Instruction/ maintenance manual of the product Pro9544FT3 Audiovox
Go to page of 8
SELECT ABLE FEA TURES Note: The method of manual override can either be selected to operate from the valet switch or operate as custom code. Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
Page 2 Fifth Press and release the valet switch 2 chirps = active locks Press transmitter Lock button to change 1 chirp = passive locks or Sixth Press and release the valet switch 2 chirps = active ar.
Page 3 the dash, located where it can be easily seen from outside the vehicle, yet not be distracting to the driver . Once a location has been selected, check behind the panel for wire routing access, and to confirm the drill will not damage any existing components as it passes through the panel.
Dark Blue Wire: DELA YED 300 mA PULSED OUTPUT / CHANNEL 3 The dark blue wire pulses to ground via an independent RF channel from the keychain transmitter . This is a transistorized, low current output, and should only be used to drive an external relay coil.
Page 5 crank positions, and off when the key is in the of f position. (This is where the yellow wire from the alarm should be connected). Cut the low current starter solenoid wire in the vehicle, and connect one side of the cut wire to relay terminal 87.
Page 6 2 Pin White Connector: Dash Mounted LED Route the red and blue wires in the 2 pin white connector from the LED to the control module, and plug it into the mating white connector on the side of the module.
3 W ire Positive Switched 2 Step Door Locks The green wire provides a positive pulse during arming, or the pulsed + 12 volt lock output. Connect the green wire to the wire that provides a low current positive signal from the factory door lock switch to the factory door lock control relay .
© 2000 Audiovox Electronics Corp., Hauppauge, N.Y. 11788 128-5761.
An important point after buying a device Audiovox Pro9544FT3 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Audiovox Pro9544FT3 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Audiovox Pro9544FT3 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Audiovox Pro9544FT3 you will learn all the available features of the product, as well as information on its operation. The information that you get Audiovox Pro9544FT3 will certainly help you make a decision on the purchase.
If you already are a holder of Audiovox Pro9544FT3, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Audiovox Pro9544FT3.
However, one of the most important roles played by the user manual is to help in solving problems with Audiovox Pro9544FT3. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Audiovox Pro9544FT3 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
