Instruction/ maintenance manual of the product 80045 Shindaiwa
Go to page of 8
SHINDAIWA OWNER’S/ OPERATOR’S MANUAL 75RS 75RS T M 75 R S BROADCAST SPREADER Part Number 80045 Shindaiwa Inc. P.O. Box 2810 Tualatin, Oregon 97062 Telephone 503 692-3070 FAX 503 692-6696 2001 Shindaiwa Inc. Part Number 80045 Printed in U.S.A. Shindaiwa is a registered trademark of Shindaiwa, Inc.
.
1 Introduction ........................................ 1 Assembly ............................................. 2 Operation ............................................. 4 Settings ................................................ 6 Rate Conversion ..
3. Feed control knob/wire through the T-handle until the caution label touches the round hole. See Figure 3. DO NOT COMPRESS THE SPRING AT THIS TIME . Feed the T-handle/control wire assembly through the square handle tube towards the locator dot. See Figure 4.
5. Remove the caution label, push the thumb release toward the center and push the control knob and spring down until the knob latches. See Figure 5. Caution! Once the knob is latched, do not move the thumb release until you have completed step 8! 6. Slide the wire retaining clip onto the wire.
4 1. Place the spreader on a driveway or sidewalk – not on the lawn. Make sure the spreader is off by pushing the control knob in. See Figure 8. 2. Determine the recommended application and spreader settings of the material to be applied (check the product container).
5 6. Where appropriate, apply header strips around the area to be treated, then push the spreader at a walking speed about 2 1/2 mph (18 feet in five seconds). To decrease the spread width in confined areas, reduce walking speed. Space your trips across the area as shown in Figure 10.
6 Figure 11 When determining correct spreader settings, consider: ■ Effective Pattern Width : The actual width in which the material is applied. Label instructions and settings are useful guides, but only an actual test can provide a reliable and accurate pattern width.
An important point after buying a device Shindaiwa 80045 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Shindaiwa 80045 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Shindaiwa 80045 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Shindaiwa 80045 you will learn all the available features of the product, as well as information on its operation. The information that you get Shindaiwa 80045 will certainly help you make a decision on the purchase.
If you already are a holder of Shindaiwa 80045, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Shindaiwa 80045.
However, one of the most important roles played by the user manual is to help in solving problems with Shindaiwa 80045. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Shindaiwa 80045 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
