Instruction/ maintenance manual of the product A-30 PGS
Go to page of 27
R Grills by AEI Corporation Gas Grills Models A-30 and A-40 ASSEMBL Y , OPERA TING & MAINTENANCE INSTRUCTIONS 1 PGS BY AEI CORPORATION 2641 DU BRIDGE AVE.
CONGRATULATIONS! You have purchased a tr uly exceptional outdoor cooking appliance with your PGS grill from AEI Corporation. Your outdoor gas grill has been designed and constructed to give you many years of outdoor cooking enjoyment.
TABLE OF CONTENTS Safety Responsibilities, Warning Symbol ................................................................................................ Page 4 Grill Model Identification (Location of Serial Number) ..................................
SPECIAL ATTENTION: THIS SYMBOL NOTES SAFETY RELATED ITEMS OR PRODUCT WARNINGS 4 IT IS YOUR RESPONSIBILITY TO: ASSEMBLE, INSTALL, LEAK CHECK, CARE AND OPERATE YOUR GAS GRILL. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. FOR YOUR SAFETY IF YOU SMELL GAS: 1.
VERY IMPORTANT SAFETY TIPS AND WARNINGS PGS IS MOST CONCERNED ABOUT THE SAFE USE OF OUR PRODUCT. THE FOLLOWING TWO PAGES ARE A SUMMARIZATION OF THE SAFETY TIPS FOUND THROUGHOUT THIS MANUAL. PLEASE TAKE THE TIME TO REVIEW THEM, AS THEY ARE CRITICAL IN THE ENJOYABLE USE OF YO UR GRILL.
6 IF A PROFESSIONAL INSTALLER OR DEALER INSTALLS THE GRILL, BE SURE THAT HE SHOWS YOU WHERE YOUR GAS SUPPLY SHUT OFF IS LOCATED. ALL GAS LIN ES MUST HAVE A SHUT OFF T HAT IS READILY AND EASILY ACCESSIBLE. IF YOU SMELL GAS, CHECK FOR GAS LEAKS IMMEDIATELY.
regulations. In the absence of local codes, installation must conform to the National Fuel Gas Code, ANSI Z21.58a-1999*CGA 1.62-M99. 7 NEVER USE NATURAL GAS IN A UNIT DESIGNED FOR LIQUID PROPANE OR THE REVERSE. IF YOU WISH TO CONVERT YOUR GRILL FROM ONE TYPE OF GAS TO THE OTHER, PLEASE CONTACT YOUR LOCAL DEALER OR DISTRIBUTOR .
LP Gas is stored under high pressure and must be handled with care. Do not handle a tank roughly. Be sure your LP gas dealer checks the cylinder with a soapy solution for leaks after filling. Do not turn gas valve on unless connection between regulator and coupler is complete.
9 GRILL MOUNT : Supports gas grill head, can be a post and base mount, a permanent post mounts pedestal mount (stationary or mobile) or built in frame inserted in a masonry enclosure. COLUMN; Pedestal that support grill head when used with a base kit.
10.
PLEASE NOTE: ALL PARTS MAY NOT COME WITH ALL MOUNTING OPTIONS PART NUMBERS AND DESCRIPTIONS REF# DESCRIPTION QT Y MODEL A40 MODEL A30 1 UPPER GRILL CASTING 1 140010 130010 2 LOWER GRILL CASTING 1 1400.
Keep in mind that the gas line access hole is on the back of the post and the notch at the top if facing front. Recheck plumb and allow cement to set. 2. Run the gas supply line into the post access hole (just above the cement). Make a 90° bend to reach the access door opening.
Step 1: Connect the Tank Locking Bar (Fig. 10) 1. From box Column Box locate and attach the Tank Lock Bar across the back of the pedestal column. Use the ¾" S.S. Hex bolt, Nylon Lock Bar Spacer and a Kep nut on each side to fasten the Tank Lock Bar in place.
14 Stainless Steel Column (A-S PED) Step 3: Connect the Grill Head Bottom to Aluminum Column (A-B PED) (Fig. 13A) 1. Attach the grill head bottom to the pedestal column top with four ¼ - 20 x1 ½" Hex bolts, washers under the bolt head, reinforcing bar and Kep nuts.
15 Grill Head Assembly Instructions Step 1: Control Panel & Heat Shield A. Attaching the Heat Shield and Control Panel Assembly (Fig. 19) 1. Attach the complete control panel assembly to the front of the grill head with 1/4—20 Kep nuts. 2. Leave the (2) nuts holding the heat shield on, to serve as spacer nuts.
Connect the 30" flexible tube to the incoming gas supply using a 3/8" flare coupling (not suppli ed). Attach the other end to the grill valve connection behind the control panel. To tighten securely use two wrenches. Hold valve joint with one wrench and tighten the hose fitting with second wrench.
around. It is a sturdy handle properly hinged securely into place (see Fig. 31). 17 Figure 31 FINISH ASSEMBLY 1. Be sure to remove all plastic protective film. Place rock grate in the bottom of the casting. 2. Place ceramic "Moon Rok II" on rock grate by evenly placing side by side.
may be necessary to turn the grill or to light the burner via a vent opening under the grill head. DO NOT TOSS A LIT MATCH INTO THE 18 UNIT AND THE GRILL STILL FAILS TO LIGHT, CHECK THE E TURN THE GAS ON! IF GAS SUPPLY. YOU COULD BE OUT OF LP GAS OR THE MAIN GAS SUPPLY FOR NATURAL GAS MAY HAVE BEEN TURNED OFF.
In many areas, spiders or small insects have been found to create "flashback" problems. The spiders spin webs and/or insects build nests in the grill's venturi tube(s). The web and/ or nests can lead to gas flow obstruction, which c an damage your grill as it results in a "flashback" (a fi re in the venturi tube(s).
cooking temperatures are t oo high. To control flare- ups: 1. Turn your control knob to a lower heat setting. 2. Move the meat to another part of the grill, if possible. With a dual burner, you can cook on one side and move food, as necessary to the unlighted side or lower heat setting.
21 NORMAL HARD FLAMES YELLOW FLAMES Extremely out of adjustment burner Slightly out of adjustment burner HELPFUL TIPS 1. Before using your grill for the first time, please l and turn both burners on HI heat for ten to fifteen minutes. This will burn off any oils that are on new surfaces.
PGS TROUBLESHOOTING GUIDE No Flame Gas Shut off Obstruction in Orifice(s) Leak in Gas Train No Gas in Tank or Not Connected to Gas Source Low Flame Leak in Gas Train Obstruction in Orifice(s) or venturi’s Natural Gas valve only turned part way Burner gasket plugging venturis.
PROPER TUBE BENDING BEEF COOKING GUIDE (Grill Preheated 5-10 M inutes) Cooking Time Amount of Heat for Medium Cooking Tips Item Meat Setting Doneness and Methods Hamburgers 1/2 lb. Medium 8-10 minutes Grill with hood clos ed, turn once T-bone or 1 to 1.
24 PACIFIC GAS SPECIALTIES COOKING TIPS AND TEMPATURE GUIDE Cooking outdoors has truly come of age in America. What was once a frustrating experience, pitting th e weekend chef against a raging charcoal inferno has evolved into an enjoyable culinary experience.
25 When rotissing you may want to put an aluminum tray or drip pan under the cut of meat to ca pture the excessive fats and -up. Again, flare-up is desirable urce, ute to influe ncing heat output and control.
26 3 Warranty N FOR AN Y PURPOSE OTHER THAN INTERNAL REGISTRATION OR ULLETINS REGARDING PRODUCT IMPROVEMENTS. Warranty information below applies to resi dential use. Commercial, common areas r apartment use carry no warranty PLEASE NOTE: ENCLOSED WARRANTY REGISTRATION CARD MUST BE RETURNED TO PGS FOR WARRANTY TO BE IN PLACE.
27 R Proudly Manufactured b y PGS BY AEI CORPORATION 2641 DU BRIDGE AVE. IRVINE, CA. 92606-5001 (949) 474-3070 FAX 949 474-0559 E MAIL aeicorp@sbcglobal.
An important point after buying a device PGS A-30 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought PGS A-30 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data PGS A-30 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, PGS A-30 you will learn all the available features of the product, as well as information on its operation. The information that you get PGS A-30 will certainly help you make a decision on the purchase.
If you already are a holder of PGS A-30, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime PGS A-30.
However, one of the most important roles played by the user manual is to help in solving problems with PGS A-30. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device PGS A-30 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
