Instruction/ maintenance manual of the product MiniMax NT Heater Pentair
Go to page of 12
Rev. B 1-20-04 1 P/N 472299 MiniMax ® NT Heater Digital Display T emperature Controller (DDTC) Installation Instructions Important Notice Attention Installer. This manual contains important information about the installation, operation and safe use of this product.
P/N 472299 2 Rev. B 1-20-04 SECTION I. INST ALLA TION 1. Turn off the electrical power to the heater. 2. Open the heater’s right door. 3. Disconnect all wires from the 6800 Temperature Controller. 4. Remove the left and right doors from the heater if necessary.
Rev. B 1-20-04 3 P/N 472299 Apply silicone between the gask et and front-mounting frame. Apply silicone between the gask et and rear-mounting frame. Secure DDTC cov er and rain shield by using six scre ws.
P/N 472299 4 Rev. B 1-20-04 GRN IGN MODULE IGNITOR HOT SURFACE BURNER GND VAL TH IGN L2 L1 IGN/240 MiniMax NT LN Dual Voltage W/DDTC Wiring Diagram ORG WHT GRN ORG RED THERMAL FUSE WHT BLU RED SWITCH WATER PRESSURE GAS VALVE RED WHT BLU RED HIGH LIMIT 115˚F 1 2 3 4 5 3 2 1 GRN AIR PRESS.
Rev. B 1-20-04 5 P/N 472299 GRN IGN MODULE IGNITOR HOT SURFACE BURNER GND VAL TH IGN L2 L1 IGN/240 MiniMax NT STD Dual Voltage W/DDTC Wiring Diagram ORG WHT GRN ORG RED THERMAL FUSE WHT BLU RED SWITCH WATER PRESSURE GAS VALVE RED WHT BLU RED HIGH LIMIT 115˚F 1 2 3 4 5 3 2 1 GRN AIR PRESS.
P/N 472299 6 Rev. B 1-20-04 Figure 6. J1 DDTC WATER PRESSURE SWITCH MiniMax NT TSI w/DDTC WIRING DIAGRAM GY AIR PRESSURE SW. O BLOWER O J5 J6 J8 G COM NO R/W R BK/W BK O REMOTE CONTROL MANUAL FOR &.
Rev. B 1-20-04 7 P/N 472299 SECTION III. INTRODUCTION OF DDTC The DDTC board, shown in Figure 7, is a digital temperature controller capable of controlling the pool, spa or both to a minimum temperature of 65° F. (below 65° F. display reads "Off") and a maximum of 104° F.
P/N 472299 8 Rev. B 1-20-04 SECTION IV . SET UP The MiniMax NT Heater comes from the factory preset with a pool temperature setting of 78° F. and a preset spa temperature of 100° F.
Rev. B 1-20-04 9 P/N 472299 • THERMOST A T This light is on when the thermostat contacts close, signaled by the water temperature falling below the set-point, calling for the heater to fire to maintain the desired water temperature.
P/N 472299 10 Rev. B 1-20-04 NOTE: With this type of two-wire remote, with its own temperature sensors and system control, using the up arrows on the front of the DDTC, hold down the up arrow until you reach the maximum setting of 104° F., this allows the remote system thermostat to operate the heater at any set-point below 104° F.
Rev. B 1-20-04 11 P/N 472299 Figure 8..
P/N 472299 12 Rev. B 1-20-04 Pentair Pool Products 1620 Hawkins Ave., Sanford, NC 27330 • (919) 774-4151 10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 523-2400 SECTION X. MINIMAX NT HEA TER DDTC RETROFIT KIT PAR TS SAVE THESE INSTRUCTIONS.
An important point after buying a device Pentair MiniMax NT Heater (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Pentair MiniMax NT Heater yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Pentair MiniMax NT Heater - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Pentair MiniMax NT Heater you will learn all the available features of the product, as well as information on its operation. The information that you get Pentair MiniMax NT Heater will certainly help you make a decision on the purchase.
If you already are a holder of Pentair MiniMax NT Heater, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Pentair MiniMax NT Heater.
However, one of the most important roles played by the user manual is to help in solving problems with Pentair MiniMax NT Heater. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Pentair MiniMax NT Heater along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
