Instruction/ maintenance manual of the product Car Security System APS-610 Audiovox
Go to page of 10
Model APS-610 Installation Manual SELECT ABLE FEA TURES Note: The method of manual override can either be selected to operate from the valet switch or operate as custom code. Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
Page 2 Fourth Press and release the valet switch 3 chirps = headlight output when arming and disarming Press transmitter Lock button to change 4 chirps = headlight output off Press transmitter Lock bu.
Page 3 If during the program sequence receiver channel 1 is programmed, and received channel 2 is skipped over , as indicated in the transmitted program guide, then the unit will operate as a single button lock/unlock unit from that transmitter .
Page 4 Whichever mounting method is selected, make certain that the sensitivity adjustment is accessible for use later in the installation. WIRING THE SYSTEM Large 10 Pin Edge Connector: Red/White (5A.
Page 5 Orange Wire: 300 mA Ground Output When Armed - N. C. Starter Disable This wire is provided to control the starter cut relay . Connect the orange wire to terminal 86 of the relay .
Page 6 Note: This is a normally opened starter cut arrangement, and when power is removed from the security system, the starter disable feature will remain operational, and the vehicle will not start. Audiovox does not recommend using the Orange w/ White trace wire to interrupt anything but the starting circuit of the vehicle.
Page 7 2 Pin White Connector: Dash Mounted L.E.D. Route the red and blue wires in the 2 pin white connector from the L.E.D. to the control module, and plug it into the mating white connector on the side of the module.
Page 8 Next, locate the drivers door unlock motor wire and cut it at a convenient location to allow wiring of the White and Dark Blue wires. Dark Blue will connect to the vehicle side of the cut wire and White will connect to the "Unlock Drivers Door Motor" side of the cut wire.
Page 9 COMPLETING THE INST ALLA TION Antenna Wire: Be sure to extend the thin black antenna wire to it’s full length, and cable tie into place where it cannot be damaged.
© 2000 Audiovox Corporation, 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-5758A.
An important point after buying a device Audiovox Car Security System APS-610 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Audiovox Car Security System APS-610 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Audiovox Car Security System APS-610 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Audiovox Car Security System APS-610 you will learn all the available features of the product, as well as information on its operation. The information that you get Audiovox Car Security System APS-610 will certainly help you make a decision on the purchase.
If you already are a holder of Audiovox Car Security System APS-610, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Audiovox Car Security System APS-610.
However, one of the most important roles played by the user manual is to help in solving problems with Audiovox Car Security System APS-610. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Audiovox Car Security System APS-610 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
