Instruction/ maintenance manual of the product APS-20B Audiovox
Go to page of 8
Model APS-20B Installation Manual V ehicle Alarm System With Auxiliary Output Inst allation Instructions This Unit Is Intended For Installation In V ehicles With 12 V olt Negative Ground Electrical Sy.
The APS-20B V ehicle Alarm System is designed to provide a basic deterrent to vehicle thef t and a convenient electronic means to gain access to the vehicle by providing RF remote control over the vehicle's power door lock system.
3 open), it will supply a ground to the input wire thus activating the alarm. Mount the switch in the hood or trunk locations away from water drain paths. If necessary , the included bracket may be used to move the switch away from rain gutters or allow mounting to the firewall behind the hood seal.
4 DARK GREEN Wire: Negative (-) Hood/Trunk Trigger Input Wire This input is designed to connect to a grounding hood, trunk, or rear hatch pin-switch, to allow the system to trigger should those entry points be violated.
5 polarity" output scheme these two wires produce the opposite polarity at the opposite time. T o better understand this, refer to the table below: The output of these wires has a maximum switching capability of 300mA.
6 V ALET/PROGRAM/MANUAL OVERRIDE SWITCH 2-PIN Blue Plug w/2 Wires; Black and Gray The Black & Gray wires in the 2-PIN blue connector are the ground supply and V alet/Program input of the APS20B unit. When the Gray wire is grounded, under certain conditions, the unit will enter the valet mode.
7 mode and toggle the V alet/Program/Manual Override Switch 3 times in order to adjust the Fourth programmable feature. The system would respond with 1 Chirp and the LED would begin to flash 4 Flashes, pause and repeat.
© 2003 Audiovox Electronics Corporation 128-6187B.
An important point after buying a device Audiovox APS-20B (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Audiovox APS-20B yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Audiovox APS-20B - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Audiovox APS-20B you will learn all the available features of the product, as well as information on its operation. The information that you get Audiovox APS-20B will certainly help you make a decision on the purchase.
If you already are a holder of Audiovox APS-20B, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Audiovox APS-20B.
However, one of the most important roles played by the user manual is to help in solving problems with Audiovox APS-20B. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Audiovox APS-20B along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
