Instruction/ maintenance manual of the product BB5L Pelco
Go to page of 20
Pelco • 300 W. Pontiac Way, Clovis • CA 93612-5699 USA • Pelco Online @ http://www.pelco.com In North America and Canada: Tel (800) 289-9100 or FAX (800) 289-9150 • DataFAX (800) 289-9108 Inte.
2 Pelco Manual C1488M-A (9/98) REVISION HISTOR Y Manual # Date Comments C1488M 6/98 Original version. C1488M-A 9/98 Rev A. Re vised the manual to incorporate Spectra™ Lite material. CONTENTS Section Page 1.0 GENERAL .................................
Pelco Manual C1488M-A (9/98) 3 1.0 GENERAL 1.1 IMPORT ANT SAFEGUARDS AND W ARNINGS Prior to installation and use of this product, the following W ARNINGS should be obser v ed. 1. Installation and servicing should only be done by qualified ser vice personnel and conform to all local codes.
4 Pelco Manual C1488M-A (9/98) 1.2 REGULA TOR Y NOTICES NOTE: This equipment has been tested and found to comply with the limits of a Class B digital de vice, pursuant to par t 15 of the FCC rules. These limits are de- signed to provide reasonab le protection against harmful interference in a residen- tial installation.
Pelco Manual C1488M-A (9/98) 5 Figure 1. Back Bo x P arts COMPASS TOOL SAFETY BRACKET CONDUIT FITTING & LOCK NUT T -RAIL CLIP 1.3 UNP ACKING INSTRUCTIONS Unpack and inspect all parts carefully . Be sure to sav e the shipping box and an y inser ts.
6 Pelco Manual C1488M-A (9/98) 2.0 DESCRIPTION The BB5A Series back bo xes are used with the SD5 Series of Spectra™ (Softw are V ersion 3.0) domes and SD5A Series of Spectra II™ domes. The BB5L Series back bo xes are used with the SD5L Series of Spectra™ Lite domes.
Pelco Manual C1488M-A (9/98) 7 3.0 INST ALLA TION FOR IN-CEILING MODELS This manual cov ers the installation of the BB5A-F , BB5A-PB , BB5A-PG, BB5A-PG-E, BB5L-F , BB5L-PG, and BB5L-PG-E back bo x es only . For complete installation and operating instructions f or the SD5 Series of Spectra™ (Software V ersion 3.
8 Pelco Manual C1488M-A (9/98) 3.1.2 Suspended Ceiling 1. Remov e the ceiling tile from the ceiling. 2. Locate the center point to drill a hole in the tile. 3. Drill a hole in the ceiling tile using a 3/32-inch drill bit. 4. Remov e the compass tool from the par ts bag (refer to Figure 2).
Pelco Manual C1488M-A (9/98) 9 Figure 4. Installing Back Bo x Figure 5. F astening Bac k Bo x HARD CEILING OR CEILING TILE T -RAIL CLIP FOR CEILING TILE HARD CEILING OR CEILING TILE T -RAIL CLIP FOR C.
10 Pelco Manual C1488M-A (9/98) Figure 6. Wiring Diagram f or Spectra™ (V er . 3.0) and Spectra II™ CONTROL (RS-422) 7 +5 to +24 VDC EXTERNAL RELA Y (WIRING EXAMPLE) CONTROL (RS-422) Figure 7.
Pelco Manual C1488M-A (9/98) 11 T able B. 24 V AC Wir ing Distances The follo wing are the recommended maximum distances f or 24 V AC with a 10- percent voltage drop . (T en percent is generally the maximum allo wable voltage drop for A C-po wered devices .
12 Pelco Manual C1488M-A (9/98) 3.3 BACK BOX INST ALLA TION 1. Suspended Ceiling Only (f or hard ceiling, go to step 2) – Install the ceiling tile with the bac k box. Attach a T -rail clip on each side of the ceiling tile as shown in Figure 5. The clips for the ceiling tile are supplied with the bac k bo x.
Pelco Manual C1488M-A (9/98) 13 3.4 BACK BOX CONNECTIONS Depending on the type of dome, ref er to either Figure 10 or 11 to attach the wiring to the interconnect circuit board inside the back bo x. Also refer to Figure 6 or 7 if necessary . 1. Earth Ground - Connect ear th ground to the middle connector on the po wer connector .
14 Pelco Manual C1488M-A (9/98) From contr oller T o 4-Wire terminal on circuit board RX- TX- RX+ TX+ TX- RX- TX+ RX+ NOTE: Connect only a low v olt- age de vice to the rela y output. Maximum current r ating of the re- la y contacts is two amperes. CAUTION: The maxi- mum output of A UX 2 is 150 mA.
Pelco Manual C1488M-A (9/98) 15 NOTE: If outdoors, apply Duct Seal inside the pipe por tion of the back bo x to pre vent moisture or cold air inside the mount from en- ter ing the unit and causing conden- sation on the dome. Duct Seal can be purchased through local elec- tr ical supply houses.
16 Pelco Manual C1488M-A (9/98) 5.0 TROUBLESHOOTING Symptom: LED does not light. If the red pow er LED on the door of the interconnect circuit board in the back bo x does not light: 1. T urn off power . 2. Open the door to the interconnect circuit board and check the fuse .
Pelco Manual C1488M-A (9/98) 17 6.0 SPECIFICA TIONS MECHANICAL Construction Back box: Aluminum Cable Entry In-Ceiling: .75" (1.91 cm) conduit fitting Pendant: Through 1.
18 Pelco Manual C1488M-A (9/98) Figure 12. SD5 Series Dimension Drawing 6.60 (16.76) 5.25 (13.34) 3.25 (8.26) 7.25 (18.13) 8.25 (20.96) 5.90 (14.99) In-Ceiling Dome Pendant Dome NO TE: V ALUES IN P ARENTHESES ARE CENTIMETERS , ALL OTHERS ARE INCHES . 5.
Pelco Manual C1488M-A (9/98) 19 NOTES.
20 Pelco Manual C1488M-A (9/98) 7.0 W ARRANTY AND RETURN INFORMA TION WARRANTY P elco will repair or replace, without charge , any merchandise prov ed def ective in material or workmanship for a period of one year after the date of shipment.
An important point after buying a device Pelco BB5L (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Pelco BB5L yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Pelco BB5L - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Pelco BB5L you will learn all the available features of the product, as well as information on its operation. The information that you get Pelco BB5L will certainly help you make a decision on the purchase.
If you already are a holder of Pelco BB5L, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Pelco BB5L.
However, one of the most important roles played by the user manual is to help in solving problems with Pelco BB5L. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Pelco BB5L along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
