Instruction/ maintenance manual of the product PWM-F110 Premier Mounts
Go to page of 18
INSTALLATION MANUAL PWM-F110 Premier Mounts 3130 E. Miraloma Avenue Anaheim, CA 92806 Phone: (800) 368-9700 Fax: (800) 832-4888 mounts@mounts.com www.mounts.
PBL-110 Projector Mount Page - 2 - Installation Manual.
PWM-F110 Installation Manual Page - 3 - Table of Contents Warning Statements ............................................................................................................ ............................... - 4 - Parts List ................
PWM-F110 Page - 4 - Installation Manual Warning Statements Safety Precautions This wall mount should be installed by qu al ified personnel having suffici ent skill and competence to install it.
PWM-F110 Installation Manual Page - 5 - Mount Overview This PWM-F110 Plasma Wall Mount may be sold as part of a system or as an i ndepe ndent component.
PWM-F110 Page - 6 - Installation Manual Parts List NOTE: This wall mount is shipped with all proper ins tallation hardware and components. Make sure that none of these parts are missing an d/or damaged be fore beginning installation.
PWM-F110 Installation Manual Page - 7 - Mounting Bracket Installation NOTE : Proper installation procedure by qualified personnel as outlined in the install ation instructions must be adhered to. Failure to do so could result in serious personal injury an d possible damage to the flat panel.
PWM-F110 Page - 8 - Installation Manual 3. If needed, install the nylon spacers to the mounting points on the flat panel (Figure 3). 4. Lay the left and right mounting brackets (stamped arrows facing out) - (Figure 4). Figure 3 Figure 4 5. Match the center of viewing guide with th e centerline you marked in step 1 (Figure 5).
PWM-F110 Installation Manual Page - 9 - C L Figure 5 Figure 6 7. The Griplates™ have M4, M5, M6 and M8 hole p atterns to fit the hardware that your flat panel requires. EXAMPLE : If your flat panel uses M8 x 20 Phillip screws, use the M8 mountin g points (Figure 7).
PWM-F110 Page - 10 - Installation Manual Wall Stud Location 1. Using a (commercially available) wood stud finder, locate four 16" or 24" stud centers behind the wall. Once found, make a pencil marking on the center of the wood studs (Figure 9).
PWM-F110 Page - 11 - Installation Manual 3. To connect the two wall plates, lay them on a flat su rface, end to end. Make sure that the holes line up (Figure 11). 4. Insert two (2) M8 x 16mm Hex Head bolts throu gh the two holes and secure with two (2) M8 Hex nuts (Figure 11).
PWM-F110 Installation Manual Page - 12 - 7. Level and se cure the plate to the wall with the reference arrow facing up to the ceiling. 8. Secure the p late using the eight (8) 5/16" lag bolts and flat washers (supplied) – (Figure 13). CAUTION : Do not over tighten the lag bolts.
PWM-F110 Page - 13 - Installation Manual 9. Level and se cure the plate to the wall with the reference arrow facing up to the ceiling. 10. Use a minimum diameter of 5/16” x 2 ¼” large co ncrete wedge anchors (commercially available) – (Figure 14).
PWM-F110 Installation Manual Page - 14 - Installing the Flat Panel Display WARNING : AT LEAST (2) QUALIFIED PERSONNEL ARE STRONGLY RECOMMENDED FOR INSTALLATION OF THIS PRODUCT. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY AND POSSIBLE DAMAGE TO THE FLAT PANEL.
PWM-F110 Page - 15 - Installation Manual 2. Make any lateral shift adjustment and lock it by tightening the two (2) ¼”-20 Phillips screws f ound on the bottom of the mounting brackets. Use the wall bumper to adjust your flat panel. CAUTION : Do not over tighten the ¼”-20 screws to the rods (Figure 16).
PWM-F110 Installation Manual Page 19 Technical Specifications 16 . 0 0 0 ( 406 .4) 16 . 0 0 0 ( 406 .4) 1.9 43 (4 9 .3 ) 5.0 00 ( 127) 28 .00 0 ( 171 .2) C L 3.5 00 (88 .9) C L 5. 000 ( 127) 16 .0 00 ( 406 .4) 24 .29 0 ( 616 .97) 16 .00 0 ( 406 .4) 21 .
PWM-F110 Page 20 Installation Manual Warranty Limited Lifetime Warranty All Premier Mounts products carry a limit ed lifetime warranty from ship date against defects in materials and workmanship. Premier Mounts is not liable for imprope r installation that result s in damage to mounts, adapters, display equipment or personal injury.
PWM-F110 Installation Manual Page - 18 - Notes Premier Mounts 3130 E. Miraloma Avenue Anaheim, CA 92806 Phone: (800) 368-9700 Fax: (800) 832-4888 mounts@mounts.
An important point after buying a device Premier Mounts PWM-F110 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Premier Mounts PWM-F110 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Premier Mounts PWM-F110 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Premier Mounts PWM-F110 you will learn all the available features of the product, as well as information on its operation. The information that you get Premier Mounts PWM-F110 will certainly help you make a decision on the purchase.
If you already are a holder of Premier Mounts PWM-F110, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Premier Mounts PWM-F110.
However, one of the most important roles played by the user manual is to help in solving problems with Premier Mounts PWM-F110. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Premier Mounts PWM-F110 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
