Instruction/ maintenance manual of the product DVD-U04S Pioneer
Go to page of 17
English Français Deutsch.
2 <DRC1126> En This product complies with the EMC Directives (89/336/EEC, 92/31/EEC) and CE Marking Directive (93/68/EEC). Ce produit est conforme aux directives relatives à la compatibilité électromagnétique (89/336/CEE, 92/31/CEE) et à la directive CE relative aux marquages (93/68/CEE).
<DRC1126> En 3 SAFETY INSTRUCTIONS T o ensure your personal safety and to maximize the full operating potential of your Drive, read and follow these safety precautions: ENVIRONMENT - Please do not use the unit at places with much dust, high temperature, or high humidity .
4 <DRC1126> En SAFETY INSTRUCTIONS RADIO SIGNAL INTERFERENCE - This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
<DRC1126> En 5 SAFETY INSTRUCTIONS The enclosed device driver is for use with MS-DOS/Windows 3.XX. This driver is not required for use with Windows 95 or Windows 98. * MS-DOS and Windows are trademarks of Microsoft Corporation. DO NOT use non-standard discs, as these may adversely influence this unit and other equipment.
6 <DRC1126> En FEA TURES ÷ High-speed reading T ransfer rate (sustained): maximum 13,500 kBytes/sec. (DVD-ROM) maximum 6,000 kBytes/sec. (CD-ROM) NOTE: The data transfer rate may not be output due to disc conditions (scratches, etc.
<DRC1126> En 7 A HARDW ARE TOUR Fig. 1 Illustrations are provided in this chapter as a visual introduction of the Drive. Please familiarize yourself with these illustrations and refer to them when necessary to complete the installation and operation of the unit.
8 <DRC1126> En 6 Audio output This is a connector for output of analog audio. As a Molex 70553 type connecter is used, select a matching connection cable. 7 Function switch Use the accessory short-circuit sockets to set the SCSI ID number and the drive function.
<DRC1126> En 9 TO INST ALL THE DRIVE ÷ T urn off the power of the personal computer and remove the cover or the front panel. ÷ Remove the blank panel installed at the front of the 5.25 inch slot. Installation is not possible when there is no empty slot.
10 <DRC1126> En Fig. 4 CONNECTING THE DRIVE IN THE MIDDLE OF A SCSI CHAIN When a SCSI hard disk or other SCSI equipment is installed in the computer , please connect according to the following method. ¶ T urn off the power supply of the personal computer .
<DRC1126> En 11 CONNECTING THE DRIVE AS THE ONL Y SCSI DEVICE W ARNING The power supply of the personal computer must be turned off before cables are connected. Fig. 5 When no SCSI hard disk or other SCSI equipment is used, connect according to the following connection method.
12 <DRC1126> En DISC OPERA TION DISC SETTING METHOD ¶ Insert the disc into the disc loading slot with the label facing up. ¶ When using 8 cm/3.15-inch discs, attach a CD adapter (available at stores) to the disc, and insert the disc into the disc loading slot.
<DRC1126> En 13 Do not place anything within 12 cm (4.72 in.) in front of the unit as this may obstruct the disc ejection operation of the unit. DISC OPERA TION DISC REMOV AL METHOD ¶ Confirm that the BUSY indicator of the drive is not lit, and then press the Eject button ( 0 ).
14 <DRC1126> En TROUBLESHOOTING Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this unit, check the points below according to the symptom.
<DRC1126> En 15 SPECIFICA TIONS [General functions] Disc diameter 12 cm ( 4.72 in ), 8 cm (3.15 in )* * When using 8 cm discs, attach a CD adapter (available at stores) to the disc. T ransfer rate (Sustained) DVD-ROM maximum 13,500 kBytes/sec.* CD-ROM maximum 6,000 kBytes/sec.
16 <DRC1126> En ABOUT REGION CODES Region codes are part of the DVD standard. There is a Region number located within one or all of the components required for DVD-VIDEO playback. The Region number defines the region of the DVD-ROM drive and its playback hardware/software.
80 <DRC1126> Ja AFTER-SALES SERVICE FOR PIONEER PRODUCTS Please contact the dealer or distributor from where you purchased the product for its after-sales service (including warranty conditions) or any other information.
An important point after buying a device Pioneer DVD-U04S (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Pioneer DVD-U04S yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Pioneer DVD-U04S - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Pioneer DVD-U04S you will learn all the available features of the product, as well as information on its operation. The information that you get Pioneer DVD-U04S will certainly help you make a decision on the purchase.
If you already are a holder of Pioneer DVD-U04S, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Pioneer DVD-U04S.
However, one of the most important roles played by the user manual is to help in solving problems with Pioneer DVD-U04S. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Pioneer DVD-U04S along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
