Instruction/ maintenance manual of the product 80WX0101 Pella
Go to page of 8
Part Number: 80WX0101 ©2012 Pella Corporation WINDOW REPLA CEMENT INS TRUCTIONS FOR CASEMENT , DOUBLE-HUNG AND CLAD FRAME WINDOWS INT O EXISTING DOUBLE-HUNG FRAME USING FRAME SCREWS EXTERIOR Flashing T ape Sill Adapter Always read the P ella® Limited W arranty befor e purchasing or installing P ella products.
1 REMOVE THE EXISTING SASH Note: Remove the new window from its packaging. Inspect and measure the new window to ensure it will fit into the opening prior to removing the existing window . T he window needs to be 3/4" smaller in both width and height than the pocket frame.
2 OPENING PREP ARA TION A. Inspect the existing window fr ame and repair or r eplace any defective or rotted wood par ts. B. Clean the opening ofanydirt,debris, orexcessold paint before pr oceeding. C. Apply one piece of sill flashing tape to the sill of theexistingwindow .
EXTERIOR 4D 4C A. If the existing double-hung has a sloped sill the sill of the new window will need to be supported by using the P ella replacement sill adapter accessory or by using wood blocking as needed.
5 INTERIOR SEAL CAUTION: Ensur e use of low pressure polyurethane window and door insulating foams and strictly follow the foam manufacturer’ s recommendations for application. Use of high pressure foams or impr oper application of the foam may cause the window frame to bow and hinder operation.
Theexteriorfr ameandsasharepr otectedbyaluminumcladdingwithourtoughEnduraClad ® or EnduraClad Plus baked-on factory finish tha t requir es no painting. Cle an this surface with mild soap and water . Stubborn stains and deposits may be r emoved with mineral spirits.
INST A LL ING ROT O CO VER AND C R ANK Note: Finish the interior of the window and allow the window to dry before proceeding with these instructions. (T o open the window for finishing, partially insert the lock handle into the jamb, unlock the unit, temporarily at tach the crank handle and turn to open.
LOCK LEVER R EMO V AL AND IN SERTION Note: Y ou may want to remove the lock lever prior to finishing the window , or if it needs to be replaced with a lock lever in a differ ent finish. Interior B Exterior C Interior F Exterior D E A. Unlock and open the window .
An important point after buying a device Pella 80WX0101 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Pella 80WX0101 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Pella 80WX0101 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Pella 80WX0101 you will learn all the available features of the product, as well as information on its operation. The information that you get Pella 80WX0101 will certainly help you make a decision on the purchase.
If you already are a holder of Pella 80WX0101, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Pella 80WX0101.
However, one of the most important roles played by the user manual is to help in solving problems with Pella 80WX0101. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Pella 80WX0101 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
