Instruction/ maintenance manual of the product PRO 9549FT Audiovox
Go to page of 8
Page 1 SELECT ABLE FEA TURES Note : The method of manual override can either be selected to operate from the valet switch or operate as custom code. Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
Page 2 INST ALLA TION OF MAJOR COMPONENTS Control Module : Select a mounting location inside the passenger compartment ( up behind the dash ), and secure using the two screws provided. The control module can also be secured in place using cable ties. Do not mount the control module in the engine compartment, as it is not waterproof.
Page 3 WIRING THE SYSTEM Large 10 Pin Edge Connector : Red Fused Wire : + 12 VDC Constant Battery Source This wire controls the sensitivity of the voltage sensing circuit, which detects the turning on of an interior light when a door is opened.
Page 4 2 Dark Green w/ White T race Wires : Entry Illumination The dark green w/ white trace wires provide the entry lighting, and flash the vehicle’s dome light while the alarm is sounding. These are NO ( normally open ) and COM ( common ) contacts of an on board, 10 Amp maximum relay .
Page 5 Black w/ White T race Wire : 300 mA Horn Output The black w/ white trace wire is provided to beep the vehicle’s horn. This is a transistorized low current output, and should only be connected to the low current ground output from the vehicle’s horn switch.
vehicle. The white wire is the positive pulse “ unlock “ output, and should be connected to the positive unlock wire in the vehicle. 5 Wire Alternating Door Lock Circuits : In this application, it is necessary to cut the existing door lock by - pass wires.
RED 87A 85 86 30 CUT TO IGNITION SWITCH TO START SOLENOID 87 TO +12 VDC IGN./CRANK EXISTING LOW CURRENT SOLENOID FEED WIRE (+12VDC, CRANKING ONLY) ORANGE OPTIONAL DEVICE or TRUNK RELEASE Conne.
PRO 9549FT CONTROL MODULE BLACK + LT. BLUE L.E.D. ZONE 1 Optional Negative Triggering Alarm Accessories LT. GREEN HEADLIGHT OUTPUT 30 Second Ground Output During Arm & Disarm (Optional Relay R.
An important point after buying a device Audiovox PRO 9549FT (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Audiovox PRO 9549FT yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Audiovox PRO 9549FT - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Audiovox PRO 9549FT you will learn all the available features of the product, as well as information on its operation. The information that you get Audiovox PRO 9549FT will certainly help you make a decision on the purchase.
If you already are a holder of Audiovox PRO 9549FT, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Audiovox PRO 9549FT.
However, one of the most important roles played by the user manual is to help in solving problems with Audiovox PRO 9549FT. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Audiovox PRO 9549FT along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
