Instruction/ maintenance manual of the product EX1000 Sonic Blue
Go to page of 25
.
2 Copyright © 2002 SONICblue Incorporated. All rights reserved. SONICblue Incorporated does not assume any responsibility for errors or omissions in this document or make any commitment to update the information contained herein. Rio is a registered trademark of RioPort, Inc.
2 Safety Warnings CLASS 1 LASER PRODUCT This Compact Disc player is classified as a CLASS 1 LASER product. Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. CAUTION: INVISIBLE LASER RADI ATION WHEN OPEN AND INTER LOCKS DEFE ATED.
3 Press Push Important Note Symbols Contents S AFETY W ARNINGS .................................................................................................................................................................................... 2 I NSTALLING YOUR E XECUTIVE S HELF S YSTEM Front Panel View .
4 Front Panel View 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 1. Function (TUNER/CD/ TAPE) 2. REC/Pause 3. Demo 4. On/Standby 5. CD Synchro 6. Headphone Jack Connector 7. AUX 8. CD Repeat 9. Stop 10. Disc Compartment 11. Skip or Search 12. Mono/ST 13.
5 Remote Control 1. On/Standby 2. EQ/S.Bass 3. Tape Rewind 4. Tape Fast-Forward 5. Rec/Pause, CD SYNCHRO 6. RE V . Mode 7. Repeat 8. CD Stop 9. Program/Set 10. Skip or Search 11. TUNE/CD Mode 12. Mono/ST 13. Mute 14. Volume Control 15. Band 16. CD Play 17.
6 Rear Panel View 1. AUX Input 2. AM Antenna Connector Terminal 3. FM Antenna Connector Terminal 4. SUBWOOFER Speaker 5. MAIN Speaker 1 2 3 4 5.
7 The power cord must be plugged into an appropriate electrical outlet. Before plugging your system into an electrical outlet, you must check the voltage. Plug the power cord (marked AC Cord on the rear of the system) into an appropriate electrical outlet.
8 The auxiliary input can be used to take advantage of the sound quality of your Executive Shelf System when listening to other sources. Examples : A television A video disc player A Hi-Fi stereo video cassette recorder T o connect the external source, the source must have an audio out - put.
9 The AM antenna can be: Placed on a stable surface Fixed to the wall (you must first remove the base) The AM antenna connector terminals are located on the rear of the system and are marked AM ANT . To avoid noise interference, check that the speaker wires do not run close to the antenna wires.
10 Your system is equipped with a clock, which allows you to turn your system on and off automatically. You should set the clock: When you first purchase the Executive Shelf System After a power failure After unplugging the unit For each step, you have a few seconds to set the required options.
11 You can play 12 cm or 8 cm compact discs without an adapter. This unit has been designed to playback the following types of CDs: Audio CD, CD Text, CD-R and CD-RW. Continued use of irregular shaped CDs (heart-shape, octagonal, etc.) can damage the unit.
12 Skipping 10 tracks at a time Press the +10 button briefly while playing back a CD. The track 10 tracks after the current one will then be played back. Example: If you want to select track 47 during playback of track 15, press the +10 button three times, and then press the button two times.
13 You can listen to the tracks on a compact disc in random order. Press the Random button. If this button is pressed when the CD is being played back or stopped, any track recorded in the CD may be selected to playback again. When you have finished the random playback, press or press the Random button again.
14 You can check or change your selection of programmed tracks at any time. Press once if you have started listening to the selection. Press Program/Set . Result: The following is displayed: (01 = Program no., – – = Track no. on the disc) If you have already programmed 24 tracks, Check is displayed instead of PR when you press Program/Set .
15 You can store up to: 15 FM stations 15 AM stations Switch the system on by pressing On/Standy ( ) . Select the required band by pressing TUNER/Band on the front panel or Band on the remote control. Result : The appropriate indication is displayed: FM AM To search for a Press TUNE/CD Mode station.
16 Always treat your cassettes with care; refer, if necessar y , to the section entitled “ Precautions When Using Audio Cassettes ” on page 22 . Switch the system on by pressing On/Standby ( ) . Open the cassette deck by pushing on the corner of the cover marked Push Eject ( ) until you hear a click.
17 The direct recording mode enables you to start recording any track on the compact disc. You do not need to adjust the volume, as it has no effect on the recording. Switch your system on by pressing On/Standby ( ) . Insert a blank cassette in the cassette deck.
18 The timer enables you to switch the system on or off at specific times. Example: You wish to wake up to music every morning. If you no longer want the system to be switched on or off automaticall y , you must cancel the timer. Before setting the timer, check that the current time is correct.
19 The S.Bass function enhances the bass sound, when enabled. Turn the S.Bass Level knob. Turn the knob clockwise or counterclockwise to switch between OFF ÷ S.Bass 1 ÷ S.Bass 2 ÷ S.Bass 3. Select the desired level for the bass. To operate from the remote control unit, press the EQ/S.
20 You can connect a set of headphones to your Executive Shelf System so that you can listen to music without disturbing other people in the room. The earphones must have a 1/8” jack or an appropriate adapter. Connect the headphones to the Phones jack on the front panel.
21 The following diagrams illustrate the precautions to be taken when using or moving your Executive Shelf System. Safety Precautions Ambient operating conditions: Ambient temperature 41°F-95°F Humidity 10-75% Do not expose the unit to direct sun radiation or other heat sources.
22 It always takes a little time to become familiar with a new appliance. If you have any of the problems listed below, try the solutions given. They may save you the time and inconvenience of an unnecessary service call.
23 Both the design specifications and these user instructions are subject to change without notice. Technical Specifications RADIO AM Signal/noise ratio 40 dB Usable sensitivity 54 dB Total harmonic distortion 2 % FM Signal/noise ratio 62 dB Usable sensitivity 3 dB Total harmonic distortion 1.
24 Warranty Our warranty to you SONICblue Incorporated warrants that your product will be free from defects in materials and workmanship for a period of one year from the date of original retail purchase. If you discover a defect covered by this warrant y , we will repair or replace the product at our option using new or remanufactured components.
An important point after buying a device Sonic Blue EX1000 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Sonic Blue EX1000 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Sonic Blue EX1000 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Sonic Blue EX1000 you will learn all the available features of the product, as well as information on its operation. The information that you get Sonic Blue EX1000 will certainly help you make a decision on the purchase.
If you already are a holder of Sonic Blue EX1000, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Sonic Blue EX1000.
However, one of the most important roles played by the user manual is to help in solving problems with Sonic Blue EX1000. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Sonic Blue EX1000 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
