Instruction/ maintenance manual of the product 745 Avalon Stoves
Go to page of 44
Pendleton (745/790) Owner's Manual • Freestanding Stove • Mobile-Home Approved • Alcove Approved • Hearth-Stove Approved • Masonry Fireplace Insert • Zero-Clearance (Metal) Fireplace Insert S A FE TY N OTIC E : If thi s appl i anc e i s not properl y i ns t al l ed, a hous e fi re ma y result.
2 Introduction Travis Industries 93508133 4 050124 Introduction We welcome you as a new owner of an Avalon Pendleton wood-burning stove. In an Avalon Pendleton you have joined the growing ranks of concerned individuals whose selection of an energy system reflects both a concern for the environment and aesthetics.
Table of Contents 3 Travis Industries 93508133 4 020509 General Information Introduction & Important Information ......................2 Safety Precautions .............................................4 Features & Specifications ..............
4 Safety Precauti ions Travis Industries 93508133 4 020509 • The viewing door must be closed and latched during operation. • Never block free airflow through the air vents on this appliance. Gas • Gasoline or other flammable liquids must never be used to start the fire or "Freshen Up" the fire.
Safety Precautions 5 Travis Industries 93508133 4 020509 Mobile Home • When installed in a mobile home, this appliance must be bolted to the floor, have outside air, and not be installed in the bedroom (Per H.U.D. requirements). Check with local building officials.
6 Features & Specifications Travis Industries 93508133 4 020509 Installation Options: • Freestanding • Freestanding in an Alcove • Freestanding in a Mobile Home • Mas onry Fireplace Insert • Factory-Built (Z.C.) Fireplace Insert Features: • EPA Phase II Approved • 1.
Stove Installation (for qualified installers only) 7 Travis Industries 93508133 4 020509 S AFE TY NOTICE : P lease r ead th is en t ir e m anu al b ef o r e yo u in st all and u se yo u r new r o o m h ea t e r . F a ilu r e t o fo llo w in s t r u c t io n s m ay r es u lt in p r o p e r t y dam age, b o d ily injur y, or even d eath .
8 Stove Installation (for qualified installers only) Travis Industries 93508133 4 020509 Floor Protection Requirements • Stove must be placed on the Travis Industries legs or Pedestal. • Must be non-combustible and at least .018" thick (26 gauge) Minimum 35-3/4" Minimum 38-3/8" Min.
Stove Installation (for qualified installers only) 9 Travis Industries 93508133 4 020509 Stove Placement Requirements Clearances may be reduced by methods specified in NFPA 211, listed wall shields, pipe shields, or other means approved by local building or fire officials.
10 Stove Installation (for qualified installers only) Travis Industries 93508133 4 020509 Chimney Requirements • DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE. • Chimney connector must be a minimum 24 MSG black or 26 MSG blued steel (6" diameter).
Stove Installation (for qualified installers only) 11 Travis Industries 93508133 4 020509 Chimney Termination Requirements • Must have an approved cap (to prevent water from entering) • Must not b.
12 Stove Installation (for qualified installers only) Travis Industries 93508133 4 020509 Alcove Installation Requirements Whenever the stove is placed in a location where the ceiling height is less than 7' tall, it is considered an alcove installation.
Stove Installation (for qualified installers only) 13 Travis Industries 93508133 4 020509 Mobile Home Requirements • Outside air must be installed - see "Outside Air Requirements" on page .
14 Stove Installation (for qualified installers only) Travis Industries 93508133 4 020509 Standard Ceiling with a Factory Built Chimney Chimney Cap (See the section "Chimney Termination Requireme.
Stove Installation (for qualified installers only) 15 Travis Industries 93508133 4 020509 Exterior Factory Built Chimney NOTE: Exterior chimneys are subject to greater moisture and creosote accumulation due to the lower temperatures. An insulated chase will reduce these accumulations (the proper clearances to the chimney must be maintained).
16 Stove Installation (for qualified installers only) Travis Industries 93508133 4 020509 Hearth Stove Direct Connection NOTE: Direct connections require installation of an airtight, non- combustible block-off plate or damper adapter.
Insert Installation (for qualified installers only) 17 Travis Industries 93508133 4 020509 S AFE TY NOTICE : P lease r ead th is en t ir e m anu al b ef o r e yo u in st all and u se yo u r new r o o m h ea t e r . F a ilu r e t o fo llo w in s t r u c t io n s m ay r es u lt in p r o p e r t y dam age, b o d ily injur y, or even d eath .
18 Insert Installation (for qualified installers only) Travis Industries 93508133 4 020509 Insert Size Requirements (see Illustration below) Minimum Fireplace Size Masonry Fireplace Z.
Insert Installation (for qualified installers only) 19 Travis Industries 93508133 4 020509 Masonry Fireplace Requirements • Chimney must have a clay tile liner or a stainless steel liner (positive connection) • Entire fireplace, including chimney, must be clean and undamaged.
20 Insert Installation (for qualified installers only) Travis Industries 93508133 4 020509 Block-Off Plate Installation Whenever this appliance is installed with a direct connection a block-off plate, or other non- combustible seal-off device (e.g. damper adapter), will need to be installed.
Insert Installation (for qualified installers only) 21 Travis Industries 93508133 4 020509 Insert with Positive Connection NOTE: Most factory-built chimney manufacturers make stainless steel chimney liners, either flexible or rigid. This provides a wide variety of installation options.
22 Insert Installation (for qualified installers only) Travis Industries 93508133 4 020509 Insert with Direct Connection (Z.C. Fireplace) NOTE: Direct connections require installation of an airtight block-off plate or damper adapter (see "Block-off Plate Installation" on page 20).
Operating Your Appliance 23 Travis Industries 93508133 4 020509 Safety Notice: If this appliance is not properly installed, a house fire may result. For your safety, follow the installation directions. Contact local building or fire officials about restrictions and installation inspection requirements in your area.
24 Operating Your Appliance Travis Industries 93508133 4 020509 Starting a Fire Since the dawn of time man has debated the best way to start a fire. Some use the boy-scout "tee- pee", some prefer the "tic-tac-toe" stack. Either way, review the hints and warnings below to ensure proper fire starting.
Operating Your Appliance 25 Travis Industries 93508133 4 020509 Adjusting the Burn Rate Use the air control slider to control the burn rate of the stove. See the illustration below for details. Low Burn (air control closed) High Burn (air control open) Use the air control to change the burn rate.
26 Operating Your Appliance Travis Industries 93508133 4 020509 Optional Blower Operation The blower will turn on once the stove is up to temperature. This is typically 15 to 30 minutes after starting the fire. Follow the directions below to alter the blower speed.
Operating Your Appliance 27 Travis Industries 93508133 4 020509 Hints for Burning • Get the appliance hot before adjusting to low burn • Use smaller pieces of wood during start-up and high burns t.
28 Operating Your Appliance Travis Industries 93508133 4 020509 Troubleshooting Problem Possible Cause Smoke Enters Room During Start-Up • Cold Air Blockage - burn a piece of newspaper to establish a draft. • Close the doors - if the flame is no t getting enough air, first make sure the air control is open (all the way in).
Maintaining Your Appliance 29 Travis Industries 93508133 4 020509 Failure to properly maintain and inspect your appliance may reduce the performance and life of the appliance, void your warranty, and create a fire hazard. Daily Maintenance (while stove is in use) Remove Ash (if necessary) Ash removal is not required once it builds up.
30 Maintaining Your Appliance Travis Industries 93508133 4 020604 Monthly Maintenance (while appliance is in use) Make sure the appliance has fully cooled prior to conducting service. Door and Glass Inspection The door must form an air-tight seal to the firebox for the stove to work correctly.
Maintaining Your Appliance 31 Travis Industries 93508133 4 020509 Yearly Maintenance Make sure the appliance has fully cooled prior to conducting service. Touch Up Paint Included with the owner's pack of this appliance is a can of Stove-Brite ® paint.
32 Maintaining Your Appliance Travis Industries 93508133 4 020509 Door Parts 5/16" Nutdriver Glass Clip Screw Door Gasket - Adhere with gasket cement.
Maintaining Your Appliance 33 Travis Industries 93508133 4 060417 Firebox Parts 1 5 2 3 4 6 6 6 6 7 8 8 6 6 6 6 The baffle support rests on these bars (welded to side of firebox). The baffle firebrick rest on top of the firebrick lining the back of the firebox.
34 Maintaining Your Appliance Travis Industries 93508133 4 020509 Air Tube Removal & Replacement a b Remove the left pin on the air tube collar (it may be a roll pin or push pin). Air Tube Collar Air Tube Push Pin Slide the air tube to the left, swing it down and remove from the firebox.
Limited 7 Year Warranty 35 Travis Industries 93508133 4 050124 To register your TRAVIS INDUSTRIES, INC. 7 Year Warranty, complete the enclosed warranty card and mail it within ten (10) days of the appliance purchase date to: TRAVIS INDUSTRIES, INC., 4800 Harbour Pointe Blvd.
36 Listin g Label Travis Industries 93508133 4070821.
Optional Equipment 37 Travis Industries 93508133 4 020509 Stove Leg Installation (Brass # 99200500, Cast Black # 99200800, Sculptured # 99200105) Raise the stove 8" (use lumber).
38 Optional Equipment Travis Industries 93508133 4 020509 Outside Air Installation (for wood stoves only) This pedestal has an internal air duct that may be used to direct air to the combustion chamber. Follow the directions below prior to installing the stove or attaching the pedestal.
Optional Equipment 39 Travis Industries 93508133 4 020509 The cover plate has a clip which attaches it underneath the air control. Remove the two screws that hold the bridge to the cover plate. Then replace the bridge when the cover plate is in place.
40 Optional Equipment Travis Industries 93508133 4 020509 Rear Blower Installation (Part number 99000138) The rear blower improves heat transfer by pushing heated air through the convection channel. Operating instructions are described in the section "Blower Operation" on page 26.
Optional Equipment 41 Travis Industries 93508133 4 020509 Outside Air Boot Installation (Part number 99200134) The outside air boot routes outside air to the stove for combustion. Refer to the section "Outside Air Requirements" on page 26 for installation concerns.
42 Optional Equipment Travis Industries 93508133 4 051104 Surround Panels (see part #'s below) Size Size on Insert (w trim) PART # 8" 39 7/8" width by 28" height 99300259 10" 43 7/8" width by 30" height 99300260 12" 47 7/8" width by 32" height 99300261 INSTALLATION INSTRUCTIONS 1.
Optional Equipment 43 Travis Industries 93508133 4 020509 Front Blower (part # 99000137) TO SWITCH THE POWER CORD TO THE LEFT SIDE: Follow the directions below to switch the power cord. Make sure the power cord, wires, or molex assembly do not protrude into the opening of the blower.
44 Index Travis Industries 93508133 4 020509 Air Control ....................................................2 5 Air Tube Part Number ....................................3 3 Air Tube Removal & Replacement .................... 3 4 Alcove ..........
An important point after buying a device Avalon Stoves 745 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Avalon Stoves 745 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Avalon Stoves 745 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Avalon Stoves 745 you will learn all the available features of the product, as well as information on its operation. The information that you get Avalon Stoves 745 will certainly help you make a decision on the purchase.
If you already are a holder of Avalon Stoves 745, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Avalon Stoves 745.
However, one of the most important roles played by the user manual is to help in solving problems with Avalon Stoves 745. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Avalon Stoves 745 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
