Instruction/ maintenance manual of the product 8101 P590-60 Sears
Go to page of 8
INSTALLER" LEAVE THESE INS TRUG TIONS WITH THE APPLIANCE INSTALLATION MANUAL Gas 24-inch Built-ln Ovens PLEASE KEEP THIS MANUAL FOR FUTURE REFERENCE THE MANUAL IS INTENDED TO ASSIST IN THE INITIAL INSTALLATION AND ADJUSTMENTS OF THE RANGE Only qualified personnel should install or service this range.
Installation Drawings PROVIDE SLOT 120 VOLT GROUNDED ELECTRICAL OUTLET IN THIS AREA FRONT OF CABI 11 MIN OVEN SUPPLIED WITH 112" NPT FEMALE INLET ON REGULATOR.
Installation Check the oven model number plate to see if the oven is approved for installation in mobile homes and/or recreational vehicles. If approved the following items are applicable. NOTE: Oven model number plate is located under broiler bottom.
Connecting The Oven Gas Supply Installation of this oven must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1-1atest edition. or water). Dirt, etc. in the supply lines can work its way into the range manifold and in turn cause failure of the gas valves or controls and clog burners.
Unit Adjustments Wall Oven Adjustment ELECTRIC IGNITION - BAKE BURNER WITH ELECTRIC GLOW BAR a. The bake burner is equipped with an electric control system as well as an electric oven burner ignitor (figure 2). This control system requires NO adjustment.
AIR SHUTTER - OVEN BURNER a. The approximate length of the flame of oven burner is a 1/2 inch distinct blue flame, figure 4. b. Oven burner flame can be checked as follows, without burner baffle in place: 1. Yellow flame on burner - open burner air shutter to the widest opening that will not cause the flame to lift or blow off the burner when cold.
Gas Conversion General All ovens are equipped with double coaxial (universal) orifices and with a convertible appliance pressure regulator. The unit model number plate states which gas it was adjusted for at the factory.
Orifice Conversion 1. FROM NATURAL GAS TO LP/PROPANE GAS: a. b. C. Change the appliance pressure regulator from natural to LP setting. (See figure 6, 7 or 8). Screw the burner orifice hoods down tight against the pins. (See figure 9B). Use care to not over tighten.
An important point after buying a device Sears 8101 P590-60 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Sears 8101 P590-60 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Sears 8101 P590-60 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Sears 8101 P590-60 you will learn all the available features of the product, as well as information on its operation. The information that you get Sears 8101 P590-60 will certainly help you make a decision on the purchase.
If you already are a holder of Sears 8101 P590-60, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Sears 8101 P590-60.
However, one of the most important roles played by the user manual is to help in solving problems with Sears 8101 P590-60. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Sears 8101 P590-60 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
