Instruction/ maintenance manual of the product BLX288/B58 Shure
Go to page of 17
©2014 Shure Incorporated 27A16033 (Rev. 5) BLX Wireless Microphone System Système de microphone sans fil BLX Sistema de micrófonos inalámbricos BLX Sistema de Microfone Sem Fio BLX *27A16033* ®.
CONSIGNES DE SÉCURITÉ IMPORTANTES 1. LIRE ces consignes. 2. CONSERVER ces consignes. 3. OBSERVER tous les avertissements. 4. SUIVRE toutes les consignes. 5. NE PAS utiliser cet appareil à proximité de l'eau. 6. NETTOYER UNIQUEMENT avec un chiffon sec.
For proper operation, set each transmitter to a different channel on the BLX88 receiver. Caution audio ready channel Diversity Antenna System PG4 audio ready group (A-Y) channel (0-9) BLX88 power audio ready group (A-Y) channel (0-9) Consult your BLX Channel guide to select compatible channel sets.
POWER MIC OUT INSTRUMENT OUT 12-18 V 160 mA group (A- Y) Connect receiver to power source. a) b) Press group button on receiver to perform a group scan. Connect receiver to mixer or amplifier. Hold power button to turn on. audio ready group (A-Y) channel (0-9) power BLX4 Brancher le récepteur à une source d'alimentation.
group (A-Y) channel (0-9) Install batteries and turn on transmitter. a) b) On the transmitter, set the group and channel to match the receiver. The audio LED on the receiver should illuminate. channe l group group channe l channel group group group channel Installer les piles et allumer l’émetteur.
group (A-Y) channel (0-9) Install batteries and turn on transmitter. a) b) On the transmitter, set the group and channel to match the receiver. The audio LED on the receiver should illuminate.
1 BLX Features Front Panel ① audio LED Indicates strength of incoming audio signal: green for normal and red for overload. ② ready LED Green light indicates system is ready for use and receiving transmitter signal. ③ LEDDisplay Displays group and channel setting.
2 BLX2 Back Panel ① DCPowerJack ② AdapterCordTie-Off ③ XLRmicrophoneoutputjack( MIC out ) ④ 6.35mm(1/4")instrumentleveloutputjack ( instrument out ) BLX1 ① LEDIndicator Displays power and battery status (see Transmitter LED Indicators).
3 TransmitterLEDIndicators LEDIndicator Status Green Ready RapidlyFlashingRed Controls locked SolidRed Battery power low (less than 1 hour remaining*) FlashingRedandshutsoff Batteries dead (change batteries to power on transmitter) *For alkaline batteries only.
4 Multiple System Setup Up to 12 systems can operate simultaneously (band and RF environment dependent). Important: Set up each system one-at-a-time. Once a receiver and transmitter are tuned to the same group and channel, leave the transmitter powered on.
5 13 mm (.5 in.) Tips to Improve Wireless System Performance If you encounter interference or dropouts, try the following suggestions: • Choose a different receiver channel • Reposition the receiv.
6 Batteries Expected life for AA batteries is up to 14 hours (total battery life varies depending upon battery type and manufacturer). When the LED indicator turns red, it signifies "low battery" with approximately 60 minutes of remaining battery life.
7 Troubleshooting Issue IndicatorStatus Solution No sound or faint sound Receiver ready LED on • Verify all sound system connections or adjust gain as needed (see Adjusting Gain) • Verify that .
8 BLX BLX1 BLX2 AudioInputLevel gain 0dB -20 dBV maximum -10dB -10 dBV maximum GainAdjustmentRange 10 dB RFTransmitterOutput 10 mW, typical varies by region Dimensions 224 mm X 53 mm dia. (8 7/8 X 2 1/8 in.) Weight 218 g (7.7 oz.) (without batteries) Housing Molded ABS PowerRequirements 2 LR6 AA batteries, 1.
9 Important Product Information LICENSINGINFORMATION Licensing: A ministerial license to operate this equipment may be required in certain areas. Consult your national authority for possible requirements. Changes or modifica- tions not expressly approved by Shure Incorporated could void your authority to operate the equipment.
PERU DECLARA TION OF CONFORMITY Shure Incorpor ated 5800 W . T ouhy Avenue Niles, Illinois 60714 - 4608, U.S.A. (847) 600 -2000 Shure Incorpor ated declar es that the f ollowing product Model: BLX1- H.
www .shure.com Asia, Pacific: Shure Asia Limited 22/F , 625 King’s Road North Point, Island East Hong Kong Phone: 852-2893-4290 Fax: 852-2893-4055 Email: info@shure.
An important point after buying a device Shure BLX288/B58 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Shure BLX288/B58 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Shure BLX288/B58 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Shure BLX288/B58 you will learn all the available features of the product, as well as information on its operation. The information that you get Shure BLX288/B58 will certainly help you make a decision on the purchase.
If you already are a holder of Shure BLX288/B58, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Shure BLX288/B58.
However, one of the most important roles played by the user manual is to help in solving problems with Shure BLX288/B58. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Shure BLX288/B58 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
