Instruction/ maintenance manual of the product WDF147S Smeg
Go to page of 25
WASHER-DRYER INSTRUCTION MANUAL EN.
1 EN Contents 1. Precautions for safety and use 2 2. Installation instructions 5 3. Description of controls 8 4. Using the appliance for washing 9 5. Using the appliance for drying 17 6.
E N 2 READ THE INSTRUCTIONS Attention! You are a dvise d to re ad all the instruct i ons in this m anual carefully; it w ill inform you about the right conditions for the proper, safe use of your washer-dryer It is very important to keep this instruction manual with the appliance for future reference.
E N 3 same as th e values mar ked on the nameplate. The use of adapters or junctions is not recom - mended. Never disc onnect the plug b y pulling on the p ower supply lead. • The appliance is on ly disconnected from the electricity supply if the plug has been removed from the socket or the electrical sys tem master switch has b ee n turned o ff.
E N 4 • Items s uch as f oa m rubber (latex f oam), s how er caps, waterpro of textiles, r ubber backed articles and clothes or pil l ows fitted wit h foam rubber pads should not be dried i n the tumble dryer • Fabric softeners, or similar products, should be used as specified by the f abric s oftener instruc- tions.
E N 5 The manufacturer declines all responsibil ity for injury or damage caused by failure to comply with the above regulations or de rivi ng f ro m tampering with even just one part of the appliance and the use of non -original spa re parts.
E N 6 2.2 POSITION ING AN D LEVELL ING 1. Place the applian ce in t he chosen position. 2. Level the app l iance carefully in all d irections with the aid of a spirit level, adjusting the height of the feet if necessary. Once done, fix the feet in place with t he locknuts pro- vided.
E N 7 2.3 CONNEC TING TO T HE WAT ER SUPP LY 1. Check that the water supply pressure is in the following range: 0,05-0,9MPa . W ith higher pressures, use a pressure reducer. 2. Connect the cold water supply ho se ( blue screw c ollar) to t he cold water tap with ¾ gas threaded connector, taking care to tighten firmly to prevent leaks.
E N 8 • Do not connection/disconnect the power supply plug from the socket with wet hands • Onl y disconnect the power suppl y plug from th e socket by taking hold of the plu g itself, never b y pulling on the lead.
E N 9 4. USING THE A PPLI A NCE FOR WASHING 4.1 PREPA RING THE ITEMS FOR WA SHING 1. Subdivide the items for washing by fabric type and colour fastness. 2. Wash white and col o u red items separately. New c o loured items should be washed s e parately the first ti me.
E N 10 4.4 LOAD ING THE ITEMS F OR WAS HING 1. Open the door and l o ad the laund ry , distributing i t evenly over the d r um , with items opened o ut and not bundled together; if possible, large and small items should be well mixed. 2. The washing m a c hine covered by this ma n u al can be loaded w ith up to 7 kg of laundry for each wash.
E N 11 4.6 POWDER DE TER GENT DOSE S Laundry with normal dirt 1. Choose a programme without prewash. 2. Pour the to tal amount o f detergent show n on the pack into the main wash c ompartment of the d etergent dra- wer. Very dirty laundr y 1. Choose a programme with prewash.
E N 12 4.10 SWITC HING ON TH E APP LI A NCE AND SELEC TING THE WASHING PRO GRA M ME To switch on the appliance and select the programme, proceed as follows: 1. Turn the programmes knob in either direction. This switches on the washer-dryer. 2. Select the washing programme.
E N 13 4.11 SELECT ING A ND CONFIRMING OPTI O NS 1. The Option Selection button can be used to select the following options in sequence (from the top down): Time to End : key can be p re ssed repeatedly to select the time after which the washin g programme will end.
E N 14 4.12 TIME T O END 1. To select options “time to end”,press the “Option selection” bu tton, pres sing repeatedly the “Confirm op- tion” button options you can select when the wash c yc l e ends.
E N 15 4.14 INTE RRUPTING OR CHA NGING THE WASH I NG PR OG RA MME The washing programme in progress can be interrupted at any moment: 1. press the “Start/Pause” button for about 3 seconds: the displ ay shows the w o rd PAUS (for 1 second) al- ternating with the time remaining until the end of the c yc l e (for 1 second).
E N 16 4.17 OPENING THE A P PL IANCE IN A N EMERG EN CY In the event of a power fai lure, th e door i s opened using the mechanical release device activated by means of the lever in the bottom of the appliance: • Turn th e knob to Off and d isconnect t he power supply plug from the socket.
E N 17 5. USING THE A PPLI A NCE FOR DRYING 5.1 GENERA L During drying cycles, the water tap must be turned on and the drain hose correctly positio ne d.
E N 18 5.2 WAS H-AND-DR Y PROGRAMME Automatic washin g and d ryin g can be carried out in the tough fab ri cs (cotton and colours) and synthetic/delicate fabrics programmes. If the wool wash programmes are selected, automatic drying after the w as h cannot be set.
E N 19 5.3 DISPLA Y MESS A GES IN RESPONSE T O INA P PR O PR IATE LOA D S LO Load too low – the programme stops after about 35 minutes to avoid damaging the laundry HI Load too high – th e program.
E N 20 6. CLEAN I NG A ND M A INTENANCE Important – Before carr y ing out an y cleani ng or maintenance procedure, the plug must be disconnected from the power supply socket. 6.1 CLEA NING THE OU TSIDE OF THE A PPLIANCE • Regular, thorough cleaning will keep your appliance looking good.
E N 21 3. Extract the drain hose ”A”. W a rning: if the hose is hot, the water is hot o r boiling hot. Place a shallow container on the floor and remove the plug “B” to drain off the water. Depending on the amou nt of water in the a ppliance, the contai n er may have to be emptied several times.
E N 22 7. TROUBLESH OOTING This produce complies with the relevant regulations governing the safety of e lectrica l equipment. For safety rea- sons, any technical inspections or repairs must be performed by qualified staff, to prevent all hazards for the user.
E N 23 11 A pp liance does not spin Anti-imbalance s af ety device tripped because laundry no t evenl y dis tri b- uted in drum. If l aundry is still wet a t end of cycle, rea rr an ge it in the drum by hand and repeat spin programme only.
PROGRAM GUIDE Programs Temp. (°C) Max. Spin (rpm) Max. washing load (kg) Max. drying load (kg) Prewash Wash Softner Prewash Intensive Easy Iron Extra rinse Flexi time Drying after wash if selected Wa.
An important point after buying a device Smeg WDF147S (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Smeg WDF147S yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Smeg WDF147S - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Smeg WDF147S you will learn all the available features of the product, as well as information on its operation. The information that you get Smeg WDF147S will certainly help you make a decision on the purchase.
If you already are a holder of Smeg WDF147S, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Smeg WDF147S.
However, one of the most important roles played by the user manual is to help in solving problems with Smeg WDF147S. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Smeg WDF147S along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
