Instruction/ maintenance manual of the product Gas Fired Boiler Raypak
Go to page of 8
USERS INFORMATION MANUAL FOR GAS FIRED BOILERS WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
Models with Motorized Modulation: H2, H6, W2 Sizes 2100-4001 are equipped with a single motorized modulating valve controlled by a temperature controller that offers full modulation down to 20% of rated input BTU.
S TART-UP PROCEDURE GENERAL Before lighting a new installation, water should be flowing through the heater. CAUTION: Propane gas is heavier than air and sinks to the ground. Exercise extreme care in lighting heater in confined areas. INITIAL START-UP – PUMP AND MOTOR Many pumps are now direct drive.
not push in or turn by hand, do not try to repair it, call a qualified service technician. Force or at- tempted repair may result in a fire or explosion.
technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water. LIGHTING INSTRUCTIONS 1. STOP! Read the safety information above. 2. Set the thermostat on the lowest setting. 3. Turn off all electric power to the appliance.
6 C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, do not try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion. D.
Observe pilot burner when shutting off pilot gas. Igni- tion spark should go on. Main gas valve will also drop out. High Limit Switch - to check high limit switch, turn dial setting down to a point slightly below the tempera- ture of the water leaving the boiler.
Raypak, Inc., 31111 Agoura Road, Westlake Village, CA 91361-4699 (818) 889-1500 FAX (818) 889-4522 Litho In U.S.A. www.raypak.com.
An important point after buying a device Raypak Gas Fired Boiler (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Raypak Gas Fired Boiler yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Raypak Gas Fired Boiler - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Raypak Gas Fired Boiler you will learn all the available features of the product, as well as information on its operation. The information that you get Raypak Gas Fired Boiler will certainly help you make a decision on the purchase.
If you already are a holder of Raypak Gas Fired Boiler, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Raypak Gas Fired Boiler.
However, one of the most important roles played by the user manual is to help in solving problems with Raypak Gas Fired Boiler. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Raypak Gas Fired Boiler along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
