Instruction/ maintenance manual of the product GB-WAC-06SE-C Soleus Air
Go to page of 20
Models G B -WAC-06SE-C G B -W AC-06ESE-C G B -W AC-08ESE-C Electronic Window Air Conditioner Operating Instructions.
.
Thank you for choosing a Soleus Air powered by Gree Air Cond itioner. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new air conditioner.
Recommended Ground Method For your personal safety, this air conditioner must be grou nded. This air conditioner is equipped with a 3 prong powe r supply cord with a grounded plug. To mini mize the possibility of electrical shock, the cord must be plugged into a 3 prong outlet and grounded in accordance with all local codes and ordi nances.
PA C K I N G L I S T 2/5” Screw (4) Sash Lock (1) 4/5” Screw (6) Packing List: • Window Air Condition er • Remote Control • AAA Batteries (2) • Top Mounting Rail • Top Mounting Rail Seal.
SPECIFICA TIONS • Noise level is measured at a distance of 3.28 ft away from the front of the unit in cooling mode. • Power consum ption is measured whe n the fan runs at t he highest speed setti ng. • These specications are for refere nce onl y.
INST ALLA TION & ASSEMBL Y INSTRUCTIONS Some assembly is required for your ne w air conditioner . Please read and follow these instructions carefully. 1. This air conditioner is d esigned to be installed in a standard double-hung window with a window width between 2 2 ” and 3 6 ” (5 59 mm - 9 14 m m).
T OP RAIL INST ALLA TION NOTE: Top Rail and the side Sliding Panels are offse t to provide t he proper pitch to the rear of (5/16”). This is ne cessary for proper condensatio n utilization and drainage. If you are not using the side panels, the rear pitch mu st still be main- tained.
ASSEMBL Y & INST ALLA TION (CONT .) 8 Placing the Unit Inside a Normal Window 1. Place the air conditioner on the sill with the bottom mounting rail against its back e dge. Center the air con- ditioner and close the window securely behind the top mounting rail.
ASSEMBL Y & INST ALLA TION (CONT .) 4. To secure the lower sash into pla ce, use the sash lock and a 4/5 ” screw as shown below (See FIG. 9 ) 5. For added insulation, cut the supplied insul ation foam to the width of the window. Insert the foam between the window sashes to prevent air and o bjects from getting into the room.
10 USING YOUR AIR CONDITIONER Electronic Control Panel & Remote Control 1. Power Button: Turns the air conditioner on and off 2. Digital Display: Under ON status without timer setting,the operation mode is Auto, Cool, Energy Saver or Dry mode,and the set temperature will be displayed.
11 OPERA TING YOUR AIR CONDI TIONER REMOTE CONTROL Battery Size: AAA - NOTE: Do not mix old and new batteries or different types of AAA batteries. 1. ON/OFF - Press the ON/OFF button to turn the A/C on or off. When the unit is turned off, the Timer and sleep functions will be can- celled.
12 OPERA TING YOUR AIR CONDI TIONER REMOTE CONTROL Battery Size: AAA - NOTE: Do not mix old and new batteries or different types of AAA batteries. 9. LOCK/UNLOCK - Press the “+” and “—” buttons simultaneously to lock and unlock the remote control.
13 USING YOUR AIR CONDITIONER (Cont.) • Freezing Conditions: This is a cooling only air conditioner. It is not designed for freezing outdoor conditions.
14 CARE AND CLEANING Clean your air conditioner to keep it looking new and to minimize dust build up. Air Filter Cleaning The air filter should be checked at least once every month to see if it needs cleaning. Trapped particles and dust can bui ld up in the filter and may decrease airflow as well as cause the cooling coils to accumulate frost.
PROBLEM The Air Conditioner will not start POSSIBLE CAUSES The air conditioner is unplu gged The fuse is blown/circuit breaker is tripped. Power Failure The current interrupter device is tripped.
PROBLEM Water is dripping outside POSSIBLE CAUSES Hot and Humid weather. SOLUTIONS • This is normal TROUBLESHOOTING (CONT .) Water is dripping inside the room The air conditioner is not correctly tilted outside. • For proper water drainage, make sure the air conditioner is slightly tilted downward from the front of the unit to the rear.
W arranty Soleus International Inc. warrants the accomp anying Soleus Air Air Conditioner to be free of defects in mate- rial and workmanship for the applications specified in its operation instruction for th e period of parts specified below.
.
6612990 8031.
An important point after buying a device Soleus Air GB-WAC-06SE-C (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Soleus Air GB-WAC-06SE-C yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Soleus Air GB-WAC-06SE-C - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Soleus Air GB-WAC-06SE-C you will learn all the available features of the product, as well as information on its operation. The information that you get Soleus Air GB-WAC-06SE-C will certainly help you make a decision on the purchase.
If you already are a holder of Soleus Air GB-WAC-06SE-C, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Soleus Air GB-WAC-06SE-C.
However, one of the most important roles played by the user manual is to help in solving problems with Soleus Air GB-WAC-06SE-C. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Soleus Air GB-WAC-06SE-C along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
