Instruction/ maintenance manual of the product Atlas II Quantum
Go to page of 8
Atlas II Jumper Settings 50-pin Jumper Settings Jumper Settings The following describes the jumper options and setting s available on the Maxtor® Atlas™ II disk drive. Maxtor Atlas II was developed by Quantum Corp oration prior to its merger with Maxtor.
Atlas II Jumper Settings Termination Power (TP) Enable termination power TP jumper on Disable term ination power TP jum per off SCSI ID (A3, A2, A1, A0) Set drive SCSI ID See ID settings table below D.
Atlas II Jumper Settings 28-Pin Secondary Option Connector Pin S ignal P in S ignal 1 A0 2 logic_gnd 3 A1 4 logic_gnd 5 A2 6 logic_gnd 7 Fault LED 8 key (blank) 9 Busy LED 1 0 Spindle Sync 11 +5VDC ou.
Atlas II Jumper Settings SCSI ID Settings The following table identifies the va rious SCSI ID values and the jumper positions required to set them. Drive ID A0 A1 A2 ID 0 OFF OFF OFF ID 1 ON OFF OFF I.
Atlas II Jumper Settings 68-pin Jumper Settings Jumper Settings The following describes the jumper option s and settings available on the Maxtor® At las™ II disk drive. Maxtor Atlas II was developed by Quantum Corporation pr ior to its merger with Maxtor.
Atlas II Jumper Settings 6 of 8 Stagger Spin Enable spin stagger SS jumper on Disable spin stagger SS jumper off Write Protect Enable Write Protection WP jumper on Disable W rite Protection WP jumper off Jumper Locations The Atlas II wide disk drive has two locations where user configurable jumpers ar e found.
Atlas II Jumper Settings 7 of 8 Pin Signal Pin Signal 1 A3 2 l ogic_gnd 3 A2 4 l ogic_gnd 5 A1 6 l ogic_gnd 7 A0 8 l ogic_gnd 9 Key (blank) 1 0 F ault LED 11 Delay Spin 1 2 l ogic_gnd 13 Logic ground .
Atlas II Jumper Settings Atlas II 9.1GB WD SCSI ID Settings The following table identifies the various SCSI ID values and the jumper positions required to set them.
An important point after buying a device Quantum Atlas II (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Quantum Atlas II yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Quantum Atlas II - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Quantum Atlas II you will learn all the available features of the product, as well as information on its operation. The information that you get Quantum Atlas II will certainly help you make a decision on the purchase.
If you already are a holder of Quantum Atlas II, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Quantum Atlas II.
However, one of the most important roles played by the user manual is to help in solving problems with Quantum Atlas II. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Quantum Atlas II along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
