Instruction/ maintenance manual of the product AS13N Audiobahn
Go to page of 14
AS SERIES DU AL CONE FULL-RANGE SPEAKERS AS13N / AS14N / AS24N / AS15N / AS16N OPERA TING INTSTRUCTIONS PLEASE RET AIN MANU AL FOR FUTRE USE AND REFERENCE QU ALITY , RLIABILITY , & PURE BLISS.
.
2 Getting Started----------------------------------------------------- Introduction---------------------------------------------------------- Features and Specifications-------------------------------.
.
Chrome Basket Black Carbon Injection Cone Butyl Rubber Surround 2 Layer High-T emp ASV V oice Coil 4 Ohm Impedance Mylar Whizzer T weeter Complete with Mounting Hardware AS13N: 3.5” 2-W ay AS14N: 4" 2-W ay AS15N: 5" 2-W ay AS24N: 4x6" 2-W ay AS16N: 6.
The picture below is a representation of the connection terminals on all the AS Series Dual Cone Speakers. The picture is shown as if you are looking at the speaker with the cone facing up towards the sky . Y ou will notice a large terminal on the left and a smaller terminal on the right.
It is always best to plan the complete installation prior to attempting to install any product. The routing of wires, power connections and mounting locations should be planned first. As with any car stereo installation, and all work performed should be checked thoroughly and carefully prior to the operation of the system.
Installation Note: Audiobahn strongly recommends that you operate your system at low volumes prior to the completed installation of your Audiobahn speakers. This will allow a test of the speaker before securing it to its permanent location. Caution: Make sure that all speaker wiring is fully protected from cuts, tears and possible wear .
Wiring Audiobahn recommends using at least 18-gauge wire with your new speaker system. Thinner gauge wire may easily be severed and can cause damage to your system should any bare wires come in contact with the vehicles chassis. Makes sure that your audio system is off while installing and connecting your new Audiobahn speakers.
Securing the Speaker Once you have tested your system and confirmed that it is operating properly , turn off your system and prepare for the final mounting of the speakers. 1) Position the speaker into the mounting hole and confirm the correct mounting location and hole placement.
10.
11.
12.
13.
An important point after buying a device Audiobahn AS13N (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Audiobahn AS13N yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Audiobahn AS13N - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Audiobahn AS13N you will learn all the available features of the product, as well as information on its operation. The information that you get Audiobahn AS13N will certainly help you make a decision on the purchase.
If you already are a holder of Audiobahn AS13N, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Audiobahn AS13N.
However, one of the most important roles played by the user manual is to help in solving problems with Audiobahn AS13N. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Audiobahn AS13N along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
