Instruction/ maintenance manual of the product WD1450 RIDGID
Go to page of 40
Part No. SP6542 Printed in Canada OWNERS MANUAL WD1450 14 U.S. GALLONS/ 12 CDN. GALLONS PROFESSIONAL WET/DRY V AC For Y our Safety: Read all instructions car efully Save this manual for future refer ence FOR QUESTIONS OR INFORMA TION CONT ACT US A T 1-800-4-RIDGID (1-800-474-3443) OR www .
2 T able of Contents Section Page T able of Contents . . . . . . . . . . . . . . . . . 2 Important Safety Instructions . . . . . . . . . 2 Safety Signal Words . . . . . . . . . . . . . . 2 Introduction . . . . . . . . . . . . . . . . . . . . . . 4 Unpacking and Checking Carton Contents .
• Keep hair , loose clothing, fingers, and all parts of body away from openings and moving parts. When using as blower: • Direct air discharge only at work area. • Do not direct air at bystanders. • Keep children away when blowing. • Do not use blower for any job except blowing dirt and debris.
4 Introduction This Wet/Dry V ac is intended for house- hold use only . This W et/Dry vac is supplied with a two stage/high efficiency filter . It can be used not only to pick up materials like sawdust and gravel but also ultra fine material like drywall dust and cold fireplace ash.
P Q R I D G I N 5 Carton Contents List Key Description Qty A Wet/Dry V ac Assembly.................1 B* Filter Nut ......................................1 C* Filter Plate ....................................1 D* VF5000 Filter .........................
1. Carefully slide the filter over the filter cage, sliding it over the center ring covering the 3 slots until the filter stops against the lid. 2. Place filter nut and filter plate onto threaded stud and tighten it down. Finger tighten only . NOTE: Lever of filter nut should be away from plate as shown.
If any parts are missing or damaged contact Customer Service. Do not assemble until you have all the parts. 1. Insert the front and rear caster feet into the bottom of drum as shown. Light taps with a mallet or hammer may be needed to fully seat both caster feet.
8 Accessory Rod Receptacles Accessory Storage Bag Rods R I D G I Powerhead Accessory Storage Rod Pull Straight Up Installing Accessory Storage Bag 1. Position rods of accessory storage bag directly over accessory rod receptacles in dust drum. 2. Slide rods of accessory storage bag into accessory rod receptacles until fully seated.
W et/Dry V ac Assembly 1. Position the powerhead assembly on the drum/caster foot assembly as shown (assembled earlier). 2. Rotate both latches down and press until you hear them snap over the flanges on the drum.
Operation W ARNING T o reduce the risk of fire or explosion, do not operate this vac in areas with flammable gases, vapors or explosive dust in the air . Flammable gases or vapors include but are not limited to; lighter fluid, solvent type cleaners, oil- base paints, gasoline, alcohol or aerosol sprays.
Operation (continued) W ARNING: T o reduce the risk of injury from accidental starting, unplug power cord before emptying the drum. W ARNING: T o reduce the risk of back injury or falls, do not lift a vac heavy with liquid or debris. Scoop or drain enough contents out to make the vac light enough to lift comfortably .
12 Push/Pull Handle Cord Wrap Power Cord Accessory Storage Y our accessories may be stored in the accessory storage bag, or in the two locations on the rear caster feet.
13 W ARNING: T o assure product SAFETY and RELIABILITY , repairs and adjustments should be performed by Independent Service Centers, always using RIDGID replacement parts. Maintenance W ARNING: T o reduce the risk of injury from accidental starting, unplug power cord before changing or cleaning filter .
14 Filter Replacement Which Replacement Filter Meets Y our Needs? Choosing a filter is as easy as 1, 2, 3... Standard Filter Filter System with antimicrobial product protection Fights and inhibits the.
15 Log on to www .ridgidvac.com/filterclub to Join Our Filter Club and/or Enter Our $500 Home Depot Gift Card Sweepstakes. (No Need to Join the Filter Club to Win) MAXIMIZE V ACUUM PERFORMANCE WITH A .
Key No. Part No. Description 1 830564 Actuator , Switch 2 813213 Switch, T oggle 3 830701 Motor Cover Assembly 4 830566 Motor Exhaust 5 509776-7 Motor Assembly (Includes Keys 12 through 15) 6 829718-8.
RIDGID parts are available on-line at www .ridgidparts.com 30 7 4 3 1 2 5 6 9 10 17 16 12 14 15 13 18 19 20 33 37 32 31 34 35 8 11 R I D G I 27 26 24 25 28 29 23 21 22 W ARNING SERVICING OF DOUBLE-INSULA TED WET/DR Y V AC In a double-insulated Wet/Dry V ac, two systems of insulation are provided instead of grounding.
18 Notes SP6542 14 Gallon 9/7/04 1:31 PM Page 18.
19 Notes SP6542 14 Gallon 9/7/04 1:31 PM Page 19.
Part No. SP6542 Form No. SP6542 Printed in Canada 05/04 What is covered RIDGID ® tools are warranted to be free of defects in workmanship and material.
No. de pieza SP6542 Impreso en Canadá MANUAL DEL USUARIO WD1450 ASPIRADORA P ARA MOJADO/SECO PROFESIONAL DE 14 GALONES EE.UU./ 12 GALONES CANADIENSES Para su seguridad: Lea detenidamente todas las instrucciones. Guarge este manual para r eferencia futura.
22 Indice Sección Página Indice . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 Instrucciones de seguridad importantes . . . . . . . 22 Palabras de señal de seguridad . . . . . . . . . . . . 22 Introducción 24 Desempaquetado y comprobación del contenido de la caja de cartón .
23 • Para reducir el riesgo de que se produzcan peligros para la salud causados por vapores o polvos, no recoja con la aspiradora materiales tóxicos. • No use ni almacene la aspiradora para mojado/seco cerca de materiales peligrosos. • Para reducir el riesgo de caídas, tenga cuidado adicional al limpiar en escaleras.
24 Introducción Esta aspiradora para mojado/seco está diseñada para uso doméstico solamente. La aspiradora para mojado/seco está provista de un filtro de dos etapas de alta eficiencia.
25 P Q R I D G I N Lista del contenido de la caja de cartón Clave Descripción Cant. A Ensamblaje de la aspiradora para mojado/seco ..................................1 B* T uerca del filtro ..........................................1 C* Placa del filtro .
Filter Threaded Stud Filter Cage Slots (3) Filter Nut Filter Nut Lever Filter Plate THIS SIDE TOWARD LID Filter Cage T abs (3) Float Solid End Slots (3) Filter Cage T abs (3) Slots (3) Power Head Assembly 26 1.
Front Caster Foot Drain #10 x 1-3/4" Screw (4) Rear Caster Foot Rear Caster Foot Drain Front Caster Foot Drum Socket Caster Stem Caster Ball 27 Si cualquiera de las piezas falta o está dañada, póngase en contacto con Servicio al Cliente. No monte la aspiradora hasta que tenga todas las piezas.
28 Accessory Rod Receptacles Accessory Storage Bag Rods R I D G I Powerhead Accessory Storage Rod Pull Straight Up Instalación de la bolsa de almacenamiento de accesorios 1.
Ensamblaje de la aspiradora para mojado/seco 1. Posicione el ensamblaje del cabezal del motor sobre el ensamblaje del tambor y los pies de ruedecilla, de la manera que se muestra en la ilustración (ensamblado anteriormente). 2. Gire ambos pestillos hacia abajo y presione hasta que los oiga acoplarse a presión sobre las pestañas del tambor .
30 Para reducir el riesgo de sacudidas eléctricas, este aparato electrodoméstico tiene un enchufe polarizado (una hoja es más ancha que la otra). Este enchufe entrará en un tomacorriente polarizado solamente de una manera. Si el enchufe no entra por completo en el tomacorriente, déle la vuelta.
Recogida de líquidos con la aspiradora IMPORT ANTE: 1. Al recoger pequeñas cantidades de líquido se podrá dejar puesto el filtro. 2. Al recoger grandes cantidades de líquido recomendamos quitar el filtro. Si no se quita el filtro, éste se saturará y podrá aparecer niebla en el escape.
32 Push/Pull Handle Cord Wrap Power Cord Almacenamiento de accesorios Los accesorios se pueden almacenar en la bolsa de almacenamiento de accesorios o en las dos ubicaciones que están en los pies de ruedecilla traseros. NOT A: Introduzca el extremo macho del tubo extensor en el manguito del portador de la manera que se muestra en la ilustración.
33 Filtro La aspiradora para mojado/seco profesional de 14 galones se suministra con un filtro para polvo fino VF5000 de RIDGID. Los filtros para polvo fino VF5000 de repuesto se pueden obtener a través del establecimiento donde usted compró la aspiradora.
34 Reemplazo del filtro ¿Qué filtro de reemplazo es adecuado para sus necesidades? Escoger un filtro es tan fácil como decir 1, 2, 3… Filtro estándar Sistema de filtro con protección con produc.
35 Conéctese a www .ridgidvac.com/filterclub para hacerse miembro de nuestro Club de Filtros y/o inscribirse en nuestro Sorteo de T arjetas de Regalo de Home Depot por valor de US$ 500.
No. de No. de clave pieza Descripción 1 830564 Accionador del interruptor 2 813213 Interruptor de palanca 3 830701 Ensamblaje de la cubierta del motor 4 830566 Escape del motor 5 509776-7 Ensamblaje .
30 7 4 3 1 2 5 6 9 10 17 16 12 14 15 13 18 19 20 33 37 32 31 34 35 8 11 R I D G I 27 26 24 25 28 29 23 21 22 37 Las piezas RIDGID se encuentran disponibles en línea conectándose a www .
38 Notas SP6542 14 GallonSP 9/7/04 2:59 PM Page 38.
Notas 39 SP6542 14 GallonSP 9/7/04 2:59 PM Page 39.
W ARNING: The power cord on this product contains lead, a chemical known in the State of California to cause birth defects or other reproductive harm. Wash hands after handling. No. de pieza SP6542 Formulario No. SP6542 Impreso en Canadá 05/04 ¿PREGUNT AS O COMENT ARIOS? LLAME AL 1-800-4-RIDGID (1-800-474-3443) www .
An important point after buying a device RIDGID WD1450 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought RIDGID WD1450 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data RIDGID WD1450 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, RIDGID WD1450 you will learn all the available features of the product, as well as information on its operation. The information that you get RIDGID WD1450 will certainly help you make a decision on the purchase.
If you already are a holder of RIDGID WD1450, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime RIDGID WD1450.
However, one of the most important roles played by the user manual is to help in solving problems with RIDGID WD1450. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device RIDGID WD1450 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
