Instruction/ maintenance manual of the product Range Roper
Go to page of 7
A WARNING l ALL RANGES,CAN TIP l lNJURY.TO PERSONS COULD RESU,LT l INSTALL ANTI-TIP DEVICE’PACKED WITH RANGE l 3EE’INSTALLATION INSiRUCTlONS IMPORTAiVT: Read and save these in&,rktionS. IMPORTANT: Installer: Leave Instdlation Instructions with the homeowner.
Before you start... Proper hlstallanon is your responsibility. A qualified technician should ihstall this range. Make sure you have everything necessary for correct installation. It is the responsibility of the installer to comply with the installation clearances specified on the serial/rating plate.
D . A 120-volt, 60-Hz, AC-only, 15-ampere, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit serving only this appliance be provided. Electronic ignition systems operate within wide voltage limits, but proper grounding and polarity are necessary.
_- Electronic Ignition System. Initial lighting and gas flame adjustments. Cooktop and oven burners use electronic ignitors in place of standing pilots. When the cooktop control knob is turned to the “LlTE” position, the system creates a spark to light the burner.
Check the oven burner for proper flame. This flame should be l/2” long, with inner cone of bluish-green, and outer mantle of dark blue, and should be clean and soft in character. No yellow tips, blowing or lifting of flame should occur. shutter until the proper flame appears.
-...- --- - L.P. gas . D . Broil burner: n$----- Cap -----A+ -L!%K- msen 7lfsl -- - Nat. Gas L.P. Gas conversion Fire Hazard m Locate gas supply valve between pressure regulator and gas valve. Shut off gas supply valve in range before converting to L.
If range does not operate... . Check that the circuit breaker is not tripped or the house fuse blown. . Check that the power supply cord is plugged into wall receptacle.
An important point after buying a device Roper Range (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Roper Range yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Roper Range - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Roper Range you will learn all the available features of the product, as well as information on its operation. The information that you get Roper Range will certainly help you make a decision on the purchase.
If you already are a holder of Roper Range, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Roper Range.
However, one of the most important roles played by the user manual is to help in solving problems with Roper Range. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Roper Range along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
