Instruction/ maintenance manual of the product PRO-9342FT3 Audiovox
Go to page of 8
Model PRO-9342FT3 Installation Manual Note: When both Passive Arming and V oltage Sensing are selected, you must hardwire the driver ’s door pin switch in order to begin the passive arming sequence. RF Programmable Features : Feature Selection 1 Chirp 2 Chirps 3 Chirps 4 Chirps Default 1st Door L/UL 1 Sec.
Page 2 Sixth Press and release the valet switch 2 chirps = hardwire Press transmitter Lock button to change 1 chirp = voltage sense or Seventh Press and release the valet switch 1 chirp = siren and ho.
Page 3 Dash Mounted LED: A small red LED is included that will serve as a visual indicator of the alarm status. It should be installed in the dash, located where it can be easily seen from outside the vehicle, yet not be distracting to the driver .
Page 4 Connect the dark blue wire to terminal 86 of the AS - 9256 relay (or equivalent 30A automotive relay), and wire the remaining relay contacts to perform the selected function of channel 3. White w/ Black T race Wire: POSITIVE OUTPUT TO SIREN Route this wire through a rubber grommet in the firewall and to the siren location.
Page 5 pulsed output should only be connected to the low current switched ground output from the vehicle's horn switch. If the vehicle switches high current ground or + 12 volts to the horn, a relay must be used to operate the vehicle horn.
Page 6 current draw through these outputs must not exceed 300 mA. The Red w/Black trace wire will provide a pulsed ground only , and will only provide an output when the unlock button of the transmitter is pressed a second time after a first unlock command was issued.
Page 7 output. Connect this wire to the drivers door unlock relay that requires a low current positive signal to unlock only the drivers door . If the vehicle does not have a separate drivers door relay , one will have to be added. Locate the drivers door unlock motor wire and cut it at a convenient location to allow wiring of an optional relay .
© 2000 Audiovox Electronics Corp., Hauppauge, N.Y. 11788 128-5765A.
An important point after buying a device Audiovox PRO-9342FT3 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Audiovox PRO-9342FT3 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Audiovox PRO-9342FT3 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Audiovox PRO-9342FT3 you will learn all the available features of the product, as well as information on its operation. The information that you get Audiovox PRO-9342FT3 will certainly help you make a decision on the purchase.
If you already are a holder of Audiovox PRO-9342FT3, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Audiovox PRO-9342FT3.
However, one of the most important roles played by the user manual is to help in solving problems with Audiovox PRO-9342FT3. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Audiovox PRO-9342FT3 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
