Instruction/ maintenance manual of the product CAL. 7L22 Seiko
Go to page of 15
Cal. 7L22 INSTRUCTIONS (P. 3) BEDIENUNGSANLEITUNG (S. 16) INSTRUCTIONS (P. 29) ISTRUZIONI (P. 42) INSTRUCCIONES (P. 57) INSTRUÇÕES (P. 70) 用法説明 (83 頁 ).
English 2 You are now the proud owner of a SEIKO KINETIC ® Cal. 7L22. For best results, please read the instructions in this booklet carefully before using your SEIKO KINETIC ® . Please keep this manual handy for ready reference. Sie sind jetzt stolzer Besitzer einer SEIKO KINETIC ® Kal.
ENGLISH 3 CONTENTS Page FEATURES .................................................................................................................. 4 HOW TO CHARGE AND START THE WATCH ........................................................... 4 POWER RESERVE IN YOUR SEIKO KINETIC WATCH .
English 4 Swing the watch from side to side approximately 500 times. * Swing rhythmically at a rate of twice a second. * 500 swings will start the watch and the second hand will move at one-second intervals. Swing the watch approximately 200 times further to reserve one day of power.
English 5 POWER RESERVE IN YOUR SEIKO KINETIC WATCH ● The electric energy generated while the watch is worn on your wrist is stored in the KINETIC ELECTRICITY STORAGE UNIT (KINETIC E.S.U.). It is a power source completely different from conventional batteries for watches, and therefore, does not require any periodical replacement.
English 6 CAUTION Never install a silver oxide battery for conventional watches in place of the KINETIC E.S.U. The battery may burst, become very hot or catch fire.
English 7 ➠ ➠ TIME/CALENDAR SETTING Minute hand Date Second hand Hour hand a. Screwed-in position c. First click b. Unscrewed position d. Second click 1. Pull out the crown to the first click and turn it counterclockwise to set the previous day’s date.
English 8 STOPWATCH ● The stopwatch can measure up to 45 minutes in 1/5 second increments. ● The measured time is indicated by two STOPWATCH hands that move independently of the hands for time indication. ● After 48 minutes, the stopwatch will stop automatically.
English 9 Ex. ) 9 minutes 58 seconds Be careful not to misread 9 minutes 58 seconds as 10 minutes 58 seconds even if the STOPWATCH minute hand is close to the 10 minutes position. ◆ STOPWATCH second hand reading: The STOPWATCH second hand almost points to “58”.
English 10 STOPWATCH OPERATION ● Before using the stopwatch, be sure to reset the STOPWATCH hands to “0” position. 1) Check that the watch is operating normally. * If the watch has stopped completely or if the second hand is moving at two-second intervals, charge the watch sufficiently.
English 11 6 0 T A C H Y M E T E R 5 0 0 4 0 0 3 0 0 2 5 0 2 0 0 1 8 0 1 6 0 1 4 0 1 2 0 1 0 0 9 0 8 0 7 5 7 0 6 5 TACHYMETER (for models with tachymeter scale) To measure the hourly average speed of a vehicle * Tachymeter scale can be used only when the time required is less than 60 seconds.
English 12 6 0 T A C H Y M E T E R 5 0 0 4 0 0 3 0 0 2 5 0 2 0 0 1 8 0 1 6 0 1 4 0 1 2 0 1 0 0 9 0 8 0 7 5 7 0 6 5 To measure the hourly rate of operation Use the stopwatch to measure the time required to complete 1 job. Tachymeter scale indicated by STOPWATCH second hand gives the average number of jobs accomplished per hour.
English 13 NOTES FOR USING THE WATCH HOW TO CHARGE AND START THE WATCH ● To charge the KINETIC E.S.U. efficiently, swing the watch from side to side rhythmically at a rate of twice a second, making an arc of about 20 cm. ● No additional benefit is obtained by swinging the watch more quickly or with greater vigor.
English 14 TIME/CALENDAR SETTING ● Do not set the date between 9:00 p.m. and 1:00 a.m. Otherwise, it may not change properly. If it is necessary to set the date during that time period, pull out the crown to the second click and turn it counterclockwise to advance the time ahead of 1:00 a.
English 15 SPECIFICATIONS 1 Frequency of crystal oscillator .......................... 32,768 Hz (Hz = Hertz … Cycles per second) 2 Loss/gain (monthly rate) .................................... Less than 15 seconds (worn on the wrist at normal temperature range 5 ° C ~ 35 ° C) (41 ° F ~ 95 ° F) 3O perational temperature range .
An important point after buying a device Seiko CAL. 7L22 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Seiko CAL. 7L22 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Seiko CAL. 7L22 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Seiko CAL. 7L22 you will learn all the available features of the product, as well as information on its operation. The information that you get Seiko CAL. 7L22 will certainly help you make a decision on the purchase.
If you already are a holder of Seiko CAL. 7L22, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Seiko CAL. 7L22.
However, one of the most important roles played by the user manual is to help in solving problems with Seiko CAL. 7L22. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Seiko CAL. 7L22 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
