Instruction/ maintenance manual of the product MKC-10 Schumacher
Go to page of 16
1 00-99-000165/0103 • IMPORT ANT SAFETY INSTRUCTIONS • • SA VE THESE INSTRUCTIONS • sary . Use of an improper extension cord could result in fire or electric shock. If an extension cord must be used, make sure that: G Pins on plug of extension cord are the same num- ber , size, and shape as those of plug on charger.
2 PERSONAL PRECAUTIONS AND SAFETY PREP ARING TO CHARGE 1. W ARNING: Wear complete eye protection and clothing protection, when working with lead-acid batteries. 2. Make sure someone is within range of your voice or close enough to come to your aid when you work with or near a lead-acid battery .
3 BA TTER Y CHARGER CONTROLS FIGURE 3 - CHARGER CONTROLS OFF - ON SWITCH Make sure On/Off switch is in the Off position when connecting and disconnecting charger to battery . AUT OMA TIC CHARGING When the battery reaches the full charge state, charge current is turned off and the charger switches to the maintainer mode of op- eration.
4 CIRCUIT BREAKER This battery charger is equipped with a self-resetting circuit breaker . This device protects the charger from temporary over- loads. In the event of an overload, the circuit breaker will trip open and after a short cooling off period will reset automatically .
5 B A TTERY POSITIVE NEGA TIVE 24", 6 GAUGE CABLE POWER CORD +- BA TTERY CHARGER 1 . Check polarity of battery posts. Battery case will be marked by each post: POSITIVE (POS, P , +) and NEGA TIVE (NEG , N, -). NOTE: The positive battery post usually has a larger diam- eter than the negative post.
6 TROUBLESHOOTING The battery charger is designed to work automatically . However , If a problem does occur, check the following: PROBLEM POSSIBLE SOLUTION Charger will not turn OFF . ON/OFF switch defective. Have battery charger checked. Green charge indicator never Battery has problem and will not take Have battery checked.
7 MAINTENANCE/CLEANING INSTRUCTIONS V ery little maintenance is required for the battery charger. Follow common sense in wiping the charger clean and store in a cle an, dry area. 1. After use, wipe all battery corrosion and other dirt or oil from clip, cord, and the charger case.
8 • IMPORT ANT SAFETY INSTRUCTIONS • • SAVE THESE INSTRUCTIONS • Minn Kota Battery Charger Manufactured by Schumacher Electric Corporation 1-800-621-5485.
1 CONSIGNES DE SÉCURITÉ GÉNÉRALES SUR LES CHARGEURS • CONSIGNES DE SÉCURITÉ IMPORT ANTES • • CONSERVEZ CE GUIDE • 25 50 100 150 18 18 16 14 MODÈLE MKC-10 CHARGEUR DE BATTERIE DE 12 VOLT.
2 CONSIGNES DE SÉCURITÉ A L ’INTENTION DE L ’USAGER PRÉP ARA TIFS DE CHARGE 220-350 24-40 3-5 350-600 40-70 5-9 600-935 70-104 9-13 MCA A / H TEMPS DE RECHARGE (HEURES) 1. ATTENTION : Portez des lunettes de sûreté et des vêtements protecteurs quand vous manipulez des batteries au plomb-acide.
3 INTERRUPTEUR MARCHE-ARRÊT Assurez-vous que l’interrupteur marche-arrêt est en position “ARRÊT” lorsque vous effectuez le branchement et le débranchement du chargeur à la batterie. CHARGE AUTOMATIQUE Lorsque la batterie est complètement chargée, le courant de charge est coupé et le chargeur passe en mode d’entretien.
4 DISJONCTEUR TYPES DE BA TTERIE Ce chargeur de batterie est équipé d’un disjoncteur automatique. Ce dispositif protège le chargeur de surcharges temporaires. Si une surcharge survient, le disjoncteur coupe le courant et, après une courte période de refroidissement, revient à sa position initiale.
5 POSITIVE NÉGA TIVE BA TTERIE CHARGEUR DE BA TTERIE CÂBLE DE CALIBRE 6, 24 PO (60 CM) CORDON D’ÂLIMENT A TION Â UNE PRISE DE COURANT MISE Â LA TERRE 1. Vérifiez la polarité des bornes de batterie. Il y aura une indication sur le boîtier de la batterie près de chaque borne: POSITIVE, (POS, P, +) et NÉGATIVE (NEG, N, -).
6 DÉP ANNAGE PROBLÉME CAUSE PROBABLE SOLUTION Le chargeur de batterie est conçu pour fonctionner automatiquement. Toutefois, si un problème survenait, vérifiez les points suivants: Le chargeur ne s’arrête pas. L’interrupteur MARCHE/ARRÊT Faites vérifier le chargeur de batterie.
7 1. Après usage, essuyez toute corrosion provenant de la batterie et autre saleté, huile, etc. sur les pinces, le cordon et le boîtier du chargeur. Employez un chiffon sec. 2. Enroulez les cordons du chargeur pour éviter qu’ils ne s’endommagent.
8 • CONSIGNES DE SÉCURITÉ IMPORTANTES • • CONSERVEZ CE GUIDE • Minn Kota Battery Charger Fabriqué par Schumacher Electric Corporation 1-800-621-5485.
An important point after buying a device Schumacher MKC-10 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Schumacher MKC-10 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Schumacher MKC-10 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Schumacher MKC-10 you will learn all the available features of the product, as well as information on its operation. The information that you get Schumacher MKC-10 will certainly help you make a decision on the purchase.
If you already are a holder of Schumacher MKC-10, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Schumacher MKC-10.
However, one of the most important roles played by the user manual is to help in solving problems with Schumacher MKC-10. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Schumacher MKC-10 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
