Instruction/ maintenance manual of the product Platinum APS-597 Audiovox
Go to page of 12
128-7407 1 of 12 Model APS-597 Installation Manual SELECT ABLE FEA TURES The selectable features can be set manually as explained below , or with the RF feature programmer . T o set features using the RF programmer , follow the instructions packaged with the programmer .
128-7407 2 of 12 Page 2 T o program these selectable features; Action System Response Turn ignition on No response Press and release the valet switch 3 times 1 Chirp - LED 1 flash Within 3 seconds, tu.
128-7407 3 of 12 T o exit program mode, turn ignition off, or press and release valet switch. RF Programmable Features Bank 3 Is Remote Start Selectable Features: Feature Selection 1 Chirp 2 Chirps 3 .
128-7407 4 of 12 Page 4 INST ALLA TION OF MAJOR COMPONENTS Note: This system allows the transmitter to be programmed for single button lock/unlock or separate button lock/unlock.
128-7407 5 of 12 Page 5 Drill a ¼ “ diameter hole, and pass the red and blue wires from the LED through the hole, from the front of the panel. Firmly press the body of the LED into the hole until fully seated. V alet Switch: Select a mounting location for the switch that is easily accessible to the driver of the vehicle.
128-7407 6 of 12 Page 6 White w/ Black T race Wire: POSITIVE OUTPUT TO SIREN Route this wire through a rubber grommet in the firewall, and to the siren location. Connect the white / black wire to the positive wire of the siren. Secure the black ground wire of the siren to chassis ground.
128-7407 7 of 12 Page 7 Dark Green Wire: ( - ) INST ANT TRIGGER ZONE This is an instant on ground trigger wire. It must be connected to the previously installed hood and trunk pin switches.
128-7407 8 of 12 3 Wire Ground Switched Single Step Door Locks In this application, the red wire provides a ground pulse during arming, or the pulsed ground lock output. Connect the red wire to the wire that provides a low current ground signal from the factory door lock switch to the factory door unlock control relay .
128-7407 9 of 12 terminal 85 & 87 to a fuse + 12 volt source. Connect terminal 30 to the low current door unlock wire from the factory door switch to the door unlock control relay .
128-7407 10 of 12 Page 10.
128-7407 11 of 12 Page 11 THIS P AGE LEFT BLANK INTENTIONALL Y.
128-7407 12 of 12 © 2005 Audiovox Electronic Corporation, 150 Marcus Blvd., Hauppauge, N.Y. 11788 Page 12 128-7407.
An important point after buying a device Audiovox Platinum APS-597 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Audiovox Platinum APS-597 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Audiovox Platinum APS-597 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Audiovox Platinum APS-597 you will learn all the available features of the product, as well as information on its operation. The information that you get Audiovox Platinum APS-597 will certainly help you make a decision on the purchase.
If you already are a holder of Audiovox Platinum APS-597, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Audiovox Platinum APS-597.
However, one of the most important roles played by the user manual is to help in solving problems with Audiovox Platinum APS-597. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Audiovox Platinum APS-597 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
