Instruction/ maintenance manual of the product APS-620 Audiovox
Go to page of 12
1 128-7829 1 of 12 Model APS-620 Installation Manual This Remote Start System is designed to be used with Automatic T ransmission- Fuel Injection V ehicles Only! COMPONENTS: Control Module 2 Four Button RF Transmitters Antenna/Receiver 1 1” X 1.
2 128-7829 2 of 12 INST ALLA TION OF THE MAJOR COMPONENTS: CONTROL MODULE: Select a mounting location inside the passenger compartment (up behind the dashboard). The mounting location selected must be within 24" of the ignition switch wiring harness to allow connection of the 6 pin main wiring harness.
3 128-7829 3 of 12 DO NOT PLUG THE SIX PIN MAIN POWER HARNESS OR THE MUL TI PIN INPUT / OUTPUT HARNESS INTO THE CONTROL MODULE UNTIL ALL CONNECTIONS T O THE VEHICLE HA VE BEEN MADE. AFTER SELECTING YOUR T ARGET WIRES AS DEFINED BELOW , DISCONNECT THE NEGA TIVE BA TTERY CABLE FROM THE VE- HICLE BA TTERY PRIOR T O MAKING ANY CONNECTIONS.
4 128-7829 4 of 12 the circuit and select the correct installation method. In addition you will realize why the connection of the safety wire is required for all mechanical switch con- figurations. Failure to make this connection properly can result in personal injury and property damage.
5 128-7829 5 of 12.
6 128-7829 6 of 12 W iring The 4 Pin Auxiliary Output Harness, Connector “A” The auxiliary 4 pin connector provides low current outputs to control various functions in the vehicle during different stages of the Remote Start unit's operation.
7 128-7829 7 of 12 3 Pin Antenna/Receiver , Connector “F” Route the 3 pin connector from the previously installed antenna receiver assemble to the mating connector on the control module. This connector supplies 5 volts, ground and RF data from the antenna receiver to the remote start module.
8 128-7829 8 of 12 VEHICLE TO THE CONSUMER IF THIS CIRCUIT DOES NOT PERFORM AS SPECI- FIED. Green w/ Orange T race Wire: T achometer Input Signal This wire will continually monitor the engine's tach rate while the unit is under power of the Remote Start module.
9 128-7829 9 of 12 A. Shock Sensor By Pass: B. Additional Ignition Output: C. GM V A TS Key Override: Green w/ White trace Wire: Entry Illumination Ground Output This wire provides a 30 second ground output (300 mA Max.
10 128-7829 10 of 12 Setting Up The System Programming Features: Bank 1 Transmitter Channels Start with the system disarmed, turn the ignition switch to the on position then: 1) Press and release the push button valet/program switch 3 times. Siren Chirps once and or Lights flash one time indicating the transmitter program mode successfully entered.
11 128-7829 11 of 12 COMPLETING THE INST ALLA TION: After you have confirmed the operation of the Audiovox Remote Start unit and tested all the safety features of the system: 1. Mount the control module up and behind the dash securing it in place with cable ties or screws.
12 128-7829 12 of 12 © 2006 Audiovox Electronic Corporation 150 Marcus Blvd, Hauppauge NY 1 1788 128-7829.
An important point after buying a device Audiovox APS-620 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Audiovox APS-620 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Audiovox APS-620 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Audiovox APS-620 you will learn all the available features of the product, as well as information on its operation. The information that you get Audiovox APS-620 will certainly help you make a decision on the purchase.
If you already are a holder of Audiovox APS-620, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Audiovox APS-620.
However, one of the most important roles played by the user manual is to help in solving problems with Audiovox APS-620. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Audiovox APS-620 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
