Instruction/ maintenance manual of the product S8M600 Pentair
Go to page of 12
SYSTEM 3 ® MODULAR MEDIA FIL TER O W N E R’ S M A N U A L INST ALLA TION, OPERA TION & P AR TS MODEL S8M600 Furnish this manual to the end user of this filter; its use will reduce ser- vice calls and chance of injury and will lengthen filter life.
2 SYSTEM 3 ® MODULAR MEDIA FIL TERS: To avoid unneeded service calls, prevent possible in- juries, and get the most out of your filter, READ THIS MANUAL CAREFULLY! The Sta-Rite System 3 ® Modular Media Filter: •Is designed to filter water for swimming pools, spas and hot tubs.
3 GENERAL INFORMA TION Hazardous pressure. Can cause severe injury or major property damage from tank blow up. Release all pressure and read instructions before work- ing on filter. Clean a new pool as well as possible before filling pool and operating filter.
4 Keep piping tight and free of leaks: pump suction line leaks may cause trapped air in filter tank or loss of prime at pump; pump discharge line leaks may show up as dampness or jets of water. Either plug drain fitting with a 2" NPT pipe plug or run piping from drain fitting to an acceptable waste water disposal point.
5 INITIAL ST AR T -UP Turn pump OFF before starting procedure. Properly seat filter clamps and securely tighten clamp knobs before proceeding. Read “Warning Instructions For Clamp Assembly” decal on tank. Water pressure in filter must not exceed 50 PSI (345 kPa) under any circumstances.
FIL TER CLEANING PROCEDURE NOTICE: When sanitizing your pool using PHMB (poly- hexamethylene biquanide based) cleaners, use only PHMB cleaners to clean the module. When using PHMB sanitizers, the filter module MUST be cleaned more thoroughly and frequently than for a pool using chlorine.
7 1. Clean filter elements first according to cleaning procedure above. 2. Use one of the commercial filter cleaners listed (see Table III) Risk of fire or explosion. Isolate filter from system before chemical cleaning; rinse filter and ele- ments completely before returning to service.
8 TROUBLESHOOTING GUIDE A. Short Cycle: Time between cleanings will vary with each installa- tion and between different areas of the country. The following causes and remedies are for cycle times shorter than normal for your area. NOTICE: Some pool disinfectants may clog filter media.
9.
Model No. Key S8M600 No. Part Description Qty. 600 Ft 2 Filters 1 2 Inch Gauge 1 33600-0023T 2 Air Release Valve 1 WC212-120P 3 Close Nipple 1/4 In. 1 35202-0959 4 Adapter Bushing 1 24900-0504 5 O-Rin.
11 Blank Page.
S293S (Rev. A).
An important point after buying a device Pentair S8M600 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Pentair S8M600 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Pentair S8M600 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Pentair S8M600 you will learn all the available features of the product, as well as information on its operation. The information that you get Pentair S8M600 will certainly help you make a decision on the purchase.
If you already are a holder of Pentair S8M600, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Pentair S8M600.
However, one of the most important roles played by the user manual is to help in solving problems with Pentair S8M600. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Pentair S8M600 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
