Instruction/ maintenance manual of the product CV-P09FR Sharp
Go to page of 22
ENGLISH C V - P 09F R R * Plasmacluster is a trademark of SHARP Corporation. FRANÇAIS • Uses ozone layer friendly refridgerant R410A. • Verwendet das die Ozonschicht schonende Kühlmittel R410A. • Utilise un réfrigérant qui n’attaque pas la couche d’ozone, le R410A.
A. Information on Disposal for Users (p rivate households ) 1. In the European Un ion Attention: If you w ant to dispose of this equipment, please do not use the ordinary dust bin! Used electrical a n.
ENGLISH ENGLISH This manual e xplains the proper use of your ne w air conditioner . Please read this manual carefully bef ore using the product. This manual should be kept in a saf e place f or handy reference. CONTENTS E-1 • IMPORTANT SAFETY INSTRUCTIONS .
USAGE CAUTIONS • V entilate the room periodicall y during use , especially if using gas appliances. • Be sure to turn the unit off and disconnect the power supply cord before performing any maintenance or cleaning. • Do not splash or pour water directly onto the unit.
ENGLISH E-3 ENERGY EFFICIENCY TIPS • A void direct sunlight. Close blinds, drapes or shades to keep out direct sunlight while in cooling mode. • Keep the filter clean. K eeping the filter clean greatly aids efficient operation. A dir ty filter bloc ks the flow of air , making your air conditioner work harder and less effi- ciently .
P AR T NAMES 1 Air Outlet 2 Vertical louvers 3 Horizontal louvers 4 PLASMACLUSTER Lamp (blue) 5 Remote control signal receiver window 6 AUX. Button 7 OPERATION Lamp (red ) 8 TIMER Lamp (orange ) 9 TURBO COOL Lamp (green ) 0 Air inlet REAR VIEW NOTE: Actual unit might vary slightly from above illustration.
ENGLISH REMOTE CONTROL 1 Transmitter 2 Display 3 ON/OFF Button 4 DISPLAY Button 5 TEMPERATURE Button 6 PLASMACLUSTER Button 7 1 hr OFF Button 8 MODE Button 9 ON TIMER Button 0 FAN Button q OFF TIMER B.
1 Remove the battery cover at the back of the remote control. 2 Insert batteries into the com- partment, making sure the ± ± ± ± ± and — — — — — polarities are correctly aligned. • Lines will appear on the display when batteries are properly in- stalled.
ENGLISH E-7 CAUTION • Do not e xpose the signal receiver window to direct sunlight. This may adv ersely aff ect its operation. If necessar y , close the cur tains to block out the sunlight. • Use of a fluorescent lamp in the same room may interfere with transmission of the signal.
The exhaust hose must be installed or removed in accordance with the usage mode. Mode Exhaust hose COOL, F AN, VENTILA TION Install DEHUMIDIFICA TION Remove Installation of the exhaust hose 1 Attach the insect guard net to the ex- haust adapter .
ENGLISH 1 3 COOL MODE Drainage nozzle Stopcock E-9 Install the exhaust hose (See Page 8), turn the drainage nozzle to the CLOSE position, and check the drainage nozzle is covered with the stopcock. 1 4 2 3 “CLOSE position” 1 Press the MODE button to select COOL mode.
DEHUMIDIFICA TION MODE E-10 7 6 In this mode, the air conditioner dehumidifies the room. Drainage nozzle Stopcock Hose clamp Hose 1 Remove the exhaust hose (See Page 8) 2 Turn the drainage nozzle to the OPEN position. 3 Pull the stopcock out from the drainage nozzle.
ENGLISH F AN MODE 1 5 2 3 VENTILA TION MODE 1 4 5 2 3 E-11 Install the exhaust hose (See Page 8), turn the drainage nozzle to the CLOSE position, and check the drainage nozzle is covered with the stopcock.
T O CHANGE AIR FLOW DIRECTION UP/DOWN AIR FLOW DIRECTION NOTE • During VENTILATION mode, UP/DOWN air flow direction cannot be changed. Hold the vertical louver as shown in the dia- gram and adjust the air flow direction. 1 Press the SWING button on the remote control.
ENGLISH E-13 1 Press the TURBO COOL button during cooling mode. • The remote control will display “ ” . • The temperature displa y will go off. • The green TURBO COOL lamp ( ) on the unit will light. T O CANCEL Press the TURBO COOL button again.
0.5h 1.0h 1.5h 10h 1 1h 12h E-14 NOTES ON TIMER SETTING AND OPERATION • The latest time setting will be memorized and will appear on the remote control display the next time you set the OFF TIMER or ON TIMER. • The OFF TIMER and ON TIMER can not be set together.
ENGLISH E-15 1 ON TIMER Display shown when you set the unit to turn on 6.5 hours later. The unit will turn on automatically according to your setting. Timer duration can be set from a minimum of half an hour (30 minutes) to a maximum of 12 hours. Up to 9.
AUXILIAR Y MODE AUXILIAR Y MODE 1 E-16 Use this mode when the remote control is not available. 1 Press the AUX. button on the unit. • The red OPERATION lamp ( ) on the unit will light and the unit will start operating in COOL mode. • The fan speed is set to AUTO.
ENGLISH DRAINAGE Prepare for drainage and drain out water within the unit in the following cases. If the unit stops operating and the TIMER ( ), OPERATION ( ) and TURBO COOL ( ) lamps are blinking. (This indicates that the water tank inside the unit is full.
CLEANING THE UNIT AND THE REMO TE CONTROL Wipe them with a soft, dry cloth or with a cloth moistened with a mild soap. Carefully remove any residue b y wiping with a damp cloth and dr y completely . A void splashing water onto the unit. W ater can dangerously damage the electrical insulation.
ENGLISH BEFORE CALLING FOR SER VICE If the unit appears to be malfunctioning, check the following points before calling for a service. AIR CONDITIONER DOES NO T OPERA TE A T ALL • Is the unit plugge.
ENGLISH SHARP CORPORA TION Osaka, Japan TINSEA419JBRZ 05AO TH 1 Printed in Thailand R.
An important point after buying a device Sharp CV-P09FR (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Sharp CV-P09FR yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Sharp CV-P09FR - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Sharp CV-P09FR you will learn all the available features of the product, as well as information on its operation. The information that you get Sharp CV-P09FR will certainly help you make a decision on the purchase.
If you already are a holder of Sharp CV-P09FR, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Sharp CV-P09FR.
However, one of the most important roles played by the user manual is to help in solving problems with Sharp CV-P09FR. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Sharp CV-P09FR along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
