Instruction/ maintenance manual of the product PT1545R Planar
Go to page of 30
PT1545R / PT1545P T ouch Screen Monitor USER’S GUIDE www .planar .com.
The information contained in this document is subject to change without notice. This document contains proprietary information that is protected by copyright.
T able of Contents Usage Notice Precautions ............................................................................................................................ 1 Introduction About PT1545R/PT1545P .............................................
Usage Notice ! W arning - T o prevent the risk of re or shock hazards, do not expose this product to rain or moisture. ! W arning - Please do not open or disassemble the product as this may cause electric shock. Precautions Follow all warnings, precautions and maintenance as recommended in this user ’s manual to maximize the life of your unit.
Introduction About PT1545R/PT1545P The PT1545R/PT1545P is a 15" at panel screen with an active matrix, thin-lm transistor (TFT) liquid crystal display (LCD).
T ouch Screen for PT1545R • 5-wire resistive touch screen for nger and stylus input • Surface: Anti-glare treatment • Interface: Dual RS-232 Serial/USB controller • T ransmittance: 82%±5% • HID: Windows® 7/8 • Driver: Windows® 7/8, VIST A, XP , 2000, ME, 98, NT 4.
4 Package Overview LCD Display Power Cord VGA Signal Cable RS-232 Cable (PT1545R only) USB Cable ( A to B) Audio-in Cable Landing Strip User ’s Guide xxxxxxxxx / xxxxxxxxx xxxxxxxxx USER’S GUIDE www.
Installation Product Overview • Front V iew • PT1545R Bottom V iew (Without Stand) • PT1545P Bottom View (W ithout Stand) 5 RS-232 VGA AC IN USB POWER SWITCH AUDIO AC IN USB POWER SWITCH VGA.
6 Start Y our Installation Please follow these instructions so that you can hookup the cables to associated connector . 1. Lay the display at on an even surface. 2. Move the stand into position as seen in the step 2 diagram. 3. Remove the cable cover as seen in the step 3 diagram.
Connecting the Display (Figure 8.1) T o setup this display , please refer to the following gure and procedures. 1. Be sure all equipment is turned off. 2. Connect the AC power cord to the power connector on the monitor and the other end into an electrical outlet (8.
(Figure 8.1) PT1545R PT1545P 8.
Kensington Security Slot The monitor can be secured to your desk or any other xed object with Kensington lock security products. The Kensington lock is not included.
VESA Mount Y our Monitor This monitor conforms to the VESA Flat Panel Mounting Physical Mounting Interface standard which denes a physical mounting interface for at panel monitors, and corresponding with the standards of at panel monitor mounting devices, such as wall and table arms.
Remove the Deskstand Remove 4 screws and then remove hinge. 11.
User Controls Side Panel Controls Power Icon Key Name Menu Up Down Enter OSD Key Menu off status Menu on status Menu appear Menu disappear/ return to main item Brightness Main item select up/ Adjust u.
13 How to Use the OSD Menus Icon Key Name Menu Up Down Enter Power 1. Press the “MENU” button to pop up the “on-screen menu” and press “Up” or “Down” button to select among the six functions in the main menu. 2. Choose the adjustment items by pressing the “Enter ” button.
On-Screen Display Menus Main OSD Menu: ITEM CONTENT Contrast The monitor luminance level control. Brightness The monitor backlight level control. Auto Adjust Fine-tune the image to full screen automatically . Left/Right Moving screen image horizontal position to left or right.
Appendix T roubleshooting If you are experiencing trouble with the display , refer to the following. If the problem persists, please contact your local dealer or our service center .
16 W arning Signal If you see warning messages on your screen, this means that the display cannot receive a clean signal from the computer graphics card. Below are the three kinds of W arning Signal. Please check the cable connections or contact your local dealer or Planar for more information.
Product Dimensions PT1545R 17 202.0 mm 222.5 mm 350.8 mm 306.5 mm 275.9 mm 196.1 mm 67.0 mm ► Side View ► T op View ► Front View.
PT1545P ► Side View ► T op View ► Front View 350.8 mm 306.5 mm 275.9 mm 196.1 mm 62.5 mm 222.5 mm 202.0 mm 18.
Compatibility Modes Mode Resolution H-Frequency (KHz) V -Frequency (Hz) IBM VGA 720 x 400 31.47 70 IBM VGA 640 x 480 31.47 60 VESA VGA 640 x 480 37.86 72 VESA VGA 640 x 480 37.50 75 VESA SVGA 800 x 600 35.16 56 VESA SVGA 800 x 600 37.88 60 VESA SVGA 800 x 600 48.
T ouch Screen Driver Installation The PT1545R is available with both RS232 and USB connections. The touch driver is located at www .planar .com/support for these operating systems: Windows® 7/8, VIST A, XP , 2000, ME, 98, NT 4.0, CE, XP Embedded, Linux kernel 2.
PT1545P Optional Calibration T ool Install: Calibrating the touch screen in Windows 7/8: 1. T ap the Start button, Control Panel and then Hardware and Sound. 2. Under T ablet PC Settings, tap Calibrate the screen for pen or touch input. 3. On the Display tab, under Display options, tap Calibrate and then Y es to allow the program to make changes.
22.
PT1545R Install Instructions: If you are using a PC running Windows® 7/8, VIST A, XP , 2000, ME, 98, NT4.0, follow the instructions below: 1. Power on the PC. 2. Be sure the USB or the RS-232 Serial cable is connected from the PC to the display . 3. Visit www .
When changing the T ouch Interface (RS-232 or USB), please follow instructions below . 1. Uninstall the touch driver . 2. Re-start the computer . 3. Remove the original T ouch Interface (RS-232 or USB). 4. Connect the computer to the T ouch Interface (RS-232 or USB) that you would like to use.
PT1545P Install Instructions: If you are using a PC running, Windows® 7/8, VIST A, XP , 2000, follow the instructions below: 1. Power on the PC. 2. Make sure that the USB cable is connected to the computer . 3. Visit www .planar .com/support. 4. Follow the step-by-step instructions as shown on the pop-up windows.
T echnical Support Cables and Accessories T o nd cables and accessories for your Planar monitor , touch screen or other Planar products visit our online store at www .
Planar Systems, Inc. Customer Service 24x7 Online T echnical Support: http://www .planar .com/ support 1 195 NW Compton Drive Beaverton, OR 97006-1992 T el: 1-866-PLANAR1 (866-752-6271) or +1 503-748-5799 outside the United States. Hours: 24 hours a day , 7 days a week © 2013 Planar Systems, Inc.
An important point after buying a device Planar PT1545R (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Planar PT1545R yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Planar PT1545R - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Planar PT1545R you will learn all the available features of the product, as well as information on its operation. The information that you get Planar PT1545R will certainly help you make a decision on the purchase.
If you already are a holder of Planar PT1545R, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Planar PT1545R.
However, one of the most important roles played by the user manual is to help in solving problems with Planar PT1545R. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Planar PT1545R along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
