Instruction/ maintenance manual of the product APS 800a Audiovox
Go to page of 8
128-6199 1 of 8 SELECT ABLE FEA TURES Note : The method of manual override can either be selected to operate from the valet switch or operate as custom code. Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
128-6199 2 of 8 Page 2 or Eighth Press and release the valet switch 1 chirp = siren and horn output Press transmitter Lock button to change 2 chirps = siren output only Press transmitter lock button t.
128-6199 3 of 8 The valet switch can be mounted to the lower side of the dash by drilling a ¼ " diameter hole in the selected location. Be sure to check behind the dash for adequate clearance for the body of the switch, and to confirm that the drill will not damage any existing components as it passes through the dash.
128-6199 4 of 8 Page 4 Dark Blue Wire : DELA YED 300 mA PULSED OUTPUT / CHANNEL 3 The dark blue wire pulses to ground via an independent RF channel from the keychain transmitter . This is a transistorized, low current output, and should only be used to drive an external relay coil.
128-6199 5 of 8 Page 5 If the vehicle uses a + 12 VDC horn switch, then connect the black w/ white trace wire to terminal 86 of the AS 9256 relay (or an equivalent 30 Amp automotive relay), and connect relay terminal 85 to a fused + 12 VDC battery source.
128-6199 6 of 8 Page 6 2 Pin Blue Connector : VALET PUSH-BUTTON SWITCH Route the grey and black wires in the 2 pin connector from the valet switch to the control module, and plug it into the mating blue connector on the side of the module.
128-6199 7 of 8 Page 7 The red wire provides a positive pulse during disarming, or the drivers door pulsed positive unlock output. Connect this wire to the drivers door unlock relay that requires a low current positive signal to unlock only the drivers door .
128-6199 8 of 8 © 2003 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y . 1 1788 128-6199.
An important point after buying a device Audiovox APS 800a (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Audiovox APS 800a yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Audiovox APS 800a - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Audiovox APS 800a you will learn all the available features of the product, as well as information on its operation. The information that you get Audiovox APS 800a will certainly help you make a decision on the purchase.
If you already are a holder of Audiovox APS 800a, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Audiovox APS 800a.
However, one of the most important roles played by the user manual is to help in solving problems with Audiovox APS 800a. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Audiovox APS 800a along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
