Instruction/ maintenance manual of the product 130 Silver Star
Go to page of 18
Silv erStar Silver Boom 130 www .silverstarmobility .com www .pridemobility .com ™.
Silver Boom 130 SAFETY GUIDELINES Copyright © 2007 Pride Mobility Products Corp. INFMANU3530/Rev A/February 2007 The symbols below are used throughout this owner's manual and on the product to identify warnings and important information. It is very important for you to read them and understand them completely .
3 SilverBoom 130 CONTENTS I . INTRODUCTION ......................................................................................................................... 4 I I . SAFETY .......................................................................
4 SilverBoom 130 I. INTR ODUCTION W elcome to Silver S tar, a division of Pride Mobility Products Corporation (Pride). Congratulations on the purchase of your SilverBoom 130 lift . The SilverBoom 130 design combines the most advanced state-of-the-art components with modern, attractive styling.
5 SilverBoom 130 I. INTR ODUCTION PRIDE OWNERS CLUB As an owner of a Pride product, you are encouraged to enroll in the Pride Owners Club. Complete and return your enclosed product registration card or visit Pride’ s web site at ww w .pridemobility .
6 SilverBoom 130 II. SAFETY PRODUCT SAFETY SYMBOLS The symbols below are used on the mobility product to identify warnings, mandatory actions, and prohibited actions. It is very important for you to read and understand them completely . R ead and f ollow the infor mation in the owner’s man ual.
7 SilverBoom 130 LIFTING CAP ABILITIES The maximum weight the SilverBoom 130 was designed to lift is 130 lbs. Under no circumstances should the SilverBoom 130 be made to lift more than 130 lbs.
8 SilverBoom 130 III. INST ALLA TION The SilverBoom 130 can be installed in either side of your vehicle. The illustrations demonstrate installation on the right side. NOTE: Most roads have a crown to help with wa- ter runoff. However , if the crown is severe enough, it may cause difficulty getting your mobility prod- uct into the vehicle.
9 SilverBoom 130 Figure 6. Motor Housing Installation ASSEMBLING THE LIFT 1. Insert the upper post into the L-base. See figure 4. 2. Assemble the split ring collar . See figure 5 . 3. Slide the split ring collar over the upper post and tighten both screws (a good starting point is approxi- mately 12 in.
10 SilverBoom 130 L-BASE INST ALLA TION After determining the ideal spot for your lift to be permanently mounted, remove the entire lift from the vehicle except for the L-base.
11 SilverBoom 130 III. INST ALLA TION Figure 9. Securing The L-Base 2. If all is clear under the L-base, mark the position of the five (5) mounting holes and drill them using a 3/8-in. drill bit. Drill all mounting holes from inside the vehicle. See figure 9.
12 SilverBoom 130 ELECTRICAL WIRING INST ALLA TION 1. Route the lift’ s long red positive (+) power wire (starting at the lift) through the interior of the vehicle until you reach the automobile battery . See figure 12 . Conceal the wire behind or under the interior panels (there should be existing holes).
13 SilverBoom 130 III. INST ALLA TION ROUTE RED (+) POWER WIRE T O BA TTER Y BLACK (GROUND) WIRE A TT ACH TO CLEAN, BARE MET AL IN CLOSE PRO XIMITY T O LIFT BLACK - RED POWER HARNESSES AUT OMOBILE BA TTER Y MO TOR HOUSING Figure 12.
14 SilverBoom 130 IV . OPERA TION LIFTING THE MOBILITY PR ODUCT WARNING! Before operating the SilverBoom 130 for the first time, be absolutely sure you have the proper docking device for your mobility product.
15 SilverBoom 130 the hook from the docking device. " Reposition the mobility product. " Attempt the lift again. WARNING! The maximum weight the SilverBoom 130 was designed to lift is 130 lbs.
16 SilverBoom 130 V . TR OUBLESHOO TING CIRCUIT BREAKER RESET BUTT ON LIFT WILL NO T OPERA TE " Check the circuit breaker reset button. Reset if nec- essary . See figur e 18 . " Ensure all harness connections are secure. " Ensure the power wire leading to the positive battery terminal is tight and not corroded.
17 SilverBoom 130 ONE YEAR LIMITED WARRANTY For one year from the date of purchase, Pride Mobility Products Corporation will repair or replace at our option to the original purchaser , free of charge,.
*INFMANU3530*.
An important point after buying a device Silver Star 130 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Silver Star 130 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Silver Star 130 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Silver Star 130 you will learn all the available features of the product, as well as information on its operation. The information that you get Silver Star 130 will certainly help you make a decision on the purchase.
If you already are a holder of Silver Star 130, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Silver Star 130.
However, one of the most important roles played by the user manual is to help in solving problems with Silver Star 130. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Silver Star 130 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
