Instruction/ maintenance manual of the product EB7000 RedMax
Go to page of 28
The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. WARNING OWNER / OPERA T OR MANUAL BACKP ACK BLOWER T4012-93110 (005) EB7000 Thank you for purchasing a RedMax product.
Read this manual carefully to understand all safety precautions, controls, proper operation and maintenance of your RedMax blower . Failure to do so could result in serious injury .
CONTENTS SAFETY PRECAUTIONS·······························································4 OPERA T OR USE OF BLOWER FUEL WORKING CONDITI.
• Read this Blower Owner/Operator Manual carefully. Be sure you understand how to operate this unit properly before you use it. Failure to do so could result in serious injury. • Be sure to keep this manual handy so that you may refer to it later whenever any questions arise.
• To reduce the risk of injury associated with contacting rotating parts, stop the engine before installing or removing attachments. Do not operate without net in place . Always disconnect the spark plug before performing maintenance or accessing movable parts.
• Avoid using the blower where stable footing and balance are not assured. • Never to touch the spark plug or plug cord while the engine is in operation.
❲ 7 ❳ (1) Read owner's manual before operating this machine. (2) Wear head, eye and ear protection. (3) Handling this machine improperly could result in accidents causing serious injury or death. Read this manual carefully and practice using the blower until you are fully acquainted with all operations and have learned to use it correctly.
❲ 8 ❳ For safe operation and maintenance, symbols are carved in relief on the machine. According to these indications, please be careful not to take a mistake.
Parts Location & Specifications Assembly ■ BLOWER TUBES 1.Connect the blower and swivel joint with flexible hose. Clamp both ends of the flexible hose securely with the hardware supplied with the unit. 2.Align the protrusion and the groove provided on the tube ends and twist the tube until connection is locked up.
• Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 3m(10ft) away from the fueling point before starting the engine.
■ CONTROL ARM 1.Hold the upper end of the control arm in hand and, while pulling it away from the unit, rotate arm forward (anti-clockwise as the arrow direction) until it clicks. (The first position) And if you want, you can rotate arm more forward until it clicks.
Operation the choke if it was set closed, and let the engine run at idle speed for a minute to warm it up. • When the engine fails to start after several attempts due to overchoking, open the choke and repeat pulling the rope. ■ ADJUSTING IDLE SPEED • The idling speed is set for 2000 rpm at the factory.
■ FUEL FILTER • A clogged fuel filter may cause poor acceleration of the engine. Check periodically to see if the filter is clogged with dirt. The filter can be taken out of the fueling port using a small wire hook. Disconnect the filter assembly from the fuel pipe and unhook the retainer to disassemble it.
❲ 14 ❳ ■ MUFFLER • Inspect periodically, the muffler for loose fasteners, any damage or corrosion. If any sign of exhaust leakage is found, do not use the blower and have it repaired immediately. • Note that failing to do so may result in the engine catching on fire.
■ SHOULDER STRAP • If the shoulder strap is damaged it may break during use, thus causing the product to fall and resulting in personal injury. Follow the instructions below to replace the shoulder strap. • Pass the upper end of the strap through the hanger, making the FLAPPED SIDE OUTSIDE.
❲ 16 ❳ Storage BEFORE STORING THE BLOWER: 1.Drain a fuel tank and push the primer bulb until it becomes empty of fuel. 2.Remove the spark plug and drop a spoonful of 2-cycle oil into the cylider. Crank the engine several time and replace the plug.
❲ 17 ❳ Parts List NOTE : 1. Use KOMATSU ZENOAH genuine parts as specified in the parts list for repair and/or replacement. 2. KOMATSU ZENOAH does not warrant the machines, which have been damaged by the use of any parts other than those specified by the company.
EB7000 Fig.1 BLOWER GROUP (S/N 010001 and up) ❲ 18 ❳.
EB7000 Fig.1 BLOWER GROUP (S/N 010001 and up) Key# Part Number Description Q'ty 1 2750-31111 VOLUTE CASE 1 2 2750-31211 VOLUTE COVER 1 3 2750-31150 SCREW M5x25 9 4 3490-11150 ELBOW 1 5 07000-0209.
Parts List : EB7000 Fig.2 ENGINE GROUP (S/N 010001 and up) ❲ 20 ❳.
EB7000 Fig.2 ENGINE GROUP (S/N 010001 and up) Key# Part Number Description Q'ty 1 2750-12110 CYLINDER 1 2 2750-12210 GASKET, base 1 3 1850-12130 BOLT 4 4 1484-13160 INSULATOR 1 5 2750-13130 GASKE.
Parts List : EB7000 Fig.3 CARBURETOR COMPONENTS (S/N 010001 and up) Fig.3 CARBURETOR COMPONENTS (S/N 010001 and up) Key# Part Number Description Q'ty 1 5602-06030 REBAILT KIT 1 2 1850-81450 • B.
.
The California Air Resources Board and KOMATSU ZENOAH are pleased to explain the emission control system warranty on your 1995 and later small off-road engine. In California, new small off-road engines must be designed, built and equipped to meet the state’s stringent anti-smog standards.
EMISSION-RELATED PARTS, FOR TWO (2) YEARS FROM THE DATE OF ORIGINAL DELIVERY OF THE MODEL EB7000, UNIT, KOMATSU ZENOAH AMERICA INC. (THE COMPANY), THROUGH ANY RedMax DEALER, WILL REPAIR OR REPLACE, FREE OF CHARGE, FOR THE ORIGINAL AND EACH SUBSEQUENT PURCHASER, ANY PART OR PARTS FOUND TO BE DEFECTIVE IN MATERIAL AND/OR WORKMANSHIP.
Pièces en rapport avec les émissions de gaz d'échappement : KOMATSU ZENOAH AMERICA INC., par l'intermédiaire de n'importe quel revendeur RedMax, réparera gratuitement ou remplacera.
.
KOMA TSU ZENOAH AMERICA INC. 4344 Shackleford Road Suite 500 Norcross, Georgia 30093 .
An important point after buying a device RedMax EB7000 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought RedMax EB7000 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data RedMax EB7000 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, RedMax EB7000 you will learn all the available features of the product, as well as information on its operation. The information that you get RedMax EB7000 will certainly help you make a decision on the purchase.
If you already are a holder of RedMax EB7000, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime RedMax EB7000.
However, one of the most important roles played by the user manual is to help in solving problems with RedMax EB7000. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device RedMax EB7000 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
