Instruction/ maintenance manual of the product ST3250312CS Seagate
Go to page of 48
Product Manual Video 3.5 HDD 100529372 Rev. J May 2013 ST31000424CS ST3500414CS ST3320413CS ST3250412CS ST31000322CS ST3500312CS ST3320311CS ST3250312CS ST3160316CS.
Revision history Copyright © 2013 Seagate Technology LLC. All rights reserved. Printed in U.S.A. Publication number: 100529372, Rev. J May 2013 Seagate, Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries.
Pipeline HD.2 Series SATA Product Manual, Rev. J i.
ii Pipeline HD.2 Series SATA Product Manual, Rev. J.
Pipeline HD.2 Series SATA Product Manual, Rev. J iii Contents 1.0 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1.1 About the Serial ATA interface .
iv Pipeline HD.2 Series SATA Product Manual, Rev. J.
Video 3.5 HDD Product Manual, Rev. J 1 1.0 Introduction This manual describes the functional, mechanical and interface specifications for the following Seagate Seagate Video 3.5 (formerly Pipeline ® HD.2) model drive: These drives provide the following key features: • High instantaneous (burst) data-transfer rates 3Gb/s default.
2 Video 3.5 HDD Product Manual, Rev. J 1.1 About the Serial ATA interface The Serial ATA interface provides several advantages over the traditional (parallel) ATA interface. The primary advantages include: • Easy installation and configuration with true plug-and-play connectivity.
Video 3.5 HDD Product Manual, Rev. J 3 2.0 Drive specifications Unless otherwise noted, all specifications are measured under ambient conditions, at 25°C, and nominal power. For convenience, the phrases the drive and this drive are used throughout this manual to indicate the following drive model: 2.
4 Video 3.5 HDD Product Manual, Rev. J Table 1: Drive specifications summary for 1000GB models Drive specification ST31000424CS ST31000322CS Formatted Capacity (512 bytes/sector)* 1000GB Guaranteed se.
Video 3.5 HDD Product Manual, Rev. J 5 * One Gbyte equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. * *During periods of drive idle, some offline activity may occur according to the S.
6 Video 3.5 HDD Product Manual, Rev. J Table 2: Drive specifications summary for 500 and 320GB models Drive specification ST3500414CS ST3500312CS ST3320413CS ST3320311CS Formatted capacity (512 bytes/.
Video 3.5 HDD Product Manual, Rev. J 7 * One Gbyte equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. * *During periods of drive idle, some offline activity may occur according to the S.
8 Video 3.5 HDD Product Manual, Rev. J Table 3: Drive specifications summary for 250 and 160GB models Drive specification ST3250412CS ST3250312CS ST3160316CS Formatted capacity (512 bytes/sector)* 250.
Video 3.5 HDD Product Manual, Rev. J 9 * One Gbyte equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. * *During periods of drive idle, some offline activity may occur according to the S.
10 Video 3.5 HDD Product Manual, Rev. J 2.2 Formatted capacity Model Formatted capacity* Guaranteed sectors Bytes per sector ST31000424CS ST31000322CS 1000GB 1,953,525,168 512 ST3500414CS ST3500312CS .
Video 3.5 HDD Product Manual, Rev. J 11 2.5 Physical characteristics 1000GB model 500, 320, 250 and 160GB models Maximum height 26.1mm / 1.028 in 20.20mm / 0.794 in Maximum width 101.85mm / 4.010 in Maximum length 146.99mm / 5.787 in Typical weight 615g / 1.
12 Video 3.5 HDD Product Manual, Rev. J 2.8 Power specifications The drive receives DC power (5V or 12V) through a native SATA power connector. Refer to Figure 2 on page 22. 2.8.1 Power consumption Power requirements for the drives are listed in the table on page 9.
Video 3.5 HDD Product Manual, Rev. J 13 2.8.1.1 Typical current profiles Figure 1. Typical 12V startup and operation current profile 2.8.2 Conducted noise Input noise ripple is measured at the host system power supply across an equivalent 80-ohm resistive load on the 12V line or an equivalent 15-ohm resistive load on the 5V line.
14 Video 3.5 HDD Product Manual, Rev. J 2.8.4 Power management modes The drive provides programmable power management to provide greater energy efficiency.
Video 3.5 HDD Product Manual, Rev. J 15 2.9 Environmental specifications This section provides the temperature, humidity, shock, and vibration specifications. Ambient temperature is defined as the temperature of the environment immediately surrounding the drive.
16 Video 3.5 HDD Product Manual, Rev. J 2.9.5 Shock All shock specifications assume that the drive is mounted securely with the input shock applied at the drive mounting screws.
Video 3.5 HDD Product Manual, Rev. J 17 2.10 Acoustics emissions Drive emission of sound is measured consistent with the ECMA-74 and its referenced standards.
18 Video 3.5 HDD Product Manual, Rev. J 2.12 Reliability 2.12.1 Annualized Failure Rate (AFR) The product will achieve an Annualized Failure Rate (AFR) of 0.55% when operated in an environment of ambient air temperatures of 25 ° C. Operation at temperatures outside the specifications in Section 2.
Video 3.5 HDD Product Manual, Rev. J 19 Korean RRL If these drives have the Korean Communications Commission (KCC) logo, they comply with paragraph 1 of Article 11 of the Electromagnetic Compatibility.
20 Video 3.5 HDD Product Manual, Rev. J 2.14 Environmental protection Seagate designs its products to meet environmental protection requirements worldwide, including regulations restricting certain chemical substances.
Video 3.5 HDD Product Manual, Rev. J 21 3.0 Configuring and mounting the drive This section contains the specifications and instructions for configuring and mounting the drive.
22 Video 3.5 HDD Product Manual, Rev. J 3.2 Configuring the drive Each drive on the Serial ATA interface connects point-to-point with the Serial ATA host adapter. There is no master/slave relationship because each drive is considered a master in a point-to-point relationship.
Video 3.5 HDD Product Manual, Rev. J 23 3.4 Drive mounting You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes. Refer to Figure 3 for drive mounting dimensions. Follow these important mounting pre- cautions when mounting the drive: • Allow a minimum clearance of 0.
Recommended case temperature measurement location 24 Video 3.5 HDD Product Manual, Rev. J Figure 4. Mounting dimensions (for 500, 320, 250 and 160GB models).
Video 3.5 HDD Product Manual, Rev. J 25 4.0 Serial ATA (SATA) interface These drives use the industry-standard Serial ATA interface that supports FIS data transfers. It supports ATA programmed input/output (PIO) modes 0–4; multiword DMA modes 0–2, and Ultra DMA modes 0–6.
26 Video 3.5 HDD Product Manual, Rev. J 4.2 Serial ATA device plug connector pin definitions Table 7 summarizes the signals on the Serial ATA interface and power connectors. Notes: 1. All pins are in a single row, with a 1.27mm (0.050 in) pitch. 2. The comments on the mating sequence apply to the case of backplane blindmate connector only.
Video 3.5 HDD Product Manual, Rev. J 27 4.3 Supported ATA commands The following table lists Serial ATA standard commands that the drive supports. For a detailed description of the ATA commands, refer to the Serial ATA International Organization: Serial ATA Revision 2.
28 Video 3.5 HDD Product Manual, Rev. J Security Erase Prepare F3 H Security Erase Unit F4 H Security Freeze F5 H Security Set Password F1 H Security Unlock F2 H Seek 70 H Set Features EF H Set Max Address F9 H Note: Individual Set Max Address commands are identified by the value placed in the Set Max Features regis- ter as defined to the right.
Video 3.5 HDD Product Manual, Rev. J 29 4.3.1 Identify Device command The Identify Device command (command code EC H ) transfers information about the drive to the host following power up. The data is organized as a single 512-byte block of data, whose contents are shown in Table 8 on page 27.
30 Video 3.5 HDD Product Manual, Rev. J 60–61 Total number of user-addressable LBA sectors available (Refer to Section 2.2 for related information.) *Note: The maximum value allowed in this field is: 0FFFFFFFh (268,435,455 sectors, 137GB).
Video 3.5 HDD Product Manual, Rev. J 31 Note. Advanced Power Management (APM) and Automatic Acoustic Management (AAM) features are not supported Note. Refer to the bit descriptions below for words 63, 84, and 88 of the Identify Drive data. 100–103 Total number of user-addressable LBA sectors available (Refer to Section 2.
32 Video 3.5 HDD Product Manual, Rev. J 13 IDLE IMMEDIATE command with IUNLOAD faeture is supported. 14 Shall be set to 1. 15 Shall be cleared to 0. Bit Word 88 0 Ultra DMA mode 0 is supported. 1 Ultra DMA mode 1 is supported. 2 Ultra DMA mode 2 is supported.
Video 3.5 HDD Product Manual, Rev. J 33 4.3.2 Set Features command This command controls the implementation of various features that the drive supports. When the drive receives this command, it sets BSY, checks the contents of the Features register, clears BSY and generates an inter- rupt.
34 Video 3.5 HDD Product Manual, Rev. J 4.3.3 S.M.A.R.T. commands S.M.A.R.T. provides near-term failure prediction for disk drives. When S.M.A.R.T. is enabled, the drive moni- tors predetermined drive attributes that are susceptible to degradation over time.
Video 3.5 HDD Product Manual, Rev. J 35 5.0 Seagate Technology support services For information regarding online support and services, visit http://www .
36 Video 3.5 HDD Product Manual, Rev. J Customer Service Operations Warranty Service Seagate offers worldwide customer support for Seagate products. Seagate distributors, OEMs and other direct customers should contact their Seagate Customer Service Operations (CSO) representative for warranty- related issues.
Video 3.5 HDD Product Manual, Rev. J 37 Index A ACA 19 acceleration 16 acoustics 17 Active mode 14 AFR 18 agency certification 18 altitude 15 ambient temperature 11 , 12 Annualized Failure Rate (AFR) .
38 Video 3.5 HDD Product Manual, Rev. J Idle Immediate 27 Idle mode 12 , 14 Information Technology Equipment (ITE) 18 Initialize Device Parameters 27 input noise ripple 13 input voltage 12 interface 1.
Video 3.5 HDD Product Manual, Rev. J 39 Security Disable Password 27 Security Erase Prepare 28 Security Erase Unit 28 Security Freeze 28 Security Set Password 28 Security Unlock 28 Seek 28 seek time 1.
40 Video 3.5 HDD Product Manual, Rev. J.
.
Seagate Technology LLC 10200 South De Anza Boulevard, Cupertino, California 95014, USA Publication Number: 100529372, Rev. J.
An important point after buying a device Seagate ST3250312CS (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Seagate ST3250312CS yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Seagate ST3250312CS - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Seagate ST3250312CS you will learn all the available features of the product, as well as information on its operation. The information that you get Seagate ST3250312CS will certainly help you make a decision on the purchase.
If you already are a holder of Seagate ST3250312CS, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Seagate ST3250312CS.
However, one of the most important roles played by the user manual is to help in solving problems with Seagate ST3250312CS. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Seagate ST3250312CS along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
