Instruction/ maintenance manual of the product PLD70BT PYLE Audio
Go to page of 40
Detachable Panel 7 Inch W ide Color T ouch Screen TFT Motorized Slide Down and Car DVD/MP4/V CD/CD/MP3 Play er Fr ont panel USB port and A UX input Built in AM/FM T uner and RDS Bluetooth A2DP & A.
Contents -1- Precautions ..................................... Safety Information......................... Disc Notes .................................... Installation .................................... Electric Connection ...................... Remote Control .
-2- Precautions THANK YOU FOR PURCHASING THIS CAR DVD PLA YER . Before operating the unit, read this manual thoroughly and keep it handy for future reference . T o avoid injury or accident , read the following precautions before installing and operating the unit .
-3- Safety Information REGION MANAGEMENT INFORMA TION: This DVD Player is designed and manufactured to respond to the Region Management Information that is recorded on a DVD disc. If the Region number described on the DVD disc does not correspond to the Region number of this DVD Player , this DVD Player cannot play this disc.
-4- Disc Notes Preparing New Discs with Spots Rough A new disc may have rough edges on i ts inside and outside edges. If a disc w it h rough edges is used, the proper s et ti ng will not be performed and the player will no t play the disc. Therefore, r em o v e th e rough edges in advance by using a ball point pen or pencil as shown on the right.
Installation -5- 1. Choose the mounting location where the unit will not interfere with the normal driving function of the driver . 2. Before finally installing the unit, connect the wiring temporarily and make sure all connected up properly and the unit and the system work properly .
Installation -6- Installation the unit 3. Remove the PLASTIC COVER of the both sides away 4. Insert the two KEY PLA T into the grooves at both sides of the unit as shown in figure until they click . PLASTIC COVER KEY PLA TE 5. Pulling the levers makes it possible to remove the unit from the dashboard .
-7- Installation How T o Remove And Install The Front Panel When detaching or attaching the control panel, be careful not to damage the connectors on the back of the control panel and on the panel holder . 2). Pull-off the front panel and keep the front panel into the case .
Panel Angle Adjustment -8- Caution: Do not insert your finger behind the control panel. When you want to change the viewing angle of the operating unit to play , you can touch the section on touch screen (or press the button on the front panel) repeatedly to select the desired angle as follows: ANGL E 1 - ANGLE 2 - ANGLE 3 - ANGEL 4 - ANGLE 1 .
Electric Connection WIRING CONNECTION -9- Note: the earth connection cable (parking brake B-) must be connected in order for DVD pictures to be played back to the monitor . If the cable has not been correctly connected, the message “P ARKING BRAKE” appears on the monitor .
Remote Control -10- 6 5 Button Ref # Function 1 2 Redial/ CLK Press it briefly to view the clock time , Press again to return to normal display mode . Press longer to set the time . PA I R / Press it to use the Bluetooth function , refer to the page 33 .
Remote Control -1 1- Button Ref # Function 8 9 GOTO Press it button to begin playback at a moment in the program you designate. Use number buttons to enter the data that is needed. In Bluetooth menu, it serves as the asterisk button on your mobile handset.
Remote Control -12- Using the Remote Control Face the remote control towards the player front face IR mark (remote control signal receiver). Operation angle: About 30 degree in each the direction of the front of the IR mark. Preparing the Remote Control 1.
Control Panel T ouch Panel Ke y F unc tions -13- T ouch Screen Ke y : MODE Operating mode selection MUTE ON T o switch of the sound Loading and ejecting the DVD/CD VOL UME- Decrease the volume level C.
-14- Unit Ke ys : Control Panel 1 A UX Input JACK For information about connecting a AUX device, please see page 25 . 2 IR SENSOR 3 VOL+/ VOL - KNOB In normal mode, this knob is used to increase or decrease the volume. It is also used as an UP/DOWN knob when audio or video settings are being adjusted when accessed using the SELECT button.
Control Panel -15- 9 (EJEC T ) BUT TON Press it button to eject the DISC or insert the DISC to start play . 11 SD/MMC CARD SL OT 8 SELECT BUT TON T o access the available adjustment settings for audio.
-16- Basic Operation Press it to switch the device ON, press and hold about 2 seconds to switch the device OFF . POWER On/Off Ejecting The Disc Use your finger to touch the range on touch screen , the control panel of the unit will swing downwards . Then you can insert the disc or eject the disc .
MODE SEL VOLUME+ VOLUME- MUTE ON TREBLE +02 FLA T DISC-IN 12: 18 touch to adjust touch to select -17- TFT Monitor Adjustment During DISC playback, use your finger to touch briefly the SEL section on t.
-18- Basic Operation Balance: Fader: R0 - 1 0t oL 0 - 1 0. Adjust sound balance between left and right speakers by using VOL + / - F0 1 0t oR0- 1 0. Adjust sound balance between front and rear speakers by using VOL + / VOL - . . - The button is to be activated for the following reasons: A.
Radio Operation -19- T ouch “ ” to next . T ouch “ ” to previous . When an FM ster eo broadcast is hard to rec eive T ouch the section on touch screen (or press button on the remote control ) to select the MONO or STEREO mode . (When Stereo mode is activated, the ST symbol will appear .
Radio Operation -20- MODE SEL VOLUME+ VOLUME- MUTE ON FM1 87.60 MHZ 12 3456 FLA T NO-DISC 12:06 DX ST TA T ouch to preset station Scan Function In Radio mode, briefly touch the section on the touch screen , the radio briefly plays all the APS preset stations of the frequency band .
AF AF FUNCTION (Alternativ e Fr equencies) AF is a function that works with the help of RDS (Radio Data System) and can only be used with FM stations . The radio searches in the background for the best frequency reception of the station that has been tuned into .
DVD 1-0:00:16 FLA T DISC-IN 12: 16 GOT O S-WOOFER DSP OSD T A AF CLK LUD RANDOM REPEA T INTRO MODE SEL VOLUME+ VOLUME- MUTE ON DVD 1-0:00:16 FLA T DISC-IN 12: 16 TITLE DVD 1-0:00:16 AUDIO Z OOM SUBTIT.
DVD 1-0:00:16 FLA T DISC-IN 12: 16 GOT O S-WOOFER DSP OSD T A AF CLK LUD RANDOM REPEA T INTRO DISC Operation -23- Subwoofer Function Use your finger touch the “ section on the screen to turn on the Subwoofer function, touch it again to cancel function .
DVD 1-0:00:16 FLA T DISC-IN 12: 16 GOT O S-WOOFER DSP OSD T A AF CLK LUD RANDOM REPEA T INTRO -24- DISC Operation NOTE : For MP3, the 3/INT button is not available. FOR CD : T ouch the screen of the section (or longer press the button on the remote control ) to play the previous 6 seconds part of each track/chapter on disc.
-25- DISC Operation A UX Operation o connect analogue replay devices. Use this jack to replay sound of other replay equipment such as DVD players, computers, etc. Via the loudspeakers. On the front panel of this unit, there is an AUX IN jack, follow the diagram below t 3).
-26- NOTE: For CD and MP3,the message will always display on the screen. SINGLE ELAPSED SINGLE REMAIN 3.Example for MP3: Each time is pressed or touch , the message displayed on screen changes as follows: OSD E.T ouch or Press for the fifth time: The message on the screen will be cleared for SVCD and VCD.
TITLE DVD 1-0:00:16 AUDIO Z OOM SUBTITLE FLA T DISC-IN 12: 16 SETUP P AIR DIAL REDIAL MONO LEFT MONO RIGHT STEREO MIX-MONO For VCD/CD: AUDIO AUDIO during playback, touch the section of the touch screen or Press on the remote . It is possible to switch the sound between monaural and stereo sound.
SETUP -28- 1.TV DISPLA Y SETUP This is to select the appropriate TV aspect (4:3 or 16:9) according to the connected TV set. Played back in the P AN & SCAN style. (If connected to wide-screen TV , the left and right edges are cut off.) Played back in letterbox style.
3 .OSD LANG TYPE SETUP Select the preferred OSD language by using the / buttons. -29- 5.CAPTIONS SETUP Activate the CAPTIONS feature by selecting ON. And release this feat- ure by selecting OFF .
-30- 6.SCR SA VER SETUP Select the SCR SA VER output ON/OFF . 7.LAST MEMORY SETUP Select the LAST MEMOR Y output ON/OFF . SPEAKER SETUP --- SPEAKER SETUP P AGE --- This is to activate the audio output from DOLBY AC3 5.1 DOWNMIX to 2 channel mode. Select the preferred SPEAKER connection by using the cursor buttons.
--- PREFERENCES P AGE --- -31- PREFERENCES SETUP 1.TV TYPE SETUP This player can play discs recorded in either P AL or NTSC format.Select NTSC format, when you connected to NTSC TV .Select P AL format, when you connected to P AL TV .Select AUTO format, the player TV output format will according to the DVD disc format.
-32- 5.P ARENT AL Select suitable parental guidance by the cursor buttons and conformed by pressing ENTER button. 6.P ASSWORD Select the change and press ENTER button. T ype the old password (The initial factory code is ) and key in 4 characters password now you want to use, and retype again to confirm key in correctly .
TITLE DVD 1-0:00:16 AUDIO Z OOM SUBTITLE FLA T DISC-IN 12: 16 SETUP P AIR DIAL REDIAL Bluetooth Operation Bluetooth Car Kit User Manual -33- 1). Place the Car Kit and mobile handset in 3 meters apart. 3). Set your bluetooth phone to “ discov er” the Car Kit .
During conversation in progress, tune the V olume switch until you reach the desired volume level. Adjust the Volume 1). Before using the function of the Blue- tooth about the unit , please check your phone’s instruction guide or contact phone manufacture if you are not sure if your phone supports the hands-free Bluetooth function .
Other Main Operation Important Note: T o prevent damage to the USB device, do not remove or disconnect it during playback. it is also a good practice to remove the USB drive during disc playback.
Other Main Operation Inserting and removing a SD or MMC card on the front panel of unit . SD/MMC card OPERA TION Mode change to SD/MMC card After a SD or MMC card was inserted into the main unit card slot . the unit will starts playing the files contained on the memory card .
Other Main Operation 00:56 04:07 003/1 12 Repeat one Mp3 Mp3 Mp3 ....... ....... K P woman 1 new ton 1 2 3 4 56 1 Current track(file)(highlighted bar) 2 Elapsed playing time of the current track( 4 total playing time. 5 Operation mode icon. (Play), (stop), (pause), (forward) (reverse).
Specification -38- TFT Monitor: Monitor Screen Size: 7 Inch Wide Number of Pixels: 480 X RGB X 234 pixels Color System: NTSC/P AL NO TE: Specifications and design are subject to modification, without notice, due to improvements in technology .
8880-J9000-04S Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer . T rouble Shooting -39- Inserting the disc in reverse direction Press the RESET button.
An important point after buying a device PYLE Audio PLD70BT (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought PYLE Audio PLD70BT yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data PYLE Audio PLD70BT - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, PYLE Audio PLD70BT you will learn all the available features of the product, as well as information on its operation. The information that you get PYLE Audio PLD70BT will certainly help you make a decision on the purchase.
If you already are a holder of PYLE Audio PLD70BT, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime PYLE Audio PLD70BT.
However, one of the most important roles played by the user manual is to help in solving problems with PYLE Audio PLD70BT. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device PYLE Audio PLD70BT along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
