Instruction/ maintenance manual of the product IG-520 BH Saunatec
Go to page of 13
IG-520-BH-2 5/25/0 7 INFRARED WOODEN SAUNA RO O M INSTRUCTION MANU AL Read all instructions caref ully before using the wooden infrared sauna room IG-520 BH PRECAUTIONS FOR USE............................................... ........1 P AR TS NAMES. ..
IG-520-BH-2 5/25/0 7 A TTEN TION ※ Read all instructions before using this appliance. ※ Serious injury may result if warnings and instructions below are not observed.
IG-520-BH-2 5/25/0 7 PA R T S N A M E S.
IG-520-BH-2 5/25/0 7 READ BEFORE IN ST ALLA TION: ※ Each panel is heavy . Be careful to avoid injury when installing, especially the top panel. ※ T wo adults are required for the installation of sauna room.
IG-520-BH-2 5/25/0 7 INST ALLA TION OF SAUNA ROOM BODY 1. Place the floor panel in the desir ed location on a level surfac e (Note: Th e floor panel must be level before installing wall and ceiling panels. If the surface is not level you may need to shim the bottom panel to get level.
IG-520-BH-2 5/25/0 7 5. Place the Bench Support p anel first and then place th e Bench surface panel into the sauna room. ※ On larger sauna room s with more than one bench, rotate the wooden bench supports away from the side wall s. ※ Slide the Bench Support Panel down the wooden supports with the heater facing out.
IG-520-BH-2 5/25/0 7 6. Place the front panel in the slot of floor panel. 7. Place the top panel on the four s ide panels. Make sure the connection wires from the three side panels protrude through the corresponding holes of the top panel. ※ Make sure the top pan el’ s arched side is facing to the front.
IG-520-BH-2 5/25/0 7 WARNING: ELECTRIC SHOCK HAZARD Do not plug cord into electrical outlet before connecting power cord wires to terminal block. 9. Make sure to connect wires in correct locatio n by .
IG-520-BH-2 5/25/0 7 CONTROL P ANEL INSTRUCTION 1. Press “ POWER ” to switch on or off. 2. “ TIME ” refers to control of operating time and indicates the amount of time remaining. ※ Once power is on, the default amount of operating time is at 45 minutes.
IG-520-BH-2 5/25/0 7 OPERA TING INSTRUCTIONS FOR COLOR LIGHT THERAPY SYSTEM 1. T o ac tiv ate the color light therapy system press “ADJUST” on the sauna control panel. Upon turning the system on, the colo r light system will go into an au tomatically cycling mode, changing color every 8 seconds: 2.
IG-520-BH-2 5/25/0 7 W ARNINGS AND SUGGESTIONS FOR USE Please read carefully the following warnings, to reduce the risk of burns, fire, electr ic shock, or injury to persons: ※ Do not put the sauna roo m in a moist environment. ※ Place room on level s urface.
IG-520-BH -2 5/25/07.
IG-520-BH- 2 5/25/07.
An important point after buying a device Saunatec IG-520 BH (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Saunatec IG-520 BH yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Saunatec IG-520 BH - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Saunatec IG-520 BH you will learn all the available features of the product, as well as information on its operation. The information that you get Saunatec IG-520 BH will certainly help you make a decision on the purchase.
If you already are a holder of Saunatec IG-520 BH, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Saunatec IG-520 BH.
However, one of the most important roles played by the user manual is to help in solving problems with Saunatec IG-520 BH. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Saunatec IG-520 BH along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
