Instruction/ maintenance manual of the product 1201BT Azden
Go to page of 8
User ’ s Guide 1201URX/AB • 1201URX/VM • 1201URX/Si 1201BT • 1201XT ENHANCED BROADCAST PERFORMANCE UHF WIRELESS SYSTEM 1201URX/AB - 1201URX/Si - 1201URX/VM RF Carrier Frequency Range 188 steps ~ 638.125 - 661.875 MHz MicroComputer Controlled PLL Synth.
1201URX/VM 1201URX/AB s E. Display The LCD segments on the left show the approximate remaining battery life (from 1 to 3 segments) with 3 segments meaning maximum battery power . The bottom segment will blink when the battery power falls to less than 2.
INTRODUCTION Thank you for selecting the Azden 1201 Series for your portable/ENG on-camera UHF wireless needs. We are condent that these compo - nents will perform beyond your expectations. For over 50 years, Azden Corporation has been creating technologically advanced products.
POWERING THE 1201XT (continued) in the illustration. The compartment is deigned to ease battery insertion - With the correct polarity . DO NOT FORCE THE BA TTERY INTO THE COMP ART - MENT .
RECEIVER SETUP (1201URX/AB and 1201URX/VM) The 1201URX/AB is a specially developed model that integrates the Anton Bauer “Gold Mount” to power the receiver . The 1201URX/VM is a specially developed model that integrates the IDX battery-mount to power the receiver .
7 2 Using either the UP or DOWN button [ ] the desired receiving frequency or channel number can be set. T apping the button steps the frequency or channel number one at a time while pressing and holding the button moves through the frequencies or channel numbers rapidly .
3 6 Powering the 1201BT T ransmitter The 1201BT uses 2 “AA” Alkaline batteries for power . The batteries are placed in the battery compartment by sliding the battery compartment door [ ] down and placing the batteries in the compartment as marked [ ].
4 5 1201URX/Si T op Panel display and operation (continued) Mode #2 (CH): T o change the channel/frequency within the selected group, press the MODE switch a 2nd time. “CH” will be displayed. Using either the UP or DOWN button [ ] the desired receiving channel/frequency combination can be set (the chart on page 3 shows the relationship).
An important point after buying a device Azden 1201BT (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Azden 1201BT yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Azden 1201BT - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Azden 1201BT you will learn all the available features of the product, as well as information on its operation. The information that you get Azden 1201BT will certainly help you make a decision on the purchase.
If you already are a holder of Azden 1201BT, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Azden 1201BT.
However, one of the most important roles played by the user manual is to help in solving problems with Azden 1201BT. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Azden 1201BT along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
