Instruction/ maintenance manual of the product XAP series Proview
Go to page of 32
User ' s Guide X A 7 - 1 9 i L C D M o n i t o r XA7-17i X E R O X X A P U s e r ' s G u i d e 1. 4 20 05 /0 8/ 29 GA 98 0i K XE RO X XL -7 95 iK AS D RAWI NG 1 1 29 0( W) X2 10 (H )TO L: 0~ +2 0 (i nc h) P A N T O N E P r o c e s s B l a c k C V P A N T O N E R e d 0 3 2 C V X A 7 - 1 9 i XA P S er i es 2 1 0 .
©2005 by Xerox Corporation. All rights reserved. Copyright protection claimed includes all forms and matters of copyrightable material and information now allowed by statutory judicial law or hereina.
2 Xerox© LCD Monitor User ’ s Manual T able of Contents CE Marking Declaration Of Conformity ................................................. 4 Federal Communications Commission (FCC) Statement .................... 5 Important Safety Instructions .
RECYCLING PLACE ENGLISH 3 Xerox© LCD Monitor User ’ s Manual Recycling Place EUROPE When disposing of Proview products in Europe, please contact one of the following three locations to make arrangements for recycling.
FCC/CE 4 Xerox© LCD Monitor User ’ s Manual CE Marking Declaration Of Conformity This LCD monitor complies with the requirements of the EC Directive 89/336/EEC “EMC Directive” and 73/23/EEC “Low V oltage Directive” as amended by Directive 93/68/EEC.
FCC/CE ENGLISH 5 Xerox© LCD Monitor User ’ s Manual This equipment has been tested and found to comply with the limits of a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Important Safety Instructions 6 Xerox© LCD Monitor User ’ s Manual T o prevent any injuries, the following safety precautions should be observed in the installation, use, servicing and maintenance of this equipment. Before operating this equipment, please read this manual completely , and keep it nearby for future reference.
Important Safety Instructions ENGLISH 7 Xerox© LCD Monitor User ’ s Manual • Do not touch the power cord and antenna cable during lightning. • Remove the plug from the wall outlet if the equipment will not be used for a long period of time. • Do not place, use or handle this equipment near water .
Important Safety Instructions 8 Xerox© LCD Monitor User ’ s Manual • If any of the following conditions occur , unplug the power cord from the outlet and request service from qualified personnel. a. The power cord or plug is damaged. b. Liquid is spilled into the product .
9 Xerox© LCD Monitor User ’ s Manual Introduction ENGLISH • Rapid Video Response Fast action media such as gaming, DVD and video conferencing will playback smoothly thanks to the rapid video 8ms response time of the LCD panel. • Adjustable Ergonomic Xstand This stand is versatile for users to make any adjustment comfortable for use.
10 Xerox© LCD Monitor User ’ s Manual Introduction Make sure all of the following contents are included in the box. If any items are missing, please return this product to the original place of purchase. CAUTION: Be sure to save original box and all packing material for future transport of monitor .
1 1 Xerox© LCD Monitor User ’ s Manual Introduction ENGLISH Front View and Controls MENU Press once to display the OSD (On Screen Display). And press to activate the items you highlight . DOWN/UP In OSD mode, press the DOWN/UP buttons to move the selection highlight to the next menu item counterclockwise or clockwise, respectively .
Installation 12 Xerox© LCD Monitor User ’ s Manual 1 T urn off the computer and unplug the power cable. 2 Fit the DVI-I to D-SUB adapter onto the signal cable of the LCD monitor . 3 Connect the signal cable to the D-SUB port on the back of the computer .
Installation ENGLISH 13 Xerox© LCD Monitor User ’ s Manual Connect to power source 5 5 Connect the power cord to wall outlet and LCD monitor . 6 Press the POWER button, located on the bottom side of the main unit to turn the monitor on, then turn the computer on.
Installation 14 Xerox© LCD Monitor User ’ s Manual 3 Method 2: Digital (DVI) Connection 1 T urn off the computer and unplug the power cable. 2 Connect the signal cable (DVI-I) to the DVI port on the back of the computer . 3 Connect the audio cable to the line-in port on the back of the computer .
Installation ENGLISH 15 Xerox© LCD Monitor User ’ s Manual If the screen displays “out of range”, please follow the instructions below to set up: • Press the MENU button to display the OSD. • Press the UP or DOWN button to highlight the (I NPUT SELECT ) icon, then press the MENU button.
Installation 16 Xerox© LCD Monitor User ’ s Manual Using Y our LCD Monitor In order to ensure a healthy and relaxed body position when using the monitor at visual display workstations, you are able to adjust the monitor ’s angle or height of the stand.
Installation ENGLISH 17 Xerox© LCD Monitor User ’ s Manual NOTE: If you find that your display card driver does not offer this feature, you can purchase aftermarket rotation software from manufacturers such as Portrait Displays. This monitor manufacturer provides no warranty with respect to the use of aftermarket display software.
Installation 18 Xerox© LCD Monitor User ’ s Manual 3 The height of the LCD monitor ’ s stand may be adjusted approximately 12cm. Be sure to follow the sequence described below .
Installation ENGLISH 19 Xerox© LCD Monitor User ’ s Manual 4 Use one hand to change the monitor ’ s swivel angle . The swivel angle of the LCD monitor may be adjusted approximately 60 degrees.
Installation 20 Xerox© LCD Monitor User ’ s Manual If you wish to lock the LCD monitor on a wall, carefully follow the instructions below . Installing the W all Mount (optional) to Y our LCD Monitor NOTE: For instructions on wall-mount installation, please refer to the installation guide provided by the wall-mount kit vendor .
OSD Menu ENGLISH 21 Xerox© LCD Monitor User ’ s Manual T o create the best picture, your XAP series has been preset at the factory with the Preset Mode T iming shown on page 25. The OSD (On Screen Display) Menu allows the user to adjust various settings and options by following the steps below .
OSD Menu 22 Xerox© LCD Monitor User ’ s Manual The OSD menu includes the following options: O BRIGHTNESS Controls the overall brightness. CONTRAST Controls the difference between the brightest and darkest regions of the picture. H. POSITION Adjusts the position of the picture left and right in the window .
OSD Menu ENGLISH 23 Xerox© LCD Monitor User ’ s Manual INPUT SELECT Allows selection of ANALOG INPUT or DIGIT AL INPUT depending on the type of input signal currently in use. RESET Restores all options to the factory settings. LANGUAGE Co nt ro ls whic h la ngua ge i s us ed on all the on- sc re en m en us.
OSD Menu 24 Xerox© LCD Monitor User ’ s Manual EXIT Exits the OSD. OSD Changes the position of the OSD. H. POSITION Moves the OSD left and right in the window .
T echnical Information ENGLISH 25 Xerox© LCD Monitor User ’ s Manual The screen image has been optimized during manufacture for the display modes listed below . Video signal: (IBM PC/A T) Dot X Li ne Ho riz ont al Frequ ency (kH z) V er t ica l Frequ ency (H z) 720 x 400 31.
T echnical Information 26 Xerox© LCD Monitor User ’ s Manual PIN D ESCRIP TIO N PIN DESCR IPT ION 1 TMDS Data 2- 15 GND 2 TMDS Data 2+ 16 Hot Plug Detect 3 TMDS Data 2/4 shield 17 TMDS Data 0- 4 18.
T echnical Information ENGLISH 27 Xerox© LCD Monitor User ’ s Manual PI N DE SC RI P TIO N 1 Red 2 Green 3 Blue 4 Ground 5 Self T est 6 Red Ground 7 Green Ground 8 Blue Ground 9 5 VDC 10 Ground 1 1 Ground 12 SDA (FOR DDC) 13 H.
T echnical Information 28 Xerox© LCD Monitor User ’ s Manual Permanently unlit or lit pixels The standard of production techniques today cannot guarantee an absolutely fault free LCD display . A few isolated permanently lit or unlit pixels may be present.
T echnical Information ENGLISH 29 Xerox© LCD Monitor User ’ s Manual Before consulting service personnel, check the following chart for a possible cause and solution to the trouble you are experiencing. Monitor will not turn on • Make sure the power cord is plugged in.
T echnical Information 30 Xerox© LCD Monitor User ’ s Manual Specifications MODEL XAP-172i X XAP-192i LCD Panel Panel Size 17’ TFT LCD 19” TFT LCD Brightness 300 300 Contrast Ratio 500:1 500:1 Dot Pitch 0.264mm x 0.264mm 0.294mm x 0.294mm Max.
T echnical Information ENGLISH 31 Xerox© LCD Monitor User ’ s Manual U.S.A. CALIFORNIA: AUTHORIZED SERVICE CENTER 7373 HUNT A VENUE GARDEN GROVE, CA 92841 (714) 799-3899 (800) 469-1 175 (714) 379-6.
An important point after buying a device Proview XAP series (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Proview XAP series yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Proview XAP series - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Proview XAP series you will learn all the available features of the product, as well as information on its operation. The information that you get Proview XAP series will certainly help you make a decision on the purchase.
If you already are a holder of Proview XAP series, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Proview XAP series.
However, one of the most important roles played by the user manual is to help in solving problems with Proview XAP series. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Proview XAP series along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
