Instruction/ maintenance manual of the product PRO 9549UG Audiovox
Go to page of 8
Page 1 Model PRO 9549UG Installation Manual SELECT ABLE FEA TURES Note : The method of manual override can either be selected to operate from the valet switch or operate as custom code. Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
Page 2 INST ALLA TION OF MAJOR COMPONENTS Control Module : Select a mounitng location inside the passenger compartment ( up behind the dash ), and secure using the two screws provided. The control module can also be secured in place using cable ties. Do not mount the control module in the engine compartment, as it is not waterproof.
Page 3 When installing this system into vehicles with electronic “ after fans “, it is recommended you disable the voltage sense circuit. In voltage sensing applications, the closer to the battery that the red wire is connected, the less sensitive the voltage sense circuitry will be.
Page 4 Mini 10 Pin Edge Connector : Light Green Wire : ( - ) Instant T rigger Zone 1 This is an instant on ground trigger wire. This wire ( zone ) should be reserved for connection to optional ground output trigger devices such as motion and / or shock impact sensors.
Page 5 This wire provides an immediate ground signal, and stays at ground for up to 8 seconds as long as the button(s) on the keychain transmitter remain pressed. W ARNING ! Connecting the dark green w/ black trace wire to the high current switched output of trunk release circuits will damage the control module.
5 Wire Alternating Door Lock Circuits : In this application, it is necessary to cut the existing door lock by - pass wires. These wires run from the master door lock switch to the slave door lock switch, and then on to the door lock motors. Cut the existing lock wire, and connect the yellow wire to the slave switch or motor side of the cut wire.
Page 7 RED 87A 85 86 30 CUT TO IGNITION SWITCH TO START SOLENOID 87 TO +12 VDC IGN./CRANK EXISTING LOW CURRENT SOLENOID FEED WIRE (+12VDC, CRANKING ONLY) PRO 9549UG CONTROL MODULE ORANGE TRUNK.
PRO 9549UG CONTROL MODULE BLACK 2 STEP UNLOCK RELAY OUTPUTS To Relay Terminal #85 To Relay Terminal #86 LT. BLUE L.E.D. ZONE 1 Optional Negative Triggering Alarm Accessories LT.
An important point after buying a device Audiovox PRO 9549UG (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Audiovox PRO 9549UG yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Audiovox PRO 9549UG - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Audiovox PRO 9549UG you will learn all the available features of the product, as well as information on its operation. The information that you get Audiovox PRO 9549UG will certainly help you make a decision on the purchase.
If you already are a holder of Audiovox PRO 9549UG, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Audiovox PRO 9549UG.
However, one of the most important roles played by the user manual is to help in solving problems with Audiovox PRO 9549UG. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Audiovox PRO 9549UG along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
