Instruction/ maintenance manual of the product PTID-6250B Power Acoustik
Go to page of 25
PTID-6250B In-Dash 6.2” Monitor Touch Screen DVD/CD/MP3/MP4 AM/FM Radio With Bluetooth Owner’s Manual Take the time to read through this owner’s manual. Familiarity with installation and operation procedures wi ll help you obtain the best Performance from your new DVD-receiver.
2 WARNING! To promote safety, certain functions are disabl ed unless the parking brake is on. The Unit is designed to detect parked status and must be connected to the power supply side of the parking brake switch. Improper connection or use of his connection may violate applicable law and may result in serious injury or damage.
3 CONTENTS WARNING ! ................................................................................................................. 2 OPERATION PREC AUTIONS .................................................................................... 2 CONTENTS .
4 Accessories Package contains the following accessories for installation and operation of the unit. (1) Washer, Spring Washer, M5 Nut 1 each (2) Mounting Strap 1 (3) Bolt 1 (4) Screw 5*20 1 (5) Scre.
5 INSTALLATION Note Before starting installation of the unit, make sure the wiring is connected properly. Use only the parts provided with the unit to ensure proper installation.
6 WIRING CONNECTIONS NOTE: Never connect cable to the system while it is connected to the battery power. Whenever the unit is disconnected from the battery, the preset memory will be erased and the unit will go back to its factory defaults. Note: To watch video the parking wire should be c onnected to break signal.
7 Note: - Only use groundless loud spea kers. - Use only loudspeakers of minimal 40Watt, using fewe r watts may result in damaging your loudspeakers at higher volumes. - Use 4~8 (Ohm impedance) loud sp eakers only; using hi gher or lesser impedance may damage the unit .
8 Front panel 1 . EJECT Button Press it to eject a disc. If t he disc is not removed for about 10 se conds after eject, the disc is reinserted automatically. 2. IR Sensor IR Remote control signal receiving window. Max distance is 6-8 meters, 45 angels.
9 USB slot, for Multimedia playback files only. Inse rt a USB into this slot and the unit will automatically start reading and playback the card. * Supported Music File Format: MP3, WMA Files 9. RESET Button Press it with a thin, sharp objec t. The device will then be reset to factory default settings.
10 6. EJECT button Press it to eject the disc. 7.STEREO/MONO/* Press STEREO button to se lect STEREO or MONO. In BLUETOOTH mode, press it to make a * symbol. 8.P.SCN/ RPT /# In SD CARD/ USB mode, press to repeat REP 1 => REP DIR => REP ALL In DVD mode, press to start repeat REP OFF=>REP Chapter=>REP Title=>REP Off.
11 In BLUETOOTH mode, press to reject a coming call or hang up while calling 21. VOL+ button Press to increase volume level. 22. A-B/ZOOM button During playback, press it at the starting point of section you want to repeat(A), press this button again at the ending point of the se ction you want to repeat (B), section A-B repeating starts.
12 28. OPEN/TILT button: (O ption without function) REMOVE BATTERY Note: The distance may vary according to the brightness of ambient light. If the remote is not used for an extended period of time, remove the battery to prevent possible damage from battery leakage and corrosion.
13 MAIN MENU The best way to discover the program is to explor e each screen in detail, and to find out how to move from one to another. Read th is chapter for a guided tour. Unit starts by displaying the Main menu. This is the root of t he screen hierarchy, and you can simply a cces s all features by tapping on the touch screen buttons.
14 Touch this button to select stereo or mono s ound reception. Touch this button to select reception of local station or DX fo r distance station. ◆ DVD PLAYER To start DVD Player, tap on DVD button from main menu screen. TOUCH SCREEN MEN U You will not see any buttons while DVD is played.
15 In VCD mode touch it can choose PBC ON or OFF. In DVD mode touch it to enter TITLE MENU (Enable only if the DVD disc with title menu). ◆ Insert USB/SD/MMC and play tr ack will display as follows: mute the sound volume button. press to decrease the volume, press to increase the volume.
16 ◆ AV-IN Mode To start AV-IN Mode, tap on AV-IN button from main menu screen. Note: If there is no ex ternal video input, the TFT displays “NO VID EO SIGNAL” Press the icon to be back to main menu. ◆ SETTING CONTROL Your device has default system se ttings.
17 RADIO CONTROL Tap RADIO button from setting menu screen. GENERAL CONTROL Tap GENERAL button from setting menu screen. Tap Down button from setting GENERAL 1 screen. SCREEN Screen setting 16:9, 4:3 ， FULL Backlight Backlight se tting LOW, MID, HIGH AREA Set AREA:EUROPE-U.
18 DVD SET UP MENU Tap the DVD button in main menu to enter the DVD player. Press the SETUP button to enter into the system settings main menu; press t he up or down arrow buttons to move to the highlighted menu item and select one of the Setup Pages: [1].
19 [6] TV SHAPE: Set TFT screen mode to the correct ratio: Three screen ratio modes are availa ble, Normal/PS (4:3 Pan Scan), Normal/LB (4:3 Letterbox) and Wide (16:9). Different disc formats will display different images depending this setting and the screen size used.
20 BLUETOOTH SECTION Warning: Driving and having a Telephone conversation at the same time is dangerous, please park your car before having a telephone conversation.
21 Voice Transfer During a call, you can change a call from Bluet ooth mode to phone by tapping Transfer button. To have a call in Bluetooth mode again, tap Transfer button. NOTE: the phonebook only supports Western Characters. Any difference in character will be shown such as “ + , * or # ”.
22 NOTES ON DISC Only use groundless loudspeaker s. Use only loudspeaker s of minimal 40Watt, usi ng fewer watts may resu lt in damaging your loud speakers at higher volumes. Use 4~8 (Ohm impedance) loudspeakers only; using higher or lesser impedance may damage the unit.
23 TROUBLESHOOTING Symptom Cause Remedy Fuse is blown Replace with fuse of the same amperage. If the fuse blows again, consult your store of purchase Power does not turn on. (No sound is produced.) In correct wiring Consult your local retailer. No sound output when operating the unit with amplifiers or power antenna attached.
24 TROUBLESHOOTING SYMPTOM CAUSE SOLUTION THE CAR IGNITION IS NOT ON. IF THE POWER SUPPL Y IS PROPERLY CONNECTED TO THE CAR ACCESSORY SWITCH THE IGNITION KEY TO “ACC”. NO POWER THE FUSE IS BLOWN. REPLACE THE FUSE. DISC CANNOT BE LOADED. PRESENCE OF DISC INSIDE THE PLAYER REMOVE THE DISC IN THE PLAYER THEN PUT A NEW UPWA RD.
25 TECHNICAL SPECIFICATIONS General Power supply: 11~16V DC Current consumption: max. 10 A Maximum power output: 52W x 4 channels (max) Compatible formats: DVD/SVCD/VCD/HDCD/MP3/MP 4/VIDEO/CDDA/Pictur.
An important point after buying a device Power Acoustik PTID-6250B (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Power Acoustik PTID-6250B yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Power Acoustik PTID-6250B - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Power Acoustik PTID-6250B you will learn all the available features of the product, as well as information on its operation. The information that you get Power Acoustik PTID-6250B will certainly help you make a decision on the purchase.
If you already are a holder of Power Acoustik PTID-6250B, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Power Acoustik PTID-6250B.
However, one of the most important roles played by the user manual is to help in solving problems with Power Acoustik PTID-6250B. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Power Acoustik PTID-6250B along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
