Instruction/ maintenance manual of the product DI6012-1 Smeg
Go to page of 39
INSTRUCTION MANUAL GUIDE FOR USING THE DISHWA SH ER AND THE WASHING PROGRAMS.
.
Conten ts 1 1. Safety and operating instructions ______________ ________ _____ 2 2. Installation and hook-up ______ ________ _________ ________ ___ 5 3. Description of the controls ________ ________ _________ _______ 9 4. Operating instructions ________ ________ _________ ________ __ 18 5.
Safety instructions 2 1. Safety and operating instructions THIS MANU AL FORM S AN INTEGRAL PART OF THE APPL IANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER W ITH THE DISH W ASHER. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTION S CONTAINED IN THIS MANUAL .
Conten ts 3 WARN I NG: SOME DISH W ASHER DETERGENTS ARE STRONGLY ALKALINE. THEY CAN BE EXTREM ELY DANGEROUS IF SWALLOWED . AVOID CONTACT W ITH THE SKIN AND EYES AND KEEP CHILDR EN A W AY FROM THE DISH W ASHER W HEN THE DOOR IS OPEN. CHECK THAT TH E DETERGENT RECEPTACLE IS EMPTY AFTER COMPLETION OF THE W ASH CYCLE.
Safety instructions 4 DO NOT DRINK THE W ATER RESIDUES W HICH MAY BE PR ESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM AND BEFORE TH E DRYING C Y CLE. LEAN ING OR SITT I NG O N THE DISH WASHER D OOR W HEN OPEN M A Y CAU SE THE A PPLI A N CE TO OVERT URN, PUTING PEOP LE AT RISK.
Installation inst r uction s 5 2. Installation and hook-up Remove the polystyrene basket retainers. Position the appliance in the desired place of installa tion. The back or sides of the dishwasher m ay be placed up against walls or o ther furniture units.
Installation inst r uction s 6 2.1 Water supply conn ection Preventing the risk o f clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supply check that the water i s clear and fre e of impurities, to prevent d amage to the appliance.
Installation inst r uction s 7 2.2 Electrical conne ction and prec autions CHECK THAT THE VOLTAGE AND THE FREQUENC Y OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE A PPLIANCE POSITIONED ON THE INNER EDG E OF THE DO OR.
Installation inst r uction s 8 FOR GREAT BRITAIN ONLY: THIS A P PLIANCE MUST BE EART HED. Fuse replacement If the m ains lead of this appliance is fitted with a BS 1363A 13amp fused p l ug, to change a fuse in this type of pl ug use an A.S.T.A. approved fuse to BS 1362 t ype and proceed as follows: 1.
User instructio ns 9 3. Description of the controls 3.1 Upper panel All the dishwasher controls are grouped on the upper panel. Switch-on, programming , switch-off, etc. procedu res are only possi ble when the door is open. The panel shown is only a guideline example: the form of the lights and buttons may vary depending on the model.
User instructio ns 10 <<OPTIONS(6)>> Depending on the mod el, this zone may contain one or more of the following options, identified by the relative symbols a nd described in more detail in the relevant sections of the manual. It is no t possible to select any options when the soak program is being used.
User instructio ns 11 PR OGRA MS TA BLE Th e manu al co nta in s the pro gr ams table fo r seve ral model s. To find the tab le for yo ur dishw asher , compa re the pro gra m sym bols at the top of the tab le w ith th ose on y our co ntr ol pa nel.
User instructio ns 12 PROGR A M S T ABLE PROGRAMME NUMBER & SYMBOL LOAD CROCKER Y AND CUTLERY PROGRAM PROGRESS DURA TION CONSUMPTION MINUTES (1) WATER LITRES POWER KWh (1) 1 SOAK Pa ns a nd d ish .
User instructio ns 13 NOTES AND REFERENCES On ly run th e soak progr am w ith ha lf loa ds. Op tion s cann ot be us ed w ith th e s oak progr am . * Sta ndard progr amme unde r EN 50 242 . ** See information sheet provided ** * IEC/DIN reference programme.
User instructio ns 14 3.2 Washing program s Before starting a washing program make sure that: • The water supply tap is open . • The softener container contains regenerating salt . • The correct amount of detergent has been a dded to the dispenser .
User instructio ns 15 Flexi Tabs Specifically for washing with c ombination detergents in tablets , which also contain sa lt and rinse aid or oth er agents such as g lass protector, steel rinse a ids, etc. W hen th is option is se lected, salt and rinse aid will not be dispensed even if the relative c ompartments contain them.
User instructio ns 16 PROGRAM DELAY The start of the program can be delayed by 3, 6 or 9 hours. This allows you to set the dishwasher to work at the times o f day most convenient to you. After s etting the program , press the button to select the delay you require; the corresponding l ight will come on.
User instructio ns 17 TO SA VE ON ENERG Y! … AND PRO TECT THE E NV IRONM ENT • Alw ays us e t he di shwash er wit h a full lo ad . • Do not w ash th e d ish es in ru nni ng w ate r. • Use the wash ing progr am that is most appr opr iate for eac h type of loa d.
User instructio ns 18 4. Operating instructions Once the dishwasher has been correctly installed, prepare for use as follows: • Adjust the water softening system; • Add the regenerating salt; • Add the rinse aid and detergent.
User instructio ns 19 • Do not use table salt as it con tains i nsoluble substances which, over time, may damage the water softening system. • When necessary, refill the regenerating salt container before starting the washing program .
User instructio ns 20 WATER HARDNESS TABLE WATER HA RDNESS SETTING German degrees (° dH) French Degrees (° dF) 0 - 6 0 - 11 All lights off (no salt) 7 - 10 12 - 18 One light on 11 - 15 19 - 27 Two l.
User instructio ns 21 ADDING THE RINSE AID The rins e aid helps the dishes d ry faster and prevents the fo rmation of scale deposits and staining; it is automatically added to the w ater during the final rinse cyc l e, from the co ntainer situated on the inner side of the door.
User instructio ns 22 ADDING THE DETERGENT To open the detergent dispenser cap, l ightly press the button P . Add the detergent a nd close the cap carefully.
User instructio ns 23 The introduction of detergent into the rins e aid dispenser, even in liquid form, will damage the dishwasher. 4.3 General warnings and recommend ations Before using the dish washer for the first time, it is advisable to read the following recommendations concerning dish t ypes to be washe d and their loading.
User instructio ns 24 WARNING! • Make sure that the d ishes are securely in pl ace so that they cannot tip ov er or obst ruct the rotation of t he spray arms during the washing cycle. • Do not place very small objects in the baskets as these c ould fall and obstruct the spray arms or the wash pump.
User instructio ns 25 4.4 Using the baskets The dis hwasher has a capacity of 12 place-settings , including serving dishes. LOWER BASKET The lower b asket receives the full force of the l ower s pray arm, and should the refore be used for the “toughest ” items with a heavier degree of soiling.
User instructio ns 26 LOADING THE LOWER BASKET Carefully load flat p lates, soup plates, d essert and s erving dishes, positioning them vertically. Pots, pans and their covers m ust be loaded upside d own. W hen loading soup pl ates and d essert bo wls, be sure to leave a gap between them.
User instructio ns 27 CUTLERY BASKET The bas ket has removable top grids in to which i tems o f cutlery should be inserted to keep them properly s paced and allow water t o pass between them effectively. The top grids and cen tral lid are in the b ag of accessories .
User instructio ns 28 UPPER BASKET It is recommended to load the up per basket with small- or medium-sized items such as glasses, small plates, tea or coffee cups, shallow bowls and light objects made from heat resistant p lastic.
User instructio ns 29 Depending o n the models, the basket may be equipped with s ome o r all of the following accessories: - Supports for cups or long objects (ladles, spoons…), on the left; can be tipped to the vertical position when not in use. - Long-stemmed glass holder, on the left; to use, simply lift and fix onto the hooks provided.
User instructio ns 30 ADJUSTING THE UPPER BASKET The hei ght of the top basket can be a djusted to allow large d ishes or pans to be placed in the bottom basket. The a djustment procedure may be type A or B , depen ding on the dishwasher model purchased.
User instructio ns 31 5. Cleaning and maintenance Before carrying out a ny work, always unplug the appliance from the electrical supply or switch off the all-pole disconnection device. 5.1 General warnings and recommend ations Avoid the use of acidic or abrasive detergents.
User instructio ns 32 CLEANING THE FILTER UNIT • It is ad visable to periodically inspect the cen tre filter C and, if necessary, to clean it. To remove the filter, grip the tabs, turn t hem anticlo.
User instructio ns 33 BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE: • Check that there are no deposits of s ludge o r rust inside the wa ter pipe: if there are, allow the water to run fro m the water supply tap for a few minutes. • Plug the power cord back into the socket.
User instructio ns 34 If the dishes fail to dry or remain dull, check that: • there is rinse aid inside the special container; • the rinse aid dispenser setting is correct; • the detergent used is of good quality and has not lost i ts effectiveness (for example, through in correct storage, wi th the box left open).
User instructio ns 35 6. T roubleshooting The dishwasher is capable of signalling a number of faults through the simultaneous illumination of several indicator lights, wit h the following meanings: FAULT DESCRIPTION E1 Acquastop failure The anti-flooding system has been activated (for t he relevant models only).
User instructio ns 36 FAULT DESCRIPTION E7 Turbine flow-regula tor malfunction (for the relevant mod els only) The appliance is not able t o "measure" the amount of water loaded a ccurately. Interrupt t he program and s witch off the dishwasher.
User instructio ns 37 TECHNICAL DATA Width 597 ÷ 599 mm Depth measure d flush with the outer edge of the control panel 550 mm Height ( de p en di ng o n m od e ls ) Free standing : from 850 mm to 890.
An important point after buying a device Smeg DI6012-1 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Smeg DI6012-1 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Smeg DI6012-1 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Smeg DI6012-1 you will learn all the available features of the product, as well as information on its operation. The information that you get Smeg DI6012-1 will certainly help you make a decision on the purchase.
If you already are a holder of Smeg DI6012-1, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Smeg DI6012-1.
However, one of the most important roles played by the user manual is to help in solving problems with Smeg DI6012-1. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Smeg DI6012-1 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
