Instruction/ maintenance manual of the product A07513-0412-0 Porter-Cable
Go to page of 18
Instruction manual IMPORT ANT Please make certain that the person who is to use this equipment carefully reads and understands these instructions before starting operations. Part No. A07513 -0412-0 ® ESP AÑOL: PÁGINA 17 FRANÇAIS: P AGE 34 T o learn more about Porter-Cable visit our website at: http://www .
2- ENG A07513 IMPORT ANT SAFETY INSTRUCTIONS Do not operate this unit until you have read and understand this Operators Manual and the Engine Owners Manual for Safety , Operation, and Maintenance Instructions.
3- ENG A07513 • Materials placed against or near the pressur e washer can interfere with its proper ventilation features causing overheating and possible ignition of the materials. • Never operate pressur e washer in an area containing dry brush or weeds.
4- ENG A07513 • Contact with hot surfaces, such as engines exhaust components, could result in serious burn. • During operation, touch only the control surfaces of the pressur e washer . Keep children away fr om the pressure washer at all times. They may not be able to recognize the hazar ds of this product.
5- ENG A07513 • Reactive force of spray will cause gun/ wand to kickback, and could cause the op- erator to slip or fall, or misdirect the spray . Improper contr ol of gun/wand can result in injuries to self and others. • Do not overreach or stand on an unstable support.
6- ENG A07513 ASSEMBL Y INSTRUCTIONS 3. Connect wand to gun. Tighten securely . 2. Attach high pr essure hose to gun. Tighten secur ely . 1. Pl ace hand le asse mbl y on to f ram e, de pre ss the snap bu tton s, a nd sl ide the han dle ass embl y on to the fr ame unti l s nap but tons sna p i nto place.
7- ENG A07513 OPERA TING INSTRUCTIONS BASIC ELEMENTS OF A PRESSURE WASHER High Pressur e Pump : Increases the pressur e of the water supply . Engine: Drives the high pressur e pump. High Pressur e Hose: Carries the pressurized water fr om the pump to the gun and spray wand.
8- ENG A07513 PRESSURE WASHER TERMINOLOGY PSI: Pounds per Square Inch. The unit of measure for water pr essure. Also used for air pressur e, hydraulic pressur e, etc. GPM: Gallons Per Minute. The unit of measure for the flow rate of water . CU: Cleaning Units.
9- ENG A07513 The high pressur e spray from your pressur e washer is capable of causing damage to surfaces such as wood, glass, automobile paint, auto striping and trim, and delicate objects such as flowers and shrubs.
10- ENG A07513 HOW TO APPL Y CHEMICALS AND CLEANING SOL VENTS Applying chemicals or cleaning solvents is a low pressur e operation. NOTE: Use only soaps and chemicals designed for pressur e washer use. Do not use bleach. T o Apply chemicals: 1. Press chemical hose onto barbed fitting located near high pressur e hose connection of pump as shown.
11- ENG A07513 8. Start engine. See Engine Owners Manual for correct procedur e. NOTE: When engine rope is pulled, pr essure starts building in the gun. If the engine does not start after two pulls, pull the gun trigger to relieve this pressur e. 9. Depress trigger on gun to start water flow .
12- ENG A07513 MAINTENANCE When performing maintenance, you may be exposed to hot surfaces, water pressur e, or moving parts that can cause serious injury or death! Before performing any maintenance or repair , disconnect spark plug wire, let engine cool and r elease all water pressur e.
13- ENG A07513 HOW TO CLEAN THE WA TER INLET FIL TER This screen filter should be checked periodically and cleaned if necessary . 1. Remove filter by grasping end and removing it fr om water inlet of pump as shown. 2. Clean filter by flushing it with water on both sides.
14- ENG A07513 1. Obtain a funnel, six ounces of *RV antifr eeze, and 16 - 36 inches of garden hose with a male hose connector attached to one end. Use only RV antifreeze. Any other antifreeze is corr osive and can damage pump. 2. Disconnect spark plug wire.
15- ENG A07513 TROUBLE SHOOTING GUIDE PROBLEM Engine will not start (see Engine Manual for further engine troubleshooting) No or low pressur e (initial use) CAUSE CORRECTION No fuel. Add Fuel. Pressur e builds up after two pulls on the recoil starter or after initial use.
16- ENG A07513 W ater leaking at pump W ater leaking at gun/ spray wand connection No or low pressur e (after period of normal use) PROBLEM CAUSE CORRECTION Spray wand not in low pressure. See How to Use Spray W and paragraph in the Operation Section.
17- ENG A07513 NOTES.
18- ENG A07513 LIMITED W ARRANTY PORTER-CABLE CORPORA TION warrants to the original purchaser that all products covered under this warranty are free from defects in material and workmanship.
An important point after buying a device Porter-Cable A07513-0412-0 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Porter-Cable A07513-0412-0 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Porter-Cable A07513-0412-0 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Porter-Cable A07513-0412-0 you will learn all the available features of the product, as well as information on its operation. The information that you get Porter-Cable A07513-0412-0 will certainly help you make a decision on the purchase.
If you already are a holder of Porter-Cable A07513-0412-0, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Porter-Cable A07513-0412-0.
However, one of the most important roles played by the user manual is to help in solving problems with Porter-Cable A07513-0412-0. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Porter-Cable A07513-0412-0 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
