Instruction/ maintenance manual of the product GM-PAC-10E2 Soleus Air
Go to page of 18
10,000 BTU Portable Air Conditioner Operating Instructions Model No. GM-PAC-10E2.
Thank you for choosing a Soleus Air Powered by Gree Portable Air Conditioner. This owner’s man- ual will provide you with valuable information necessary for the proper care and maintenance of your new product.
LCDI POWER CORD AND PLUG This air conditioner is equipped with an LCDI (Leakage Current Detection and Interr uption) power cord and plug as required by US National Electric Code 440.65. This cord consists of a length of shielded flexible cord with no termination on the load side and a LCDI attachment plug on the line side.
INCLUDE P ARTS INCLUDED Window Exhaust Adapter A Sc re w (7 ) Exhaust Hose Window Exhaust Adapter C Adjustable Window Slider (3) H o s e c l i p ( 2 ) Rubber plug Battery (AAA.1.5V) INCLUDE Window Exhaust Adapter B SUGGESTED TOOLS FOR WINDOW P ANEL INST ALLA TION 1.
1, Control panel and display lamp 2, Remove control signal receiver window 3, Handel 4, Remote controller box 5, Air outlet 6, V ertical louvers 7, Horizontal louvers 8, Wheel 9, Air inlet 10, Grille .
6 SPEC IFIC A TIO NS x The cooling capacity is measured at an am bient tem perature of DB 95 °F, WB 83 °F. x Noise level is measured at a distance of 3.28 ft away from the front of the unit, when the unit i s in cooling mode. x Power consumption is measured when the fan runs at the highest speed setting.
• Attach the hooks to the back of air conditioner with the screws. hoook screw • Wind the power cord round the power cord hooks. 7 I N S T A L L A T I O N O F T H E P O W E R C O R D H O O K.
P ARTS & WINDOW KIT ASSEMBL Y PARTS EXHAUST HOSE & ADAPTERS ASSEMBLY & INSTALLATION INSTALLATION When the unit is operating as an air conditioner or dehumidifier, the window kit a nd exhaust hose mu st be installed. When the unit is operating in fan mode, the window ki t and exhaust hose do not need to be installed .
9 SINGLE HOSE WINDOW KIT INSTALLATION When installing the exhaust hose, try and keep it as flat as possible. The less angles and bends in the hose, the better the unit will perform. If bending or an angle is necessary , use single 90 ° angles like the pictures above.
CONTROL P ABEL & DISPLA Y When pressing key is valid, buzzer makes a sound, indicate dlamp indicates relevant state, syste mwill last for 2 seconds. OPERATING INSTRUCTIONS l. 3. MODE Button 4. Fan speed When the unit is running in Cool or F a n mode,press the Fan speed Button to select the fan speed in High, Middle, Low , Auto.
HOW TO USE THE REMO V E CONTROL For good receive, the distance between operator and the unit no more than 5 meters. Point the remote control towards the units signal receiver window a n d p r e s s t h e d e s i r e d b u tt o n . A beep will sound when the unit re- ceives the signal.
12 1) Power On and Off - Press the ON/OFF (POWER) button once to m anually turn the unit on. Press the Power button once more to turn the unit off. When you manua lly power the unit on an d off by pressing the ON/OFF button, the preset timer will be cancelled.
5) Auto-on Timer: When the air conditioner is off, it can be set to autom atically turn on in 30 m i nutes to 24 hours at the previous set mode and fan setting. To set the Auto-on Timer, press the TIME R button on the unit or remote control. Each touch of the +/- buttons on the remote will change the timer setting in 30 minute increm ents (.
1 4 When the temperature or humidity is too high, the air conditioner may not be able to evaporate all of the water as quickly as needed. All moisture that is un able to be evaporated is placed in a sm all bank up water tank in- side the unit.
MAINTENANCE Note: Make sure power is off and the power cord is not plugged into an electrical outlet prior to performing any maintenance on the unit. Clean or replace filter - If the air filter is blocked with a dust, the airflow volum e may reduce. It is recommended to clean the filter once every two weeks or as needed.
PROBLEM The Air Conditioner will not start POSSIBLE CAUSES The air conditioner is unplu gged or not connected well. The fuse is blown/circuit breaker is tripped.
PROBLEM The LCD Display is showing “E5” POSSIBLE CAUSES Low Voltage Protection SOLUTIONS x Unplug for 10 minutes and then turn on the unit. If “E5” is still dis- played, contact customer service.
W ARRANTY One Year Limited Warranty Soleus International Inc. warrants the ac companying Soleus Air Powered by Gree Portable Air Conditioner to be free of defects in material and workmanship for the applications sp ecified in its operation instruction for a period of ONE (1) year from the date of original retail purchase in the United States.
An important point after buying a device Soleus Air GM-PAC-10E2 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Soleus Air GM-PAC-10E2 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Soleus Air GM-PAC-10E2 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Soleus Air GM-PAC-10E2 you will learn all the available features of the product, as well as information on its operation. The information that you get Soleus Air GM-PAC-10E2 will certainly help you make a decision on the purchase.
If you already are a holder of Soleus Air GM-PAC-10E2, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Soleus Air GM-PAC-10E2.
However, one of the most important roles played by the user manual is to help in solving problems with Soleus Air GM-PAC-10E2. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Soleus Air GM-PAC-10E2 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
