Instruction/ maintenance manual of the product LC12 Planar
Go to page of 24
Title: Product Specification: LC12 High - Bright AMLCD Monitor Page 1 of 24 Document Number: 023 - 0284 - 01 Revision: A Product Specification - LC 12 High - Bright Monitor Document Number: 023 - 0284.
Title: Product Specification: LC12 High - Bright Monitor Page 2 of 24 Document Number : 023 - 0284 - 01 Revision: A Table of Contents 1.0 INTRODUCTION ....................................................................................................
Title: Product Specification: LC12 High - Bright Monitor Page 3 of 24 Document Number : 023 - 0284 - 01 Revision: A 8.4 System Transient Disturbance Requirements ................................................................... 20 8.5 Labeling .....
Title: Product Specification: LC12 High - Bright Monitor Page 4 of 24 Document Number : 023 - 0284 - 01 Revision: A 1.0 Introduction This document defines the electromechanical parameters and operating characteristics for a 12’1” Active Matrix Liquid Crystal Display (AMLCD) based product, hereafter referred to as the Monitor.
Title: Product Specification: LC12 High - Bright Monitor Page 5 of 24 Document Number : 023 - 0284 - 01 Revision: A 2.0 Basic Construction 2.1 Weight Monitor weight does not exceed 5 Kgs (11 lbs). 2.2 Mechanical Mounting Requirements Per Planar Mechanical Outline drawing 074 - 0666 - 01 2.
Title: Product Specification: LC12 High - Bright Monitor Page 6 of 24 Document Number : 023 - 0284 - 01 Revision: A 2.8 LCD Controller Board The LCD Controller Board incorporates components necessary to drive the LCD Panel (Section 6.7 ). Accepting VGA and VESA video standards (Section 1.
Title: Product Specification: LC12 High - Bright Monitor Page 7 of 24 Document Number : 023 - 0284 - 01 Revision: A 3.0 Environmental 3.1 Temperature and Humidity The Monitor withstands operating and storage environmental conditions liste d in Table 1.
Title: Product Specification: LC12 High - Bright Monitor Page 8 of 24 Document Number : 023 - 0284 - 01 Revision: A Power spectrum is referenced per MIL STD 810 E Environmental Test Method 505.3, Table - II Spectral Energy Distribution and permitted tolerances Maximum solar power flux = 1120 watts /m 2 at 65 degrees normal to the Monitor surface.
Title: Product Specification: LC12 High - Bright Monitor Page 9 of 24 Document Number : 023 - 0284 - 01 Revision: A 4.0 Video Signal Input Requirements 4.
Title: Product Specification: LC12 High - Bright Monitor Page 10 of 24 Document Number : 023 - 0284 - 01 Revision: A where 0 - mv is minimum luminance.
Title: Product Specification: LC12 High - Bright Monitor Page 11 of 24 Document Number : 023 - 0284 - 01 Revision: A Figure 6. TTL Allowable Signal Levels 4.2.2.1 Mode Detection The polarity of incoming horizontal/vertical frequencies and synchronization pulses define the video resolution being presented.
Title: Product Specification: LC12 High - Bright Monitor Page 12 of 24 Document Number : 023 - 0284 - 01 Revision: A physically connected to Signal Gr ound Reference (Pin 10) as defined by the wiring definitions of Table 2.
Title: Product Specification: LC12 High - Bright Monitor Page 13 of 24 Document Number : 023 - 0284 - 01 Revision: A 4.5 Video S ignal On - Off Sequences The sequence for bringing up and removal of each video input signal can be in any sequence or combination of input signals.
Title: Product Specification: LC12 High - Bright Monitor Page 14 of 24 Document Number : 023 - 0284 - 01 Revision: A VIDEO MODES IBM VGA VESA RESOLUTION 640 x 400 640 x 480 800 x 600 Video Clock 25.175 MHz 25.175 MHz 50.000 MHz Horizontal Scan Frequency 31.
Title: Product Specification: LC12 High - Bright Monitor Page 15 of 24 Document Number : 023 - 0284 - 01 Revision: A 5.0 DC Power Input Requirements 5.1 DC Power Input Lines The DC Power Input Connector consists of two (2) positions wired numerically and supplied attached to the Monitor as a chassis mounted connector per definitions listed in.
Title: Product Specification: LC12 High - Bright Monitor Page 16 of 24 Document Number : 023 - 0284 - 01 Revision: A 0-amp 5-amp 10-amp 15-amp 20-amp 25-amp Time Scale: 10-msec / div 3-amp (max) steady-state 11-amp (max) 25-msec (max) Stabilization 1-msec (max) Initial inrush current Power Supply Limit Figure 9.
Title: Product Specification: LC12 High - Bright Monitor Page 17 of 24 Document Number : 023 - 0284 - 01 Revision: A 6.2.1 Room Ambient Contrast Minimum Contrast of the display under r oom ambient lighting conditions of 1076 LUX [100 fC] direct incident illumination, is > 90:1.
Title: Product Specification: LC12 High - Bright Monitor Page 18 of 24 Document Number : 023 - 0284 - 01 Revision: A 7.0 Display Cosmetics All defects, pixel related and non - pixel related are observed at 46 cm [18”] viewing distance under room ambient light intensity 400 - 600 lux (fluorescent or incandescent lighting).
Title: Product Specification: LC12 High - Bright Monitor Page 19 of 24 Document Number : 023 - 0284 - 01 Revision: A Non - Pixel Defects Qty Allowed Size Se paration Defect Description 0 L > 0.120” W > .010” - 5 .020” < L < .120” .
Title: Product Specification: LC12 High - Bright Monitor Page 20 of 24 Document Number : 023 - 0284 - 01 Revision: A • Electromagnetic Immunity EN 50082 part 1 :1992 8.3 RFI Emission Certification The Monitor is certified to the following emissions standards when installed i n customer product configuration: • FCC, Part 15, Paragraph 15.
Title: Product Specification: LC12 High - Bright Monitor Page 21 of 24 Document Number : 023 - 0284 - 01 Revision: A 9.2 Critical Failures Critical failures is defined as fai lures that render the Monitor inoperable to the end user.
Title: Product Specification: LC12 High - Bright Monitor Page 22 of 24 Document Number : 023 - 0284 - 01 Revision: A claims of defects. If that remedy is adjudicated insufficient, Seller shall refund Buyer's paid price for the Goods and have no other liability to Buyer.
Title: Product Specification: LC12 High - Bright Monitor Page 23 of 24 Document Number : 023 - 0284 - 01 Revision: A CIE : Abbreviation for the Commission Internationale de l'Eclairage, formerly referred to as the International Commissio n on Illumination (ICI).
Title: Product Specification: LC12 High - Bright Monitor Page 24 of 24 Document Number : 023 - 0284 - 01 Revision: A SVGA - Super Video Graphics Adapter Sync : A contraction of synchronous or synchronization. Tristimulus Va lue : See Chromaticity Value and Color Data .
An important point after buying a device Planar LC12 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Planar LC12 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Planar LC12 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Planar LC12 you will learn all the available features of the product, as well as information on its operation. The information that you get Planar LC12 will certainly help you make a decision on the purchase.
If you already are a holder of Planar LC12, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Planar LC12.
However, one of the most important roles played by the user manual is to help in solving problems with Planar LC12. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Planar LC12 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
