Instruction/ maintenance manual of the product SCP108SG Smeg
Go to page of 28
31 T able of Content s INSTRUCTIONS FOR THE USER : these pro vide recommendations for use, a description of the controls an d the correct procedures for cleaning and maintaining th e appliance INSTRUCTIONS FOR THE INST ALLER : these are intended for the qualified engineer who is to install, commission and test the appliance 1.
32 Precautions f or Use 1. PRECA UTIONS FOR USE THIS MANU AL IS AN INTEGRAL P ART OF THE APPLIANCE. T AKE GOOD CARE OF IT AND KEEP IT T O HAND THROUGHOUT THE O VEN'S LIFE CYCLE. WE URGE Y OU TO READ THIS MANU AL AND ALL THE INFORMA TION IT CONT AINS CAREFULL Y BEFORE USING THE APPLIANCE.
33 Disposal instructions 2. DISPOSAL INSTRUCTIONS - OUR EN VIRONMENT POLICY Our products are only packaged using non-pollutant, environment-friendly , recyclable materials .
34 Safety precautions 3. SAFETY PRECA UTIONS REFER T O THE INST ALLA TION INSTRUCTIONS FOR THE SAFETY REGULA TIONS FOR ELECTRIC OR GAS APPLIANCES AND VENTILA TION FUNCTIONS.
35 Instructions f or the User 4. GET T O KNO W Y OUR O VE N 5. BEFORE INSTALLATION CONTROL P ANEL O VEN LIGHT O VEN F AN SHELF AND TRA Y R UNNERS TEMPERA TURE SENSOR Nev er l eav e packaging residues unattended in the home. Separate waste packaging materials by type and consign them to the nearest separate disposal centre.
36 Instructions f or the User 6. DESCRIPTION OF FRONT P ANEL CONTR OLS All the appliance's control and monitor ing devices are placed together on the front panel.
37 Instructions f or the User FUNCTION-SWITCH ON KNOB PT2 Simply turn this knob to th e right or left to select the function required, from those l isted below .
38 Instructions f or the User 7. USING THE O VEN 7.1 Precautions a nd General Advice All cooking operations m ust be carrie d out with the door closed When the ov en and grill are used for the first t.
39 Instructions f or the User 7.3 Fir st use At first use, or after a power f ailure, the ov e n display (DSP1), will show a flashing symbol. T o star t any cooking operation, the current time must be set. (F or fur ther information abo ut settin g or adjusting the current ti me, see point "7.
40 Instructions f or the User W ar ning: the minute minder does not stop the cooking pr ocess. It only warns the user that the preset number of minutes have passed.
41 Instructions f or the User 7.5.3 A utomatic cooking Automatic cooking is the function which allows a cooking operation to be star ted at a set time and then ended after a specific length of time set by the user . Select a cooking fu nction, set the co oking temperature required or lea ve the preset temperature (see point “7.
42 Instructions f or the User 7.6 Secondary men u This appliance also has a "secondar y menu" allowing the user to: 1 Set the time shown on the display (DSP1).
43 Instructions f or the User 7.6.1 Modifying the sec ondar y menu setti ngs The secondar y menu appears th e first time the appliance is u sed or after a power blac kout, or can be accessed b y keeping PT1 depressed f or 3 seconds with the ov en in OFF status (see point “7.
44 Instructions f or the User 7.7 Cooling fan system The appliance is equipped with a co oling system which comes into operation as soon as a cooki ng function or a cleaning cycle (Pyrolysis) star ts.
45 Instructions f or the User 8. A CCESSORIES A V AILABL E The ov en is fitted with 4 runners f or placing tra ys and shelve s at different heights . Shelf: useful to suppor t pans containing the f ood for cooking. Tr a y g r i d : for placing on top of a tray f or cooking foods which ma y dr ip .
46 Instructions f or the User 9. RECOMMENDED COOKING TABLES The ov en must be preheated before all cooking operations. Do not place the foods inside t he ov en until the degrees Centigrade symbol on the display stops flashing and the bee p has sounded to confir m that the set temperat ure has bee n reached.
47 Instructions f or the User HO T AIR COOKING RUNNER P OSITION FROM THE BO TTO M TEMPERA TURE °C. TIME IN MINUTES PA S T A LASA GNE P AST A BAKES 2 2 210 - 230 210 - 230 45 - 50 25 - 30 MEA T ROAST .
48 Instructions f or the User GRILLING RUNNER POSITION FR OM THE BO TT OM TIME IN MINUTES 1ST SIDE 2ND SIDE PORK CUTLET PORK FILLE T FILLET STEAK SLICED LI VER VEAL ESCALOPES HALF CHICKEN SA USAGE MEA.
49 Instructions f or the User 10. CLEANING AND MAINTENANCE Before carrying out any operations, disconnect the appli ance from the electricity supply . Nev er use a jet of steam for cleaning the inside of the ov en.
50 Instructions f or the User 10.4 Cleaning the oven T o keep the ov en in good condition, it must be cleaned regular ly , after allowing it to cool down. Remove all remov able par ts. • Clean the oven shelv es with hot water and non-abrasive detergents, rinse an d dr y .
51 Instructions f or the User 10.6 Pyr olysi s: automatic o ven cleaning Pyrolysis is an automatic high-tem perature clea ning procedure which causes dir t to dissolve . Before starting the auto matic cleaning cycle, ma k e sure that the ov en does not contain a ny f ood s or large spills from previous cooking operations inside.
52 Instructions f or the User 10.6.2 How the automati c cleaning cycle w orks The table below shows an e xample of operation of the automatic cl eaning cycle. About 2 minutes after the cleaning cycl e s tar ts an inter lock de vice which prev ents openin g of the door is tripped.
53 Instructions f or the User 10.6.3 Setting the clean ing cyc le Use PT2 to select one of the two pyrolysis functions ( and ) with the ov en in OFF status (see poin t 7.4, Function Selection). T o star t the cleaning (Pyrolysis) cycl e, press knob PT1 once to set its durati on ( ).
54 Instructions f or the User 11. EXTRA ORDINAR Y MAINTENANCE Occasionally , the ov en will require minor ser vic ing procedures or the replacement of par ts subject to wear and tear , such as gaskets, light bulbs, etc. The specific operations fo r each procedure o f this kind are provided below .
55 Instructions f or the User 11.2 Remo ving the door 11.2.1 With type 1 mobile lever s With the door completely open, lift the le vers A of the tw o hinges until the y touch the hinges B and tak e hold of the tw o sides of the door with both hands close to the hinges .
56 Instructions f or the User 11.4 Remo ving the inside gl ass with the door co ld The glass in the d oor should always be k ept thoroughly clean. For easier cleaning, the door glazing can be fully removed b y procee ding as describe d below . After opening the door and locking it in place as describe d in point “11.
57 Instructions f or the Installer 12. INST ALLING THE APPLIANCE 12.1 Electrical connection The nameplate with the technica l data, ser ial number and mar k is in a visible position on the ov en door frame. The nameplate must nev er be removed. The appliance must be connected to ear th in compliance with electrical system safety regulations.
58 Instructions f or the Installer 12.2 P ositioning the o ven The appliance is designed for building- in to cabinets made from any heat- resistant materi al. Comply with the dimensions shown in figures 1 , 2 and 3 . When installing und er worktops, comply with th e dimensions shown in figure 1 - 3 .
An important point after buying a device Smeg SCP108SG (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Smeg SCP108SG yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Smeg SCP108SG - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Smeg SCP108SG you will learn all the available features of the product, as well as information on its operation. The information that you get Smeg SCP108SG will certainly help you make a decision on the purchase.
If you already are a holder of Smeg SCP108SG, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Smeg SCP108SG.
However, one of the most important roles played by the user manual is to help in solving problems with Smeg SCP108SG. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Smeg SCP108SG along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
