Instruction/ maintenance manual of the product S2400M Regency
Go to page of 28
FPI FIREPLACE PRODUCTS INTERNA TIONAL L TD. 6988 V enture St., Delta, BC Canada, V4G 1H4 918-154b MODELS: F2400M S2400M Freestanding W oodstove 02/15/06 Installer : Please complete the details on the back cover and leave this manual with the homeowner .
Regency Freestanding Woodstove 2 Thank-you for purchasing a REGENCY FIREPLACE PRODUCT . The pride of workmanship that goes into each of our products will give you years of trouble-free enjoyment. Should you have any questions about your product that are not covered in this manual, please contact the REGENCY DEALER in your area.
Regency Freestanding Woodstove 3 T ABLE OF CONTENTS THE REGENCY FREEST ANDING WOOD ST OVE SAFETY LABEL Safety Label for F2400m ............................................... 4 Safety Label for S2400M ............................................... 5 INST ALLA TION Unit Dimensions .
Regency Freestanding Woodstove 4 This is a copy of the label that accompanies each Regency Freestanding Woodstove (F2400M). We have printed a copy of the contents here for your review . SAFETY LABEL NOTE: Regency units are constantly being improved. Check the label on the unit and if there is a difference, the label on the unit is the correct one.
Regency Freestanding Woodstove 5 SAFETY LABEL This is a copy of the label that accompanies each Regency Medium Freestanding Step Stove (S2400M). We have printed a copy of the contents here for your review . NOTE: Regency units are constantly being improved.
Regency Freestanding Woodstove 6 UNIT DIMENSIONS INST ALLA TION.
Regency Freestanding Woodstove 7 INST ALLA TION RESIDENTIAL INST ALLA TION 1) Please read this entire manual before you install and use your new woodstove. Failure to follow instructions may result in property damage, bodily injury or even death. Be aware that local Codes and Regulations may override some items in this manual.
Regency Freestanding Woodstove 8 Unit From Unit From Corner From Flue Center-Line A B C D E F Medium F2400M with Airmate 15" (381 mm) 5.5" (139 mm) 4" (101 mm) 27" (685 mm) 12" (304 mm) 15.5" (393 mm) with Rear Deflector 15" (381 mm) 6.
Regency Freestanding Woodstove 9 Minimum Alcove Clearance to Combustible Materials The Regency Freestanding models have been alcove approved and must be installed with a listed double wall connector to the ceiling level.
Regency Freestanding Woodstove 10 INST ALLA TION Diagram 2 Diagram 3 ST OVE ASSEMBL Y PRIOR T O INST ALLA TION All units require either the pedestal or 4 legs at- tached to the base. The F2400M stove requires either the Airmate or Rear Heat Deflector on top of th e st ov e.
Regency Freestanding Woodstove 1 1 Horizontal Installation Standard Ceiling Installation 8) T o com plet e your chi mney instal lati on, ins tall the double wall connector pipe from the stove’s flue collar to the chimney support device.
Regency Freestanding Woodstove 12 INST ALLA TION F ACTOR Y BUIL T CHIMNEY When a metal prefabricated chimney is used, the manufacturer's installation instructions must be followed.
Regency Freestanding Woodstove 13 M et h o d A : 12" (304.8 mm) Clearance to Combustible W all Member: Using a minimum thickness 3.5" (89 mm) brick and a 5/8" (15.
Regency Freestanding Woodstove 14 RECOMMENDED HEIGHTS FOR WOODST OVE FLUE Simple rules on draft (refer to T able 1). 1) At sea level minimum height is 12' straight. 2) Add the following vertical height to compen- sate for: 45 deg. elbow = 1 ft. 90 deg.
Regency Freestanding Woodstove 15 MOBILE HOME INST ALLA TION Once you have properly marked the position of your unit and the floor protection as outlined in the Residential Installation items #1 through #8, a supply of fresh air has to be supplied to your unit.
Regency Freestanding Woodstove 16 Slide the tube into the left hand side, as far as possible and then bring it back into the hole on the right hand side until it locks into position. If the tube will not slide in easily , simply use a pair of vise grips or pliers and tap it into place with a hammer .
Regency Freestanding Woodstove 17 INST ALLA TION GLASS INST ALLA TION Remove the door from the stove and remove the glass retainer. Position the glass in the door , make sure that the glass gasketing will properly seal your unit, and replace the retainer , it should res t on th e ga ske t not the glas s.
Regency Freestanding Woodstove 18 Blower/Fan (846-515) 1) Remove the two screws from the top of the fan housing. 2) Slide the fan up into the rear heat shield. 3) Aft er alig ning holes, secure the fan to the rear heat shield using the two screws removed earlier .
Regency Freestanding Woodstove 19 OPERA TING INSTRUCTIONS 9) During the first few days it may be more difficult to start the fire. As you dry out your firebrick and your masonry flue, your draft will increase. 10) For those units installed at higher elevations or into sub-standard masonry fireplaces, drafting problems may occur .
Regency Freestanding Woodstove 20 OPERA TING INSTRUCTIONS SAFETY GUIDELINES AND W ARNINGS 1) Never use gasoline, gasoline type lantern fuels, kerosene, charcoal lighter fuel, or similar liquids to start or ‘freshen up’ a fire in your heater . Keep all such liquids well away from the heater while it is in use.
Regency Freestanding Woodstove 21 MAINTENANCE CREOSOTE When wood is burned slowly , it produces tar and other organic vapours, which when combined with moisture, form creosote. The creosote va- pours condense in the relatively cool chimney flue of a slow burning fire.
Regency Freestanding Woodstove 22 Part# Description 1) 846-913 Door Assy-Med Gold F2400M (no glass) 846-915 Door Assy-Med Black F2400M (no glass) 3) 846-302 Glass - Replacement - F2400M 4) 936-243 7/8.
Regency Freestanding Woodstove 23 P ARTS LIST Part# Description 1) 846-913 Door Assy- Medium Gold S2400M (no glass) 846-915 Door Assy-Medium Black S2400M (no glass) 3) 846-302 Glass - Replacement - S2.
Regency Freestanding Woodstove 24 Part# Description 48) 020-915 Pedestal - Medium 49) 904-257 Large Magnet Catch 50) * Blanking Plate - Pedestal 850-100 Ashdrawer Kit - Pedestal 45) * Ashdrawer - Pede.
Regency Freestanding Woodstove 25 Part# Description 70) 902-1 1 1 Brick - Regular Full Size: 1-1/4" x 4-1/2" x 9" 74) 802-147 Brick Partial: 1-1/4" x 4-1/2" x 3-1/2" 75) .
Regency Freestanding Woodstove 26 NOTES.
Regency Freestanding Woodstove 27 W ARRANTY Regency Fireplace Products are designed with reliability and simplicity in mind. In addition, our internal Quality Assurance T eam carefully inspects each unit thoroughly before it leaves our door . Regency Industries Ltd.
Installer: Please complete the following information Dealer Name & Address: ______________________________________________ ___________________________________________________________________ Insta.
An important point after buying a device Regency S2400M (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Regency S2400M yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Regency S2400M - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Regency S2400M you will learn all the available features of the product, as well as information on its operation. The information that you get Regency S2400M will certainly help you make a decision on the purchase.
If you already are a holder of Regency S2400M, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Regency S2400M.
However, one of the most important roles played by the user manual is to help in solving problems with Regency S2400M. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Regency S2400M along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
