Instruction/ maintenance manual of the product F38-NG2 Regency
Go to page of 23
10/14/09 Freestanding Gas Stove FOR YOUR SAFETY What to do if you smell gas: Do not try to light any appli- ance Do not touch any electri- cal switch: do not use any phone in your building. Immediately call your gas supplier from a neighbour's phone.
2 Regency F38-2 Freestanding Gas Stove T o the New Owner: Congratulations! Y ou are the owner of a state-of-the-art Gas Stove by FIREPLACE PRODUCTS INTERNA TIONAL L TD. The Regency Gas Series of hand crafted appliances has been designed to provide you with all the warmth and charm of a woodstove, at the fl ick of a switch.
Regency F38-2 Freestanding Gas Heater 3 T ABLE OF CONTENTS SAFETY LABEL Safety Label................................................................... 5 INST ALLA TION General Information ....................................................... 5 Important .
4 Regency F38-2 Freestanding Gas Stove This is a copy of the label that accompanies each Freestanding Gas Stove. We have printed a copy of the contents here for your review . The safety label is located on the inside of the drop down pedestal door . NOTE: Regency units are constantly being improved.
Regency F38-2 Freestanding Gas Heater 5 INST ALLA TION GENERAL SAFETY INFORMA TION 1) The appliance shall be installed in accord- ance with the manufacturer's installation instructions, local gas.
6 Regency F38-2 Freestanding Gas Stove INST ALLA TION CLEARANCES T O COMBUSTIBLES The clearances listed below are MINIMUM distances. Measure the clearance to both the appliance and the chimney connector . (The farthest distance is correct if the two clear- ances do not coincide.
Regency F38-2 Freestanding Gas Heater 7 INST ALLA TION Flueing Requirements A100 mm diameter fl ue is required. For cosmetic or aesthetic purposes 6" outer fl ue can be used as long as an approved inner fl ue is installed. Fasten but do not penetrate the inner sleeve of the fl ue when tightening the screw .
8 Regency F38-2 Freestanding Gas Stove INST ALLA TION CONVERSION KIT# 731-968 FROM NG T O LPG THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !! 1) Shut off the gas supply . 2) Open the front door and carefully remove the logs and lava rock.
Regency F38-2 Freestanding Gas Heater 9 INST ALLA TION AERA TION ADJUSTMENT The burner aeration is factory set but may need adjusting due to either the local gas supply or altitude. F38-2 with 38 mj F38-NG2 NG: Full open F38-LPG2 LPG: 6.4 mm open Caution: Carbon will be produced if the air shutter is closed too much.
10 Regency F38-2 Freestanding Gas Stove Notch E)02-45 Bracket A)02-65 The bottom right edge of Log G)02-48 must sit snugly against the bracket Side V iew G)02-48 E)02-45 F)02-47 10) Position notch in Front Right Log G)02-48 on Log F)02-47 and push the bottom right edge against the bracket on the burner tray .
Regency F38-2 Freestanding Gas Heater 11 Note: If the fl ue is blocked or has a strong reverse fl ow , the thermally actuated safety switch mounted in the draft diverter will automatically shut off the gas supply within about 10 minutes. If the heater turns off be- cause of this during the spillage test, check for the cause of the lack of draft.
12 Regency F38-2 Freestanding Gas Stove OPTIONAL REMOTE CONTROL Use the Regency Remote Control Kit approved for this unit. Use of other systems may void your warranty . The remote control kit comes with a hand held transmitter , a receiver and a wall mounting plate.
Regency F38-2 Freestanding Gas Heater 13 WIRING CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation.
14 Regency F38-2 Freestanding Gas Stove OPERA TING INSTRUCTIONS 4) T urn the PILOT knob counterclockwise to pilot and align it with the arrow as shown in diagram 1. 5) Push in PILOT knob all the way in and hold. Immediately push IGNITOR button until pilot lights.
Regency F38-2 Freestanding Gas Heater 15 COPY OF THE LIGHTING PLA TE INSTRUCTIONS W ARNING: DO NOT SPRA Y AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IN OPERA TION. OPERA TING INSTRUCTIONS 1 ) Push in the gas control knob slightly and turn clockwise t o O FF.
16 Regency F38-2 Freestanding Gas Stove NORMAL OPERA TING SOUNDS OF GAS APPLIANCES It is possible that you will hear some sounds from your gas appliance. This is perfectly normal due to the fact that there are various gauges and types of steel used within your appliance.
Regency F38-2 Freestanding Gas Heater 17 MAINTENANCE CLOTHING OR OTHER FLAMMA- BLE MA TERIAL SHOULD NOT BE PLACED ON OR NEAR THE AP- PLIANCE. DO NOT USE THIS APPLIANCE IF ANY P ART HAS BEEN UNDER W A TER.
18 Regency F38-2 Freestanding Gas Stove MAINTENANCE F AN MAINTENANCE If your fan requires maintenance or replacement, access to the fan is through the access panel on the rear wall of the fi rebox.
Regency F38-2 Freestanding Gas Heater 19 4) Remove the two outside frame pieces by removing two screws per side. See diagram below . REMOVING V AL VE If your valve requires maintenance or replace- ment, follow these instructions: NOTE: Always shut off the gas supply before removing the valve.
20 Regency F38-2 Freestanding Gas Stove P ARTS LIST MAIN ASSEMBL Y 1) 560-920 T op/Bottom Gold Louvre (Set) 560-922 T op/Bottom Black Louvre (Set) 2) 750-532 Safety Screen (Australia only) 9) 750-040 .
Regency F38-2 Freestanding Gas Heater 21 BURNER & LOG ASSEMBL Y Part # Description P ARTS LIST 52) 910-190 Piezo Ignitor & Nut 54) 910-373 Knob - S.
22 Regency F38-2 Freestanding Gas Stove 101 111 107 208 111 105 WRAP DOOR DOOR ASSEMBL Y 730-933 Black W rap Door - Complete 101) 846-570 Door Gasket Kit 105) * Ceramic Paper 107) 936-243 Glass Gasket 1 1 1) * Door Frame Fibre Paper 208) 940-325/P Wrap Glass *Not available as a replacement part.
Regency F38-2 Freestanding Gas Heater 23 W ARRANTY Exclusions: This limited Lifetime W arranty does not extend to or include paint, door or glass gasketing or trim.
An important point after buying a device Regency F38-NG2 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Regency F38-NG2 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Regency F38-NG2 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Regency F38-NG2 you will learn all the available features of the product, as well as information on its operation. The information that you get Regency F38-NG2 will certainly help you make a decision on the purchase.
If you already are a holder of Regency F38-NG2, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Regency F38-NG2.
However, one of the most important roles played by the user manual is to help in solving problems with Regency F38-NG2. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Regency F38-NG2 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
