Instruction/ maintenance manual of the product 2520ULST Simer Pumps
Go to page of 16
©2008 SIM813 (1/17/08) OWNER’S MANUAL Condensate Pumps NOTICE D’UTILISA TION P ompes de récuération des eaux condensées MANUAL DEL PROPIET ARIO Bombas de condensado Installation/Oper ation/P arts F or further oper ating, installation, or maintenance assistance: Call 1-800-468-7867 English .
Safety 2 F or parts or assistance , call Simer Customer Service at 1-800-468-7867 / 1-800-546-7867 READ ALL INSTRUCTIONS BEFORE ST ARTING INST ALLA TION Gener al Safety Information Electrically powered condensate pumps normally give many years of trouble-free service when correctly installed, maintained, and used.
F or parts or assistance , call Simer Customer Ser vice at 1-800-468-7867 / 1-800-546-7867 Installation 3 Fire and e xplosion hazard. Do not use this pump to pump flammable or explosive liquids. Use pump only with liquids compatible with pump component materials.
F or parts or assistance , call Simer Customer Ser vice at 1-800-468-7867 / 1-800-546-7867 Installation 4 W ith the unit plugged in and the discharge line installed, fill the pump reservoir until the pump starts. Allow it to pump down and shut itself off automatically to verify proper operation through one complete cycle.
Installation / Maintenance 5 F or parts or assistance , call Simer Customer Ser vice at 1-800-468-7867 / 1-800-546-7867 H. Risk of Flooding. W ith installation No. 2 (“Safety Switch Sounds Alarm”), the alarm is activated when the water level in the reservoir is within about 1/2" of the top of the reservoir .
TROUBLESHOO TING Pump does not run • Check power to furnace/AC and to pump circuit. Be sure pump is plugged in. • Condensate level in reservoir may not be high enough to start pump. (W ater must be 2" below the top of the reservoir for pump to start.
Sécurite 7 P our obtenir des pièces ou de l’aide, appeler le Service à la clientèle Simer en composant le 1 800 468-7867/1 800 546-7867 LIRE TOUTES CES CONSIGNES DE SÉCURITÉ A V ANT DE PROCÉD.
Risque d’incendie et d’explosion. A vec cette pompe, ne pas pomper de liquides inflammables ou explosifs. Ne pomper que des liquides compatibles avec les matériaux qui la com- posent. Ne pas utiliser cette pompe dans une atmosphère explosive. Risque d’inondation.
P our obtenir des pièces ou de l’aide, appeler le Service à la clientèle Simer en composant le 1 800 468-7867/1 800 546-7867 Installation 9 Une fois la pompe branchée et la conduite de refoulement instal- lée, remplir le réservoir jusqu’à ce que la pompe démarre.
Installation / Entr etien 10 P our obtenir des pièces ou de l’aide, appeler le Service à la clientèle Simer en composant le 1 800 468-7867/1 800 546-7867 H.
Recher che des pannes 11 P our obtenir des pièces ou de l’aide, appeler le Service à la clientèle Simer en composant le 1 800 468-7867/1 800 546-7867 RECHERCHE DES P ANNES La pompe ne fonctionne pas • Vérifier le courant alimentant le circuit de l’ensemble appareil de chauffage central et climatiseur et de la pompe.
Seguridad 12 Si necesita repuestos o asistencia llame al Servicio al Cliente de Simer , 1-800-468-7867/1-800-546-7867 LEA TOD AS LAS INSTRUCCIONES ANTES DE COMENZAR LA INST ALA CIÓN Información gene.
Si necesita repuestos o asistencia llame al Servicio al Cliente de Simer , 1-800-468-7867/1-800-546-7867 Instalación 13 P eligro de incendio y explosión. No use esta bomba para bombear líquidos inflamables o explosivos. Use la bomba solamente con líquidos que sean compatibles con los materiales de los componentes de la bomba.
Si necesita repuestos o asistencia llame al Servicio al Cliente de Simer , 1-800-468-7867/1-800-546-7867 Instalación 14 Con la unidad enchufada y la línea de descarga instalada, llene el tanque de la bomba hasta que la bomba arranque.
Instalación / Mantenimiento 15 Si necesita repuestos o asistencia llame al Servicio al Cliente de Simer , 1-800-468-7867/1-800-546-7867 H. P eligro de inundación.
Localizacion de fallas 16 LOC ALIZA CIÓN DE F ALLAS La bomba no mar cha • Inspeccione la corriente a la caldera/CA y al cir cuito de la bomba. Asegúrese de que la bomba esté enchufada. • Es posible que el nivel del condensado en el tanque no sea lo suficientemente alto para arrancar la bomba.
An important point after buying a device Simer Pumps 2520ULST (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Simer Pumps 2520ULST yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Simer Pumps 2520ULST - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Simer Pumps 2520ULST you will learn all the available features of the product, as well as information on its operation. The information that you get Simer Pumps 2520ULST will certainly help you make a decision on the purchase.
If you already are a holder of Simer Pumps 2520ULST, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Simer Pumps 2520ULST.
However, one of the most important roles played by the user manual is to help in solving problems with Simer Pumps 2520ULST. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Simer Pumps 2520ULST along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
