Instruction/ maintenance manual of the product ATS-404 Sangean
Go to page of 10
.
.
Control Locations 1. T elescopic Antenna 2. Display (L.C.D) 3. Display illuminated button (LIGHT) 4. Power on/off button 5. Sleep (auto shut off) button 6. Display button 7. Standby button (ALARM) 8. Alarm by radio or buzzer selection 9. Manual/auto scan tuning buttons 10.
Choosing a power su pply This radio c an be operat ed using 4 Alkaline UM-3 ( LR6) (AA size) ba tteries Household AC adaptor (no t supplied ) Installing batte ries 1.Position the radio f ace down . 2.Press th e catch mark ed "OPEN " and side in the di rection sh own 3.
In addition to real time, a dual time can be programmed into the radio. 1.Press MEMO SCAN (DUAL TIME) button, display will flash “ ” 2.Press ENTER button within 7 seconds, the display “ ” will stop flashing.
Manual tuning 1.Press the POWER on/of f button to turn on the radio. 2.Select a waveband by pressing BAND button. 3.A single press on the either the TUNING UP “ ” or DOWN “ ”buttons will change the frequency up or down.
3. Press the numbered button corresponding to the preset memory location for the required station .The radio will instantly tune to the station and the display will show its frequency and memory location. Select Short W ave Meter band 1.Turn on the radio by pressing the POWER on/off button.
ALARM button again to cancel the alarm, The alarm symbol will flash for 7 seconds and disappear. Note: 1.When the alarm is sounding, press POWER button to turn off the alarm for 24 hours. 2.The radio alarm will last for one hour if not turned off by pushing the POWER button.
removed form the display . Light Pressing the light button located on the top of the radio will turn on the light and illuminate the display for approximately 7 seconds. MW step switch 1.This switch located on the bottom side of the radio provides a means of changing the MW step from 9kHz to 10 kHz.
Circuit features Semiconductors 1 LSI,5IC'S, 2 FET ,39 transistors ,34 diodes,1 LED Aerial system MW Built in ferrite aerial SW Telescopic aerial FM T elescopic aerial Output Power 180 m W Sockets Headphones socket 3.
An important point after buying a device Sangean ATS-404 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Sangean ATS-404 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Sangean ATS-404 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Sangean ATS-404 you will learn all the available features of the product, as well as information on its operation. The information that you get Sangean ATS-404 will certainly help you make a decision on the purchase.
If you already are a holder of Sangean ATS-404, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Sangean ATS-404.
However, one of the most important roles played by the user manual is to help in solving problems with Sangean ATS-404. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Sangean ATS-404 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
