Instruction/ maintenance manual of the product AMP200 AudioSource
Go to page of 6
Phoenix Gold International, Inc. 9300 North Decatur Street Portland, Oregon 97203 T el: 503.286.9300 F ax: 503.978.3381 T ech Support: 800.950.1449 W eb: www .
W ARNING CA UTION RISK OF ELECTRIC SHOCK DO NO T OPEN T O PREVENT FIRE OR SHOCK HAZARD , DO NO T USE THIS PL UG WITH AN EX TENSION C ORD , RECEPT ACLE OR O THER OUTLET UNLESS THE BLADES CAN BE FULL Y INSERTED TO PREVENT BLADE EXPOSURE. T O PREVENT FIRE OR SHOCK HAZARD , DO NO T EXPOSE THIS APPLIANCE T O RAIN OR MOISTURE.
Y ou should use a 3.5mm phone plug in the “IN” connector to make this connection. The tip of the connector is (+) positive , and the sleeve of the connector is (-) negative . A second terminal in the same block is labeled “OUT ” . This allows for remote turn-on of other devices when the AMP300 is po wered on.
Master Lev el Controls Each channel is able to control its v olume independently relative to the other channel. At the bottom left of the rear panel, there are 2 screwdriver adjustment knobs which correspond to the v olume level of the channel identified by a channel designator below it.
NO TE : Only one pair of channels can be bridged together . Do not attempt to bridge both A & B speaker terminals, as this may result in a low er impedance than the amplifier is designed to accommodate , and may damage your amplifier . The minimum impedance for the total load connected to a pair of channels in the bridged mode is 8-ohm.
6 Stereo Setup In this configuration, the mono switch is set to stereo f or stereo operation. Connect the line out jacks from a stereo preamplifier or source to the Line 2 input jacks of y our AMP200. Nex t connect your speakers to the terminals marked “SPEAKER A ” observing proper polarit y (see “Speaker T ermi- nals” Page 5).
An important point after buying a device AudioSource AMP200 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought AudioSource AMP200 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data AudioSource AMP200 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, AudioSource AMP200 you will learn all the available features of the product, as well as information on its operation. The information that you get AudioSource AMP200 will certainly help you make a decision on the purchase.
If you already are a holder of AudioSource AMP200, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime AudioSource AMP200.
However, one of the most important roles played by the user manual is to help in solving problems with AudioSource AMP200. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device AudioSource AMP200 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
